Public Works Department Tender

Steel work in built up tubular (round, square or rectangular hollow tubes etc) trusses etc., including cutting , hoisting , fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete.Hot finished welded type tubes.

Steel work welded in built up sections/framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required. In gratings, frames, guard bar, ladder, railings, brackets, gates and similar works.

12mm Cement plaster of mix 1 : 4 (1 cement : 4 fine sand).

Providing and applying Plaster of Paris putty of 2mm thickness over plastered surface to prepare the surface even and smooth complete.

Finishing walls with acrylic smooth exterior paint of required shade on New work (Two or more coats applied @ 1.67 liter/10sqm over and including priming coat of exterior primer applied @ 2.20kg/10sqm).

Centering and shuttering including strutting, propping etc. and removal of form work for Foundations, footings, bases of columns etc. for mass concrete.

Painting with synthetic enamel paint of approved brand and manufacture to give an even shade. Two or more coats on new work.

Description for outdoor tip up HDPE Chair : High Density Polyethylene Blow moulded (HDPE) plastic Outdoor seat made out of blow moulded process with double layer construction and average wall thickness of each layer shall be in not less than 3mm, the tip up of the Shell by Spring. The chair size be 21 inch etc. (tolerance +/- half inch). BACK : 33” Back height from floor level, manufacture through a blow moulded high impact HDPE blow process and UV RESISTED additives for ray’s protection and anti-rust anatomic shaped with radius edges. SEAT : The seat has Spring Back tip up systems that allows the perfect seat alignment and make it completely silent. Manufacture through a blow moulded high impact HDPE blow process and UV RESISTED additives for ray’s protection and anti-rust anatomic shaped with radius edges. STANDS : Stand will be made by Aluminium Die casting Stand with Silver powder coated finish. Stand should has the provision of fitting with 2 anchor fasteners. The outer expose metal parts shall be duly powder coated with 50-60 micron. NUMBERING : Non corrosive numbering to be provided for traceability. INSTALLATION : The chair is to be fitted with 2 Nos. of anchor fasteners per stand of size M-10 x 70mm with Araldite. Warranty Period. 2 year warranty against any manufacturing defects; not against any public vandalism or act of GOD.

Carriage of material by Mechanical Transport including loading / unloading and stacking at site complete.

Stone agg. / Sand for an avg. lead of 10 Kms.

Disposal of excavated earth / mulba for an average lead of 5 Kms.