Public Works Department Tender

4 x 10 sq. mm + 2 x 6 sq. mm earth wire

4 x 16 sq. mm + 2 x 6 sq. mm earth wire

SITC of wall/free standing floor mounted dust and vermin proof compartmentalized cubical panel for electrical Works, made out of CRCA sheet. Other parameters required as per point (a) Thickness of sheet shall not be less than 1.6 mm up to 600 mm length/width of any compartment and be of 2.0 mm above 600 mm. Load bearing structure shall be of 2.0 mm thick sheet supported by base M.S. channel if required. Side walls and cable alley compartment shaving bolted type doors with/without detachable extension type structure (b) Panel shall be duly treated for derusting in 7 tank process with de phosphating and with powder coating of minimum 70 microns on both side of panel in desired shade The panel having PU/Neoprene rubber gasket of not less than 3mm thickness, required hardware, separate detachable gland plate M.S. base channel (min 75mm), hinged door with locking arrangement for equipment/switchgear c) Interconnection between bus bar and switch gears/cable shall be rigidly supported and made out by flexible copper wires (upto 125 amp) and by solid bus bar ( 125). (d) Only outer area on all sides shall be measured & panel to be fabricated only from CPRI approved fabricator CPRI Test certificates to be submitted) All as per pre approved by Engineer in charge.

Providing and fixing following rating and breaking capacity and pole MCCB with thermomagnetic release and terminal spreaders in existing cubicle panel board including drilling holes in cubicle panel, making connections, etc. as required. (Thermal Magnetic type, Adjustable type)

63 Amp, 25 KA, FP MCCB ICU = 100% ICS

100 Amp, 30 KA, FP MCCB ICU = 100% ICS

250 Amp, 36KA, FPMCCB ICU = 100% ICS

Electrical Rubber Mat having thickness 6mm and width 1 Mtr

Aluminium Bus Bar 200 Amp set of 4 strips

Aluminium Bus Bar 300 Amp set of 4 strips

Aluminium Bus Bar 400 Amp set of 4 strips

Aluminium Bus Bar 500 Amp set of 4 strips

Digital Metering devices, comprising of Voltmeter, Ammeter, Selector Switch, Indicating Lamp, CT Set etc.

Supplying and fixing of following rating 240/415 volts "C" curve, miniature circuit breaker suitable for inductive load of following poles in the existing MCB DB complete with connections, testing and commissioning etc. as required.

Single pole upto 32 amp.

Single pole 40 amp.

SPN 40 Amp

SPN 63 Amp

TPN 40 Amp

TPN 63 Amp

Dismantling of Existing old Pannel including cabling and other allied works and then carriage of same material to Department store/safer place and Laying of Cable For New Pannel Complete Job