Public Health Engineering Department Tender

Development of Tube Well in accordance with IS:2800 (Part-I) and IS: 11189 to establish maximum rate of usable water yield without sand content (beyond permissible limit) with required capacity air compressor for required time till the Tube Well is fully developed measuring yield of well by “V” Notch method or any other approved method, measuring static water level & draw down etc. By step draw down method, collecting water sample and testing from approved laboratory including disinfection of Tube Well . Complete including required hire and labour charges of air compressor, tools and accessories etc.

Providing, installation, testing and commissioning of electro-mechanical Components for installation of submersible pump set along with other allied works i.e Providing/fitting of G.I. Pipe 65 mm dia (Medium Class) 80.00 M to 100.00 M as per requirement. Cutting of G.I/ pipes of 6.00 M length in 03.00 M length each. Then providing and fabrication of M.S. Flanges and welding the same on both sides of G.I. Pipes in proper alignment. Complete job including cost of G.I. Pipe, MS Flanges and other miscellaneous items and cost of carriage/transportation of material from workshop to the site of work. Providing, fitting, installation, testing and commissioning of Submersible pump set of parameters at a head of 130 M to 150 M of reputed make conforming to IS Code: 8034. The job includes carriage of material to the site of work and lowering of submersible pump set in to the bore hole by way of coupling of flanged G.I. Riser Pipes with fixtures such as nuts, bolts & washers to a depth 80.00 M to 100.00 M as per requirement and making of electrical connections with starter panel. Fabrication of well cap, tie rod along with G.I. bend, elbow for delivery of water. Providing, fitting and installation of three phase submersible starter controller capable of protection of current related faults and voltage related faults in sheet enclosure type of reputed make including fabrication of steel enclosure outdoor electrical cabinets with canopy for motor starter. Providing and laying of 06.00 sq. mm 3 Core submersible cable 120.00 M to 140.00 M & also providing and fitting of 3.5 -Core PVC insulated armored aluminum cable 25.00 sq. mm- 40.00 M to 60.00 M (Approx. as per site requirement) as service line required from LT Pole to starter panel of reputed make. Making of electrical connections with the starter panel , service line and submersible pump set after properly thimbling and testing and commissioning thereof. The job includes loading, unloading, shifting by Mechanical transport, labour and material charges.Complete Job.