Public Health Engineering Department Tender

Design, fabrication, carriage, installation, testing and commissioning of 70 ampere LT control panel alongwith allied works at pumping station Pinger (old) stage-1st by way of fabrication of starter with Main,delta and star power contactors 01 no. each with main and delta of 70 ampere rating and star of 50 ampere rating and compatible with the rating of the prime mover, of reputed make ,conforming to ISI standards. The system should be provided with solid state fault analyzer cum controller unit or equivalent of standard and reputed make. The complete system should be enclosed in MS steel enclosure box of suitable dimensions. The enclosure should be finished with powder coated painting from inside as well as from outer surface of approved colour. Providing / laying of copper conductors of proper rating alongwith insulation material as per site requirement. The enclosure should be front shutter mounted with key locking system having glass window. Digital electronic voltmeter & ampere meter should be provided along with the required current transformer and selector switches. The internal control wiring should be done with flexible PVC LT cable with proper thimbling at each end. The system should trip the motor on power failure and on appearance of any electrical fault which may otherwise damage the motor field coils and should not restart automatically until unless the system is reset manually, thus providing automation to the system and protection to the motor .The system / star delta auto starter should not fall into delta if it does not fall into star mode first and should remain de-energised to avoid damage to the motor / machinery and also to the power source / transformer. The system / star delta auto starter should trip off if it does not fall into delta & remains in star mode for more than 10-20 seconds. The system shall provide protection against:-Low voltage below 350 V, High Voltage above 450 V, Single phasing, Reverse phasing, Un Balanced phasing, Dry running, Overloading. In addition the system should have the following audio & visual features for a quick and accurate diagnosis of the appeared fault / status for a speedy rectification of the system-- Separate LED fault / status indicators, LED phase indicators. An isolation by pass system, for fault analysis of system, with a blinking indicator. An audio warning system/Siren which activates only on starter failure to trip the motor on appearance of any electrical fault mentioned above, to warn the operator to switch off the motor manually.3 LED, contactor ‘COIL OK’, indicators, one for each of the contactors / coils. LED star & delta indicators to access the star to delta timing. A tamper proof starting system to avoid manipulations by the motor operator to keep the system in a permanently ON position. The job further involves providing and fitting of 80mm dia CS Sluice valve -1no. by way extraction of old wornout Sluice valve 80mm dia along with pipe side flanges and subsequently providing and fitting of new 80mm dia CS Sluice valve -1no. of reputed make and same rating and specifications as compatible with pump together with fitment of new flanges, nut, bolts, gaskets complete with cutting and welding work. Complete job includes cost of material and equipment, transportation charges, manual carriage charges, skilled and unskilled labour charges , hire charges of tools and tackles etc. (Complete job)