Pradhan Mantri Gram Sadak Yojana Tender

Prime Coat:- Providing and applying (medium porosity) primer coat with bitumen emulsion (ss-1) V.G-10 on prepared surface of granular base inculding cleaning of road surface and spraying primer at the rate of 0.90-1.2 kg/sqm using mechanical means as per Technical Specification Clause 502.including cost, loading unloading,haulage octroi charges etc complete (finished work to be measured complete).

Tack Coat: - Providing and applying tack coat with Bitumen emulsion (VG-10) using emulsion distributor at the rate of 0.20 to 0.25 kg per sqm on the prepared bituminous surface cleaned with Hydraulic broom as per Technical Specification Clause 503..including cost, loading unloading,haulage octroi charges etc complete (finished work to be measured complete).

Bit Macadam (Waste Plastic) :- P/L Bit Macadam with Waste Plastics (50mm thick ) with hot mix plant using crushed aggregate of grading as per Table 500.3and 500.4 premixed with bitumen binder, V.G-10, not less than 3.3% laid over a previously prepared surface with paver finisher to the required camber, grade level and alignment and rolled to achieve the designed compaction as per tecnical specifications clause 504. including loading unloading haulage octori charges complete.(finished work to be measured complete).

OPEN GRADED PRE-MIX-CARPET: - Providing,laying (by mech. Means ) & rolling of pre-mix carpet of 20mm th. Composed of 13.2mm to 5.6mm aggregates,using bitumen VG-10 by mech. Means to reqd. , line , grade and level , to sereve as wearing course on previously prepared base ,including mixing in a suitable plant laying &rolling with a three wheel 80-100KN static roller , finished to required level & grade to be followed by seal coat of type Bas per technical specification clause 508. including loading unloading haulage octori charges complete.(finished work to be measured complete).

Seal Coat: - Providing and laying seal coat sealing the voids in a bituminous surface laid to the specified levels, grades and cross fall using Type B bitumen (VG-10) as per Technical specification Clause 510 and 510.2.3 by mechanical means Including loading, unloading, haulage octroi charges etc complete (finished work to be measured).

Berm/Shoulder :- Construction of Khak Bajri shoulders with approved material obtained from approved source with all lifts and leads, transporting to site, spreading, grading to required slope and compacted to meet requirement of table 300.2 with required lead /Lift as per tech. specification clause 303.1.including cost and carriage of all materials from approved source to site of work,with all leads, lifts, loading unloading and octori.(Finished work to be measured, complete ) .

Cement Concrete Drain ( 1500 Rm )

Earth Work in excavation for structures as per drawing and technical specification Clause 305.1 including setting out construction of shoring and bracing and removal of stumps and other deleterious material disposal as directed by Er. Incharge ,dressing of side ,bottom and backfillingf in trenches with excavated suitable material, ordinary soil.

Providing concrete for plain/reinforced concrete in open foundations complete as per drawings and technical specifications Clause 802, 803, 1202 & 1203. Including loading, unloading, haulage royalty,octroi charges, from work etc complete. P.C.C Grade M-10 (1:3:6) Nominal mix (finished work to be measured).

Providing concrete for plain/reinforced concrete in open foundations complete as per drawings and technical specifications Clause 802, 803, 1202 & 1203. Including loading, unloading, haulage royalty,octroi charges, from work etc complete. P.C.C Grade M-15 (finished work to be measured).

Providing weepholes in brick masonry/stone masonry, plain/reinforced concrete abutment, wing wall, return wall with 100 mm dia AC pipe extending through the full width of the structures with slope of 1(V):20(H) towards drawing face complete as per drawing and technical specification Clauses 614, 709, 1204.3.7(finished work to be measured complete).

Plain/reinforced cement concrete in substructure complete as per drawings and technical specification Clauses 802, 804, 805, 806, 807, 1202 ans 1204.including cost, loading unloading,haulage octroi charges etc complete (finished work to be measured complete).(PCC Grade M20)

Providing and laying reinforced cement concrete in superstructure as per drawing and technical specifications Clauses 800, 1205.4 and 1205.5 .including cost, loading unloading,haulage octroi charges etc complete (finished work to be measured complete). (RCC Grade M20)

Supplying, fitting, and placing HYSD bar reinforcement in superstructure complete as per drawing and technical specifications Clauses 1002, 1010 and 1202.including cost, loading unloading,haulage octroi charges etc complete (finished work to be measured complete).

Road Furniture

Providing and fixing of retro-reflectorised cautionary, mandatory and informatory sign as per IRC:67 made of encapsulated lens type reflective sheeting vide Clause 1701.2.3 fixed over aluminium sheeting, 1.5 mm thick supported on a mild steel angle iron post 75 mm x 75 mm x 6 mm firmly fixed to the ground by means of properly designed foundation with M15 grade cement concrete 450 mm x 450 mm x 600 mm, 600 mm below ground level as per drawings and Technical Specification Clause 801

Providing and fixing of citizen information boards as per drawing and details of PMGSY fig.3A steel tube firmly fixed to the ground by properly designed foundation with M-15 grade cement concrete 450*450*600mm, 600m below round level as per drawing and technical specification Clause 801 Including all leads, lifts of all materials complete job (finished work to be measured). Clause 1701.

Providing and fixing of typical PMGSY informatory sign board with logo as per MORD specification and drawing. Three MS plates of 1.6mm thick, top and midldle plate duly welded with MS flat iron 25mm*25mm size on back on edges. The lower plate will be welded with MS angle iron frame of 25mm*25mm*5mm. The iron frame of the the lower most plate and flat iron frame of middle plate will be welded with two numbers 75mm*75mm of 12SWG sheet tubes posts duly embeded in cement concrete M-15 grade blocks of 450mm*450mm*60mm, 600mm below ground level. The top most diamond plate will be welded to middle plate by 47mm*47mm of 12SWG steel plate tube. All M.S will be stove enameled both sides lettering and printing arrows, border ete will be painted with ready mixed synthentic enamel paint of supperior quality in a required shade and colour. All sections of framed posts and steel tube will be painted with primer and two coats of epoxy paints as per drawing clause 1701 and annexure 1700.1. Including loading unloading, haulage ete complete job.

Maintenance for Five Years

1st Year

2nd Year

3rd Year

4th Year

5th Year

The Contractor has to quote the rates for Construction part without GST and GST @12% shall be added at the time of Allotment.