Floriculture Department Tender

Filling available excavated earth (excluding rock) in trenches, plinth, sides of foundation etc. Layers not exceeding 20cm in depth, consolidating each deposited layer by ramming and watering lead upto 50m and lift upto 1.5m. Cum

Supplying and Laying PVC Conduit ISI marked in the existing surface including bends and extra as per requirement at site.(Item as per LMR)

40 mm dia

Providing and fitting of 3 HP, 3-Phase Sewerage Submersible Pump/Motor set of Kirlosker, KSB, Crompton Greaves, Usha or approved make. The job includes material, carriage and labour charges. (Head and discharge as per site conditions and as approved by site Engineer)(Item as per LMR)

Providing and fitting of 5 HP, 3-Phase Sewerage Submersible Pump/Motor set of Kirlosker, KSB, Crompton Greaves, Usha or approved make. The job includes material, carriage and labour charges. (Head and discharge as per site conditions and as approved by site Engineer).(Item as per LMR)

Providing Fixing installation and testing of 200 Amp Main Panel. The feeder panels shall be outdoor type made out of 14 gauge rolled Steel, painting two coats steel primer and two coats of synthetic enamel paint from inside and outside, slopping head at a suitable angle and overhang to provide complete protection from water and moisture, provided with lockable hinged door. All the steel section used in the fabrication shall be carefully leveled straightened with following accessories duly wired neatly. The feeder panels are to be installed in Cement Concrete Block in 1:3:6 with 20% boulders as per the site conditions and minimum 1’.0” above ground level. (Site selection as per the directions of Site Engineer). The job includes thimbling of all the incoming and outgoing cable ends of the feeder panels with crimping tool including required nuts bolts and washers: Incoming :- i MCCB 200Amps,4 pole 25KA of GE make – 01No ii Digital meter (V.A.F & P.F) of L&T make. - 01No iii Ct’s 200/5 ratio – 1 Set iv Indicating lamps (LED type) R, Y & B -01 Set v Control fuses for metering protection of GE make. -01 Set vi Al Bus- Bar-01 Set Outgoing :- i MCCB 100Amps, 4 pole 25KA of GE make – 01No ii TPN 63Amps – 04Nos iii MCB DP 32 Amps. 10 KA of GE make – 02Nos iv Starter for 3 HP and 5 HP motor=04 nos. v SPN 63 Amp=04 nos (Item as per LMR)

Providing and Laying following sizes of Copper Submersible cable of Havells,Polycab,Anchor,Finolex or equivalent make.Complete including making of joints.(Item as per LMR)

3-core 4 mm sq.

Providing and laying of armoured aluminum cable of Havells, Anchor, Finolex, Polycab or Equivalent make in dug out trenches. The job includes digging out trenches and laying of cable including refilling of trenches.(Item as per LMR)

50 mm sq 3.5-core.

Hire Charges of Technicians engaged for the Welding of joints in G.I pipe .Complete job includes cost of material welding set and labour charges . (Item as per LMR)

Providing and fitting 150 mm dia Non return valve/Control valve for one way flow of approved quality and make and as directed by engineer in charge.Complete Job(Item as per LMR)

Providing and Fitting of Flanges for fixing of pump sets of approved make.(dimensions as per requirement at site and as directed by site engineer).Complete Job.(Item as per LMR)

Providing and fitting of G.I.Fittings.(Item as per LMR)

2”Elbow

2” Union

2” Tee

2” Socket

2” Plug

21/2" X 2” Reducer Socket

2” x 12” Nipple

2” x 9” Nipple

2” x 6” Nipple

2” x 4” Nipple

Providing and laying of HDPE pipe in dug out trenches complete with necessary fittings. The job includes digging out trenches for laying of HDPE pipe line including refilling and neatly levelling of trenches.(Item as per LMR)

150 mm OD x 6Kg / cm2