Central University Of Jammu Tender

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level :1:4:8 (1 Cement : 4 coarse sand (zone-III) : 8 graded stone aggregate 40 mm nominal size)

Providing and Laying 75 mm thick compacted bed of dry brick aggregate 40 mm thick nominal size including, spreading , well ramming and consolidation, including grounting with Jamuna sand finishing Smooth as per the directions of Engineer-In-Charge

Providing and laying at or near ground level factory made kerb stone of M-25 grade cement in position to the required line, level and curvature jointed with cement mortar 1:3(1 cement: 3 coarse sand ) including making joints with or without grooves (thickness of joints except at sharp curve shall not to more than 5mm) including making drainage opening wherever required complete etc. as per direction of Engineer-in-charge (length of finished kerb edging shall be measured for payment). (Precast C.C. kerb stone shall be approved by Engineerin- charge).

Preparation and consolidation of sub grade with power road roller of 8 to 12 tonne capacity after excavating earth to an average of 22.5cm depth, dressing to camber and consolidating with road roller including making good the undulations etc. and re-rolling the sub grade and disposal of surplus earthwith lead upto 50 metres.

Cement Concrete1:2:4(1 cement:2 Coarse:4 40 mm aggregate) in pavements laid to required slope and camber, as required including consolidation finishing and tamping complete

(a).Providing and laying in position ready mixed M-30 grade concrete for reinforced cement concrete work, using cement content as per approved design mix, manufactured in fully automatic batching plant and transported to site of work in transit mixer for all leads, having continuous agitated mixer, manufactured as per mix design of specified grade for reinforced cement concrete work, including pumping of R.M.C. from transit mixer to site of laying , excluding the cost of centering, shuttering finishing and reinforcement, including cost of admixtures in recommended proportions as per IS : 9103 to accelerate/ retard setting of concrete, improve workability without impairing strength and durability as per direction of the Engineer-in-charge. Note :Cement Content considered in this item is 330kg/cum. Excess/Less/Cement used in the item is payable recoverable,seperately,

Steel reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding all complete upto plinth level. Thermo-Mechanically Treated bars of grade Fe-500D or more.

Providing and Fixing Premoulded Joint Filler in expansion joints of RCC /CC Pavements after making the joints dust free with high pressure air jet cleaners all complete

Providing and laying in position ready mixed or site batched design mix cement concrete for reinforced cement concrete work; using coarse aggregate and fine aggregate derived from natural sources, Portland Pozzolana / Ordinary Portland /Portland Slag cement, admixtures in recommended proportions as per IS: 9103 to accelerate / retard setting of concrete, to improve durability and workability without impairing strength; including pumping of concrete to site of laying, curing, carriage for all leads; but excluding the cost of centering, shuttering, finishing and reinforcement as per direction of the engineer-in-charge; for the following grades of concrete. M25 grade All works upto Plinth Level

All works above Plinth Level upto floor Five

Centering & Shuttering for Foundations, bases of columns, mass concrete

Centering & Shuttering for Walls Columns any sizes

Providing and Laying Brickwork with common burnt brick of class designate 75 in superstructure above plinth

Providing and Laying 15 mm thick Plaster on rough side of single or half brick wall (1:6)