Urban Development Department Tender

Supplying and erection of 40/50/63 amps rating, 10 KA breaking capacity, 240 volts, 'C' curves, miniature circuit breaker of following poles in the existing MCB DB complete with connections etc. as required Triple pole. Cat-A.

Supplying and erection of 6 amps. to 32 amps. rating, 10 KA breaking capacity, 240 volts, 'C' curves, miniature circuit breaker of following poles in the existing MCB DB complete with connections etc. as required Single pole & neutral. Cat-A.

Outdoor lighting distribution board: Incoming:- 1 No. 40 Amps, FP MCB + RCCB, 415 volts, 3 phase, 50 Hz ; MFM meter, With RS 485 , Class 1.0 with 3 Nos. CT 40/5A, CL-1.0 ; 1 set of Phase indicating lights ;1 no - 40 Amps contactor with Astronomical Timer; Outgoing: 4 Nos 10 Amps, SP MCB, 230 volts, 3 phase, 50 Hz.; 1 No 32 Amps, FP MCB,

Providing and laying of one No. aluminium conductor, PVC insulated and PVC sheathed, armoured/XLPE power cable, working voltage 1100 volts grade direct in ground; to be laid 1 meter below the ground level including excavation sand cushioning, protective covering and refilling the trench etc. of the required size:-3Cx16 sq.mm. A2XFY

3Cx10 sq.mm. A2XFY

4Cx 6sqmm A2XFY ( street lighting)

Supply and Fixing heavy duty AL cable glands with rubber ring fo suitable size cable complete with outgoing tails, insulating tape etc and Supply and erecting crimping type aluminium/copper lugs conforming to IS suitable for cable as below evenly crimped with high pressure tool and connected to switch gear terminal with brass/cadmium plated nut bolts in an approved manner 3Cx16 sq.mm. A2XFY

3Cx10 sq.mm. A2XFY

4Cx 6 sqmm A2XFY ( street lighting)

Indoor and Outdoor Illumination: Supply , Installation and Testing of following fixtures for guard room, basement , Street light etc. with All complete work. IP65 Surface Mounted Batten Philips BN308C LED Batten with PIR Sensor or equivalent (For Indoor Lighting)

60W LED Street light luminaire, electrical Class I, made of high pressure die cast aluminium body. IP 66 optical & control gear compartment sealed by a toughened clear glass protector (IK 08 impact resistance) for an optimal luminous flux. The Upward Light Output Ratio (ULOR) should be 0% (at 0 inclination) to avoid glare and light pollution. The luminaire shall have a CCT of 5700K and CRI ≥ 70. Each LED should have a specific lens that generates uniform photometric distribution of the luminaire. The luminaire shall have direct tool less access to gear and electronic compartment. The Luminaire shall be provided with a driver (efficiency 85%) with internal surge protection of 4/6 kV and an external Surge Protection Device (SPD) of 10/10 kV (in both Common and Differential modes), Power Factor 0.95, a residual flux of 70% (L70) @ 50,000 hours at Ta 50° deg. Luminaire Efficacy:- 110 Lumen/W, (Keselec ROMA MINI 60W CW LED or equivalent)

Supply,Installation and commissioning of Conical Pole 8M GI with Base plate

Supply,Installation and commissioning of Receptacles(including plug),ceiling fan regulators and switchboards of following rating with necessary accessories.all complete works Ceiling Fan 1200 mm sweep, Category-A

Wiring: Wiring for light point / fan point / exhaust fan / call bell point with 1.5 Sq. mm. PVC insulated heat resistant flame retardant (HRFR) and low smoke single core (flexible) copper conductor cable in surface/recessed PVC conduit and earthing the light point with 1.5 Sq.mm. HRFRLS/PVC insulated single core copper conductor cable as required. (Group C)

Supplying and fixing G.I. Modular box of (140mmx78mmx50mm) size with modular plate and cover in recess including providing and fixing 5 pin 5/6 amps modular socket outlet and 5/6 amps, modular switch, connections etc. as required.

Earthing & Lightning Protection :S.I.T.C. of Earthing with G.I earth pipe 4.5 mtr. long and 40mm dia, including accessories and providing masonry enclosure with cover plate having locking arrangement and watering pipe etc. ( but without charcoal or coke and salt ) complete as required.

Extra for using salt and charcoal for pipe earth electrode complete as required.

Supply,Installation and commissioning of Safety procedures for electrical equipments all complete works. :Providing and fixing M.V.danger notice plate of 200 mm x 150 mm made of mild steel at least 2 mm thick, and vitreous enameled white on both sides and with inscription in signal red color on front side as required.

New Electricity connection charges and Liasoning charges (Lum sump)