The Himachal Pradesh State Industrial Development Corporation Limited Tender

P/F precaoted galvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm (+0.05%) total coated thickness with zinc coating 120gm per sqm as per IS:277,in 240mpa steel grade,5-7 microns epoxy primer on both side of the sheet and polyster top coat 15-18 microns.Sheet should have protective guard film of 25 micron minimum to avoid scratches during transportation and should be supplied in single length upto 12m or as desired by Engineer-In-Charge. The sheet shall be fixed using self drilling/self tapping screws of size (5.5 x 55mm)with EPDM seal, complete upto any pitch in horizontal/vertical or curved surfaces excluding cost of purlins,rafters and trusses and i/c cutting to size and shape wherever required including carriage of materials ,labour ,tool and plants through all modes of transportation with in all leads and lifts, and as per direction of the Engineer-in-charge.

Providing and fixing on wall face unplsticised rigid PVC rain water pipes conforming to IS :13592 type A, including jointing with seal ring conforming to IS :5382, leaving 10mm gap for thermal expansion, (i) Single socketed pipes. (A) 110mm diameter

Providing and fixing M.S. holder bat clamps of approved design to C.I. or S.C.I. rain water pipes embedded in and including cement concrete blocks 10 x 10 x 10 cm of 1:2:4 mix (1 Cement: 2 coarse sand : 4 graded stone aggregate 20 mm nominal size) and cost of cutting holes and making good the walls etc. 100 mm diameter including carriage of materials ,labour ,tool and plants through all modes of transportation with in all leads and lifts, and as per direction of the Engineer-in-charge.