Public Works Department Tender

Providing and laying Expension joint as per MORD specification including carriage of all labour, equipment and material to various location through all modes of transportation in all leads lifts and all incidental charges.

Drainage spouts complete as per drawing and as per technical specification clause-405 (four zero five)-A and MORD specification including carriage of all labour equipment and materials to various location of site through all modes of transportations in all leads lifts and all incidental charges

Providing and laying 56 mm( Fifty Six mimlimeter ) thick Mastic Asphalt wearing course with paving grade polymer modified bitumen meeting the requirements given in table 500-29, prepared by using mastic cooker and laid to required level and slope after cleaning the surface, including providing antiskid surface with bitumen precoated finegrained hard stone chipping of 13.2 mm nominal size at the rate of 0.005 cum per 10 sqm and at an approximate spacing of 10 cm center to center in both directions, pressed into surface when the temperature of surfaces is not less than 1000C, protruding 1 mm to 4 mm over mastic surface, all complete as per clause 515. as per MORTH specification clause No. 509 complete in all respects and as per direction of Engineer in charge including carriage of all labour, equipments and materials to various locations through all modes of transportation in all lead & lifts and all incidental charges.

Providing and fixing in position pipe railing consisting of IS Rolled steel joist posts designation ISMC 100 (100x75) at 2.5 m interval and three rows of 50 mm dia steel pipes (light) including fixing in position on bridge deck complete as per drawing and technical specifications Clause 1208.2

Painting two cooat, including primer court with epoxy paint of approved brand on concrete steel surface. After through cleaning of surfaces to give an even shared as per drawing and MORD technical specification.

Providing concrete for Plain/reinforced cement concrete in sub-sturcture complete as per drawing and technical specifications clause using concrete mixer RCC Grade M-25 upto all depth with in all leads, lifts of materials as per direction of Engineer-in-charge. as per MORD specification including carriage of all labour, equipment and material to various location through all modes of transportation in all leads lifts and all incidental charges.

Supplying fitting and placing uncoated HYSD bar reinforcement in foundation and super -structure complete as per drawing and technical specification. as per MORD specification including carriage of all labour, equipment and material to various location through all modes of transportation in all leads lifts and all incidental charges.