Public Works Department Tender

Providing and laying mechanically mixed and vibrated reinforced cement concrete grade M-30 (M-Thirty) for bridge work design mix with minimum cement contents at the rate 430 Kg (Four hundred thirty five kilograms) per cubic metres with 20 mm (Twenty millimetres) nominal size crushed stone aggregate (extra cement as per design mix above the minimum cement contents specified shall not be paid extra) on ground or under water including pumping of bailing out water, dewatering for all height/depth and any quantum of water including removal of slush which may be arise at the time of laying concrete and curing complete in all type of bridge structure as per MORTH technical specification clause 1500, 1700 and 2200 as directed by the Engineer-in-charge including carriage of material within all leads, lifts, and other incidentals. The rate is including octroi, royality, Malkana, toll tax, GST or any other taxes imposed by the Government.

Providing and laying mechanically mixed and vibrated plain/reinforced cement concrete design mix to obtain minimum compressive strength of grade M-30 (M- thirty) using minimum cement contents of 430 ( four hundred thirty kilogramme ) per cubic metre in wearing coat including reinforcement complete with bending, binding, straightening of bars, cost of binding wire and cost of curing and form work complete in all heights/depths as per drawing and technical specifications and as per the directions of Engineer-in-Charge including carriage of materials within all leads and lifts and other incidentals.The rate is including octroi, royality, Malkana, toll tax, GST or any other taxes imposed by the Government.

Supplying fitting and placing HYSD bar reinforcement in sub structure complete as per drawing and MORTH technical specifications section 1600 and 2200 including cutting, bending, binding, straightening and placing in position complete in all respect including cost of binding wire upto all height and depth as directed by the Engineer-in-charge including carriage of material within all leads, lifts, and other incidentals. The rate is including octroi, royality, Malkana, toll tax, GST or any other taxes imposed by the Government.

Construction of Reinforced cement concrete railing of M-25 grade (M-Twenty five) in cast in situ with 20 mm (twenty millimetre) nominal size aggregate true to line and grade, tolerance of vertical railing post not to exceed 1 in 500 (one in five hundred) centre to centre spacing between vertical posts not to exceed 2000 mm (two thousand millimetre) leaving adequate space between vertical post for expansion complete including the cost of reinforcement, form work and curing complete as per approved drawing and MORTH technical specifications section 2700, 1500, 1600 and 1700 and as per the entire satisfaction and as directed by the Engineer-in-charge including carriage of material within all leads, lifts, height and other incidentals. The rate is including octroi, royality, Malkana, toll tax, GST or any other taxes imposed by the Government.

Back filling behind abutment, wing wall, return wall etc with granular material complete as per drawing and clause 710.1.4 of IRC:78 & MORTH technical specifications section 2200 or as per direction of Engineer - in- Charge including carriage of materials within all leads lifts and other incidental. The rate is including octroi, royality, Malkana, toll tax, GST or any other taxes imposed by the Government.

Providing and laying mechanically mixed and vibrated reinforced cement concrete grade M-30 (M-Thirty) mix design with minimum cement contents of 407 Kgs (Four hundred seven kilograms) per cubic metre with 20 mm (Twenty milimetres) nominal size graded crushed stone aggregate (extra cement as per design mix above the minimum cement contents specified shall not be paid extra) in approach slab including cost of form work and reinforcement complete with bending, binding, placing in position of bars with cost of binding wire as per drawings and MORTH technical specifications section / clause 1500, 1600 1700 and 2700 and as directed by the Engineer-In-charge including carriage of material within all leads, lifts, height and other incidentals. The rate is including octroi, royality, Malkana, toll tax, GST or any other taxes imposed by the Government.

Providing and fixing drainage spouts complete with 100 mm (one hundred millimetre) dia galvanized mild steel down pipe corrosion resistant structural steel head and grating complete as per Morth Technical specifications section - 2700 and as per the direction of Engineer-in- Charge including carriage of materials within all leads, lifts and other incidental. The rate is including octroi, royality, Malkana, toll tax, GST or any other taxes imposed by the Government.

Providing and laying 100 mm (Hundred millimetre) dia PVC pipe make of Phinolux , D-plast etcetra of working pressure 6kg/ cm2( Six kilograme per square centimeter) weep holes in brick masonry/stone masonry, plain reinforced concrete, Abutments, Wing walls, Return walls and retaining/breast walls extended through the full width of the structure with slope I (V):20(H) (One vertical : Twenty Horizontal) towards drainage face complete as per drawing and MORTH technical specification clause 2706 and as per direction of Engineer-in-charge including carriage of materials within all leads lifts and other incidentals. The rate is including octroi, royality, Malkana, toll tax, GST or any other taxes imposed by the Government.

Providing and laying burried expansion joint, expansion gap being 20mm (Twenty milimetres) covered with 12mm (Twelve milimetres) thick, 200mm (Two hundred milimetres) wide galvanised weldable structural steel plate as per IS: 2062, placed symmetrical to centre line of the joint, resting freely over the top surface of the deck concrete, welding of 8mm (Eight milimetres) diametres 100mm (One hundred milimetres) long galvanised nails spaced 300mm (Three hundred milimetres) centre to centre along the centre line of the plate, all as specified in clause 2606 MORTH technical specificatios and as directed by the Engineer-in-Charge including carriage of material within all leads, lifts, height and other incidentals. The rate is including octroi, royality, Malkana, toll tax, GST or any other taxes imposed by the Government.

Earth work in excavation for all type of road structure such as retaining walls, breast walls, culverts, drains and parapets etcetera in all type of classification of soil, comprising of ordinary soil, ordinary rock , hard rock chiseling / wedging out rocks (where blasting is prohibited) as per drawings and MORD technical specification section 300 and 1600 as per the directions of the Engineer-in-Charge including setting out, construction of shoring and bracing, removal of stumps and other deleterious materials and disposal un-useful materials upto any lead and lift including dressing of sides bottom and back filling in trenches with excavated suitable / approved materials to the original surface in layers not exceeding 150mm (one hundred fifty millimetre) compacted thickness including shoring, strutting and pumping and bailing out water (surface and sub soil water) upto any depth and any quantum of water including cleaning of slush which may arise out during dewatering as per directions of Engineer-in-Charge including carriage of materials within all leads, lifts and other incidentals.Carriage of surplus muck genrated from cutting/ excavation work to the disposable/ dumping site to be selected by the contractor in private lands.The rate is inclusive of octroi, royality ,Malkana, toll tax , GST or any other taxes imposed by the Government .

Providing and Laying mechanically mixed and vibrated plain cement concrete in foundation for all type of structure complete of plain concrete nominal mix 1:5:10 (one cement isto five sand isto ten graded) crushed stone aggregate 40 mm (Forty millimetre) nominal size in or under water and curing complete including pumping or bailing out water, dewatering, removal of slush as required at site which may arrise at the time of laying under water complete for all height / depth including the cost of form work complete in all respect as per the drawing and MORD technical specifications Section 800, 900 ,1200 and 1600 and as per direction of Engineer-in-Charge including carriage of material within all leads and lifts and other incidental. The rates is inclusive of the octori, royality, Malkana, toll tax, sale tax , GST or other taxes imposed by the Government.