Military Engineer Services Tender

Material and labour for dry sand in trenches cushioning to under ground cable spreading, levelling hand punning complete all as specified and directed. Note- Punned down thickness will be measured for payment purpose.

M&L for bricks common burnt old size sub class `B' bricks laid dry for cable protection flat width wise complete all as specified and directed.

M&L and jointing testing and commisioning in replacement XLPE LT UG Cable insulated, screened, PVC bedded, galvanised steel strip or wire armoured, electric power cable (heavy duty) with multistranded aluminum conductors, 1100 Volt grade, laid in trenches / ducts / encased in GI pipe / fixed to pole/wall etc Make of LT UG Cable- Havells / KEI/ Polycab/Grandlay and including taking down old unserviceable cables complete all as specified and directed of Cross sectional area 3.5 core 120 Sqmm

All as per item No 6 above but of Cross sectional area 3.5 core 95 Sqmm

All as per item No 6 above but of Cross sectional area 3.5 core 50 Sqmm

All as per item No 6 above but of Cross sectional area 3.5 core 35 Sqmm

All as per item No 6 above but of Cross sectional area4 core 16 Sqmm

Supply & lay GI tubing light grade 50 mm dia bore in protection of cable at road crossing /hard standing/pole protection fixed with clamps as per site requirement etc all as specified and directed. Make :- Prakash surya/Jindal/Tata

S&F in replacement solar maintenance free battery nominal voltage 12V, 75 AH of make luminious/Exide/Amron complete all as specified and directed by Engr-in-Charge

S&F in replacement sloar LED light fitting luminiaire of 18/20W with fixing accessories and making electric connection from battery to light fitting with and including 20mm dia PVC conduit and PVC insulated copper conductor wire 2.5 Sqmm 3 core complete of make Havells/Bajaj/Surya all as specifed and directed by Engr-in-charge

M & L in repair for cement concrete PCC 1:4:8 type D-2 using 40mm graded stone aggregate as in pole coping in shape of round/square including dismanting complete all as specified and directed.

M&L for Cutting of road / hardstanding upto a size not exceeding 20 cms in width and not exceeding 60 cms in depth for laying of LT UG cable protection pipe line making good the disturbed portion so as to match existing finishing or with and including PCC 1:2:4 type B1 complete all as specified and directed.

M&L for unbinding from insulators ACSR conductor any size of LT over head line for repairs, restretching of 4/5 nos ACSR conductor to achieve proper sag and rewinding to the insulators using aluminium/GI wire including fixing of spacer as required all as required at site or directed. Note:- Distance between two poles irrespective of no of lengths of conductor shall be considered as a single span.

Cutting/ trimming of tree branches clearing 5 metres horizontal and 5 metres vertical distance from both sides of conductor including removing branches from site, complete all as specified & directed.Note:- (i) Clearing branches from both sides of conductor in between two consequtive poles shall be considered as one span irrespective of distance between poles.(ii) Cost of T&P required for cutting and removing branches shall be deemed to be included in rate quoted by bidder.

Supply and fix Outdoor type factory made bus bar chamber of size 0.75x0.45x0.40 metres depth made out of CRCA sheet 3.15mm thick with 4 No's aluminium bus bars of capacity 200 Amps,with colour code supported on insulators,including phase indicator R Y B , internally prewired having locking arrangement, handle, provision of suitable hole at bottom for incoming and outgoing under ground cables, panel having angle iron frame made of 40 X 40 X 6 mm angle iron and 60 cms long legs embedded upto 30 cms in PCC & 30 cms clear above ground complete including painting with two coats of powder coated paint over a coat of red oxide primer on exterior and interior faces, errection of Bus Bar chamber duly grouted in PCC M-15, type B0 using 12.5 mm graded crushed stone aggregate including earth work complete all as specified and directed.

M&L in replacement for Earthing complete with galvanised steel earth plate electrode 60 X 60 cm X 6 mm thick, buried directly in ground (earth pit not less than 2.25 meter deep below ground level) with top edge of the plate not less than 1.5 meters below normal ground level, connected to and inclduing GI Strip 25X4 mm as earthing lead, by means of bolts, nuts, check nuts and washers of galvanised iron all as shown in electrical plate No 5 of MES SSR Part I and testing on completion inclduing excavation and earth work in any type of soil, PCC (1:3:6) type C1 chamber, and cover 6 mm thick in cement concrete (1:2:4) type B1, funnel with wire mesh, GI watering pipe 20mm dia medium grade and lugs complete all as specified and directed with earth resistance not more than 1.0 OHMS. Note- In case earth resistance more than 1.0 ohms, the contractor wiil re earthing at no extra cost.

S&F in repair MCCB 3 Pole .415 V. fixed type,25 to 100 Amps with breaking capacity 25 KA

S&F in repair MCCB 3 Pole , 415 V, Adjustable type,160 Amps with breaking capacity 36 KA

S&F in repair MCCB 3 Pole , 415 V, Adjustable type,200 Amps with breaking capacity 36 KA

S&F in repair MCCB 3 Pole , 415 V, Adjustable type,250 Amps with breaking capacity 36 KA

Supply and stringing ACSR conductor in replacement on LT over head line securing on pole complete including necessary binding work, jumpering, PG clamp, maintaining proper sag as per IE rule etc and including taking down old unserviceable ACSR conductor complete all as specified & directed. Make:-Bharat conductor /ICC /Alind (Note :- (a) Rate is inclusive of jumper on cut point/2 pole structure shall be provided with PVC insulated sleeve.

M&L for PVC line seperator spiral type 3 phase 4 wire to making suitable gap in between LT line conductor with nuts bolts,washer complete all fixing accessories.all as specified and as directed by Engr-in-charge