Himachal Pradesh Irrigation And Public Health Department Tender

Providing tor steel reinforcement for R.C.C. work including bending, binding and placing in position complete upto floor two level including carriage of material complete in all respect within all leads and lifts complete to the entire satisfaction as directed by the Engineer-in-charge.

Providing and laying cement concrete work 1:4:8(1cement :4 Sand :8 graded stone aggregate 20 mm nominal size ) and curing complete excluding cost of form work in foundation and plinthcomplete within all leads and lifts as per direction and to the entire satisfaction of the Engineer-in-Charge.

Providing form work with steel plates 3.15mm thick welded with angle iron in frame 30x30x5mm, so as to give a fair finish including centring, shuttering , strutting and propping etc. with wooden battens and ballies height of propping and centering below supporting floor to ceiling not exceeding 4meters and removal of the same for insitu reinforced concrete and plain.

Vertical surfaces such as wall (any thick.) partitions & the like including attached pillasters, buttresses,plinth & string courses & the like with in all leads and lifts complete to the entire satisfaction as directed by the Engineer-in-charge .

Providing boulder/stone filling dry hand packed tightly behind retaining wall / under lean concrete to prevent the entry of surface water with in all leads and lifts complete in all repects & to the entire satisfaction of Engineer-in-Charge.

Providing and laying stone filling in wire crate made of G.I. wire filled with boulders with square cut faces against the wire (wire crate tobe measured and paid for seperately) complete in all leads and lifts and to the entire satisfaction of the Engineer-in-Charge.

Wire crate made of G.I. wire filled with boulders with square cut faces against the wire (boulder filling to be measured and paid for seperately ) G.I. wire 5mm thick corresponding to SWG 6 (15cmx15cm mesh) in cross gabion structure complete in all leads and lifts and to the entire satisfaction of the Engineer-in-Charge.

Design,fabrication and supply at site 1st stage mbedded parts, including shop painting etc., complete as per technical specifications and/ or as directed by the Engineer, Design Fabrication and supply at site second stage embedded parts of gate including shop painting etc. complete, asper technical specification and /or as direcred by the Engineer, Design fabrication and supply at site fixed wheel vertical lift gates of size 1000mm ( width) x1200mm ( height) with all accessories such as thrust pads, seals, guides, skin plates, stiffeners , horizontal and end vertical girders, lifting arrangements etc. including shop painting, as per IS: 4622 and technical specification and /or as directed by the Engineer, Design Fabrication including paint shop and supply at te site Hoistbridge and deck over gate opening in he intake including hand railing approach ladder/ stairways etc. complete as per technical specification and or as directed by the Engineer, Design Fabrication and supply including shop painting of Dogging Beam arrangement with its embedded parts complete as per Technical specification as directed by the Engineer in Charge complete in all respects in all leadsand lifts. complete within all leads and lifts as per direction and to the entire satisfaction of the Engineer-in-Charge.

Provision for structural design and drawing (after acertaining the safe bearing capapcity of the soil at site) the architecture drawing of whole components. The structural design & drawing for all the structures duly vetted from PEC Chandigarh/NIT's /IIT's shall be submitted by the contractor before start of work.