Himachal Pradesh Irrigation And Public Health Department Tender

Fine dressing the trenched ground.

Excavation in foundation,trenches etc. in earth work in all kinds of soil such as pick work, jumper work, blassting hard of soft rock by chiselling such as pick work, jumper work, blasting hard or soft rock by chiselling where the blasting work is prohibited, slushy, daldal and saturated soil including pumping or bailing out water within all heights, stacking the excavated soil within all leads clear from the edge of excavation and then returning the stacked soil in 15cm (fifteen centimetres) layer when required into plinths, sides of foundation consolidating each deposited layer by ramming and watering and then disposing of all surplus excavated earth as per the direction of Engineer-in-Charge with in all leads and lifts.

Supplying and stacking manure at site including royalty and carriage complete in all respect including all leads and lift. (Sludge measured in stacks will be reduced by 8% for payment).

Spreading sludge dump manure or/and good earth in required thickness (cost of sludge, dump manure or/and good earth to be paid seperately) as per the direction of Engineer-in-Charge with in all leads and lifts.

Providing and Laying cement concrete 1:3:6 (1cement: 3 sand: 6 graded stone aggregate 40mm nominal size and curing complete excluding the cost of form work in foundation and plinth complete in all respect including all leads and lifts.

Providing and laying cement concrete 1:5:10 (1 cement: 5 sand: 10 graded stone aggregate 40mm nominal size) and curing complete excluding cost of form work in. Foundation and plinth as per the direction of Engineer-in-Charge with in all leads and lifts.

Providing and laying cement concrete 1:4:8 (1 cement: 4 sand: 8 graded stone aggregate 40mm nominal size) and curing complete excluding cost of form work in. Foundation and plinth as per the direction of Engineer-in-Charge with in all leads and lifts.

Providing and Laying cement concrete work 1:1.5:3 (1cement:1.5 sand:3 graded stone aggregate 20mm nominal size) and curing complete excluding cost of form work and reinforcement for reinforced concrete work:- Foundation, footing, bases of columns and mass concrete as per the direction of Engineer-in-Charge with in all leads and lifts..

Coursed rubble masonry (second sort) with hard stone in foundation & plinth with Cement mortar 16 (1 cement 6 coarse sand) complete in all respect including all leads and lifts

Brick work with common burnt clay modular bricks of class designation 7.5 in foundation and plinth in: Cement mortar 1:4 (1 cement : 4 coarse sand) complete in all respect including all leads and lifts

20 mm cement plaster of mix : Cement mortar 1:4 (1 cement : 4 coarse sand) complete in all respect including all leads and lifts

Providing and placing in horizontal layers filtering media duly graded, screened, washed and cleaned as specified by the Engineer-in-Charge.

Bio media broken stone screened, washed and graded from 50mm - 75mm and 25 - 40 from approved source.

Technology cost including Design & Drawing and supplying of Microphytes and enzymes at site including carriage within all leads and lifts.

Providing Tor steel reinforcement for RCC work including bending, binding & placing in position complete upto floor two level complete in all respect including all leads and lifts

Providing form work with steel plates 3.15mm thick welded with angle iron in frame 30x30x5mm, so as to give a fair finish including centring, shuttering , strutting and propping etc. with wooden battens and ballies height of propping and centering below supporting floor to ceiling not exceeding 4meters and removal of the same for insitu reinforced concrete and plain.

Edges of slabs and breaks in floors and walls under 20 cm wide.

Vertical surfaces such as walls (any thickness) partitions and the like I/c attached pillasters,buttresses, plinth and string courses and the like;

Mud-concrete: Providing and laying in foundations mud concrete with graded Stone aggregate 40mm nominal size excluding Cost of Form work complete in all respect including all leads and lifts

Boulder/ Stone soling dry hand packed tightly under floor with in all leads and lifts.

Dry stone pitching 22.5 cm thick including supply of stones and preparing surface complete in all respect including all leads and lifts.

Providing and fixing 3 layer PP-R (Poly propylene Random copolymer) pipes confirming to IS:15801 UV stabilized & anti - microbial fusion welded, having thermal stability for hot & cold water supply, including all PP - R plain & brass threaded polypropylene random fittings, including trenching, refilling & testing of joints complete as per direction of Engineer-in-Charge. PN - 10 Pipe, 110 mm OD (SDR-11)

Supply of submersible pumping set of KSB/Calama/SU/Johnston/ Crompton/BS/ SABAR/ Oswal/ Seerus/LUBI/ Grandfus/ Hindustan/ worthigton make conforming to latest relevant BIS Code. The pump should be fitted with bronze impeller of suitable alloys as per IS 1520-1980 (latest) suitable for water lifted having greased packed bearings and shaft with wound stator on motor side and with soft protection sleeve on pump side ensuring better life for shaft coupled to a submersible squirrel cage electric induction motor (water proof type) of required HP & 2900rpm of reputed make conforming to BIS 9283-1979 latest with upto date amendments, totally dust and water proof for submersible duty isolated from the pump by intermediate casing with double mechanical seal in oil chamber and grease packed lubricated bearings and provided with stainless steel thrust bearing plate to with stand non vertical loads with minimum wear and tear. It should also be fitted with a device to take up expansion of water with the heating of motor. The pump set should include water level guards, erection clamps , cable clips and depth gauge including starter, panel, cable and all other associated accessiories etc.

Providing and laying of one No. copper conductor, PVC insulated and PVC sheathed, armoured/XLPE power cable, working voltage 1100 volts grade direct in ground; to be laid 1 meter below the ground level including excavation sand cushioning, protective covering and refilling the trench etc. of the required size: - Armoured cable 10 sq. mm (twin core).

Providing, fixing and Installation of Floating/ Fixed Fountain for Aeration System comprising of Lilly Nozzle Made in Brass with shine Chrome CNC Cutting Nozzle Specification: - Bronze/Gunmetal/Brass of approved make at site including carriage within all leads and lifts.

Providing and laying 80mm thick cement concrete paver block of of M-30 grade with approved colour, design & pattern factory made chamfered edge Cement Concrete paver blocks in footpath, parks, lawns, drive ways or light traffic parking etc, of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over 25mm thick compacted bed of Cement Motor 1:4 (1 cement:4 sand), compacting and proper embedding/laying of interlocking paver blocks into the motor bedding layer through vibratory compaction by using plate vibrator, filling the joints with cement and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand complete all as per direction of Engineer-in-Charge.

Providing and laying at or near ground level factory made kerb stone of M-25 grade cement concrete in position to the required line, level and curvature, jointed with cement mortar 1:3 (1 cement: 3 coarse sand), including making joints with or without grooves (thickness of joints except at sharp curve shall not to more than 5mm), including making drainage opening wherever required complete etc. as per direction of Engineer-in-charge (length of finished kerb edging shall be measured for payment). (Precast C.C. kerb stone shall be approved by Engineer-in-charge).

Supplying and planting of potted plants at site including carriage within all leads and lifts.

Habiscus (big)

Supplying and Installation of all weather LED Screen of approved brand and manufecture alongwith Sound system including all accessories at site including carriage within all leads and lifts.

Supplying and fixing of Signage Boards with flex printing of Tubular Section frame of required and shapes including righting of water conservation slogans complete with all accessories at site including carriage within all leads and lifts.

Digging holes upto 1 metre dia in soil and refilling the same with the excavated earth mixed with manure in the ratio of 2:1 by volume (2 parts of stacked volume of earth after reduction by 20% :1 part of stacked volume of manure after reduction by 8%) flooding with water, dressing including removal of rubbish and surplus earth, if any with all leads and lifts (cost of manure or sludge or extra good earth, if needed, to be paid separetaly).

Supplying and planting of potted plants at site including carriage within all leads and lifts.

Golden Cypress

Gycas Palm

Rubina Palm

Rabish Palm

Supplying and erection of 4 mtr Decorative Poles made of galvanised Mild steel pipes fitted withcast aluminium/ iron embellishments duly polyurethane paint coated. Bottom dia-139.7 (1M), Top dia- 76.1 (3M), Base plate-300x300x10mm, with foundation nuts & bolts MFHD - 203 (2.5 inch pipe fitted on top portion of pole) without wiring complete in all respect including all leads and lifts

Supplying and errection of LED Post Top Lights BGCTNP 40W WW on Pole of apprved brand and manufecture including all accessories at site including carriage within all leads and lifts.

Supplying and errection of Fency Lights (Laddi type) 4 mtr length arround the Pole from bottom to top of apprved brand and manufecture including all accessories at site including carriage within all leads and lifts.

Steel Work welded in built up sections, trusses and framed work, including cutting, hoisting, fixing in position and applying a priming coat of re lead paint.( In gratings framed guard bars, ladders, railings, brackets and similar works.) complete in all respect including all leads and lifts.

Construction of RCC framed structure Panel Room in M-25 concrete grade (as per proper Design & Drawing) complete in all respect Panel Boards etc. The outer doors & Window shall be in double shutters and grills for windows & internal wiring shall be in PVC conduit. All work shall conform to relevent IS code and to the entire satisfection of the Engineer in Charge.

Manufacturing and fixing of mural/ Sculpture of birds by using HPSR 2009 item code No. 1504040000 i.e Steel Work welded in built up sections, trusses and framed work, including cutting, hoisting, fixing in position and applying a priming coat of re lead paint.(In gratings framed guard bars, ladders, railings, brackets and similar works.) complete in all respect including all leads and lifts.

Big mural/ Sculpture of birds

Small mural/ Sculpture of birds

Providing Mali/ Gardner for Operation and maintenance for one Year complete in all respect as per the direction of Engieer in charge