Public Health Engineering Department Tender

Wiring and Cabling Complete wiring and cabling as per detailed specifications i) From control panel to starter 2 x 3 core x 200 sqm runs of armoured.

Wiring and Cabling Complete wiring and cabling as per detailed specifications ii) Starters to motors 1 x 3 core x 200 sqm to armoured.

Earthing Double loop earthing for all electrical equipment from the existing grid as per electricity rules with 5 Nos. earth pipe complete

Pipes and Fittings Providing laying jointing and testing M.S. D/F pipes made of M.S. sheet confirming to IS: 2262 welded as per IS: 816 pipes IS standard, valves and specials required for suction and delivery pipes including testing etc. complete in all respect.

Supply and erection of Hand operated Travelling crane with Trolley and Chain Block complete 3 tonne capacity

Sump Pump Provision for Supply and Erection of Sump Pump, Dewatering pump and vacuum pump complete

Providing and Installation of flow meter suitable to measure discharge 750 cum./hr to 2000 cum/hr

Supply and fixing of VCB 24 volts Deiperated as per DHBVN requirement complete.

Supplying and fixing of Sluice Valves, Kinetic air valves, Zero Velocity valves along with contingent material required for their fixing with pipes and specials complete in all respect as per specification and direction of the Engineer-in-charge of rating Pn 1.6 (b) Supplying and fixing of 600mm i/d Zero velocity valve rating PN 1.0 fixing on 800mm i/d DI K-9 pipe line including construction of manhole chamber complete in all respect on Engineer-in Charge

Reinforced cement concrete 1:2:4 with stone aggregate 20mm nominal size for thrust block bearing block and pipe and casing under roads including placing in position shuttering etc. complete in all respect.

Supplying and fixing of Sluice Valves, Kinetic air valves, Zero Velocity valves along with contingent material required for their fixing with pipes and specials complete in all respect as per specification and direction of the Engineer-in-charge of rating Pn 1.6 cc) Supplying and fixing of 150mm dia Kinetic Air Valve rating PN 1.6 with all piping for fixing on 800mm i/d DI K-9 pipe and Tee including construction of manhole chamber complete in all respect as per the specification and direction of Engineer-in-charge

SSupplying and installing 200mm i/d scour arrangement on 800mm DI K-9 pipes including cost of 200mm i/d sluice valve of IVC/Kirloskar make and all jointing tests and valves etc. and cost of construction of manhole chamber complete.

(i) Providing and Installation of Horizontal split casing pumps with squirrel cage induction electric motor including testing commissioning etc. complete in all respect. i) 255 lps with 35 M Head (200 BHP)

Providing and Installation of Horizontal split casing pumps with squirrel cage induction electric motor including testing commissioning etc. complete in all respect. i) 120 lps with 55 M Head (150 BHP)

Providing and Installation of Horizontal split casing pumps with squirrel cage induction electric motor including testing commissioning etc. complete in all respect. ii) 245 lps with 40 M Head (220 BHP)

lying and fixing openable anodized (15 micron) aluminium doors and windows

Supply and erection of street light luminaire minimum IP - 65/66 level protected single piece dia cast almunium / almunium sheet housing with pot optic reflector, heat resistant glass cover or HPSV lamp complete with copper wound blast capacitor complete. (iii) Sodium 250 W Street light luminator

Supply, Erection,testing and commissioning of Puffin 18W White Round Bright LED Panel Light Ceiling Downlight Lamp Kit with LED Driver Surface Mount LED Ceiling Light (Pack of 1)(2 Year Warranty Make:-Philips,Bajaj,GE,Wipro,K-lite,crompton greaves

Supplying and fixing of Sluice Valves, Kinetic air valves, Zero Velocity valves along with contingent material required for their fixing with pipes and specials complete in all respect as per specification and direction of the Engineer-in-charge of rating Pn 1.6 (aa) Sluice valve 800mm i/d including cost of chamber etc. complete. (Make IVC/Kirloskar)

Supplying fixing, testing and commissioning IVC make D.I recoil non return type zero valve having body in D.I to IS 1865 Gr. 400/15, Slant seat design, PN-1.6 rating flanges to be drilled as per IS: 1538 complete in all respect to the satisfaction of Engineer-in-charge.

Supply and placing in position coarse yamuna sand to be filled under road cuts to the satishfaction of the engineer-in-charge.

Supplying fixing, testing and commissioning M.S D/F pipe for scouring arrangement complete in all respects to the satisfaction of Engineer-in-charge. 250mm i/d

Providing and insertion of M.S Casing pipe (Fe-330 grade) fabricated as per IS : 3589 of 1991 from steel plates confirming to IS-2062 of following size including cutting, beveling grinding and radio graphically welding of pipes as per IS-1182 complete in all respect including cartage to site of work and testing. i) for 724 mm o/d M.S pipe 12 mm thick casing pipe.

A) for MBS Chandhat and Janacholi: i) 100 amp. TP E/o ACB equipment with 6no plus 6NC auxilary contacts, 240 volts. AC shur release, service position micro shitwch, 240 V Ac motor ACB will be horizontal draw out type. ii) Earth fault and over current relay of `LT-LK/CandS/BCH` 1 No. iii) automatic power factory connector relay of LT-LK VOMECH, 6 stages- 1 No. IV) 96x96 sqm, mm ameter digital type with 3 nos. CTs and selector switch of range 0-1000 Amp.-1NO. V ) 96x96 sqm voltmeter with volymeter selector switch (0-500v) digital type-1 No. vi) power capacitor bank of suitable rating to improve PF to 0.95 (Wheater one of three pumping opetion) 1 lot. vii) RYB LED indication lamp 1 set. viii) incoming and outgoing cable box-1lot. ix) busbar and suitable cross section for 100 AMPS. for phase and neutral on haif of cross area of main buster-1lot. incoming Feedar i) 4 pole, 400 amp. MCCB-3 Nos. ii) 96x96 sqm. ameter digital tupe (0-400 amp.) with 3 nos. CTs selector switch -3 nos. iii) RYB indicating lamps (LED) type-8set iv) 16 Amp. MCB for vaccum pump-2 nos. v) 16 Amp. MCB, for dewatering pump. vi) Dol starter-4 nos. vii) ameter (0.20 amp.) digital type - 4 nos. viii) 16 amp. MCB for lighting and auxiliary load-4 nos. x) soft starter for 110 KW motor- 3 nos.

Supply erection, testing and commissioning of 11KV panel complete as per DHBVN specifications as per approved NIT.

Supply and fixing VCB 24 volts as per DHBVN requirment complete in all respects as per approved. NIT.

Supply, erection, testing and commissioning of HT outdoor cable box XPLE 300 sqm complete in all respect in all respect as per DHBVN specification as per approved NIT.

Supply, erection, testing and commissioning of HT indoor cable box XLPE 300 sqm complete in all respect as per DHBVN specifications as per apporved NIT.

Supply, erection testing and commissioning of HT CT 20/5 amp. complete as per DHBVN specifation as per approved NIT.

Supply, erection testing and commissioning of 11 KV. PT complete as per DHBVN specification as per approved NIT.

Providing chemical earthing with cooper plate as per ISI specification as per ISI specification complete as per DHBVN requirement as per DHBVN NIT.

Supply, erection testing and commissioning of 11 KV gang operated air break switch conforming to ISS-2544/1963 with latest amendments suitable of 400 amp. HT load and fitted on the `H` pole complete the job in all respects upto the Engineer- in- charge as per approved NIT.,.

Providing and coating synthetic rubber polymer mixed with cement..,,

Supply and fixing Terra cota tile 25mm thick in wall facing (lining) on wall..

Cost of supply and erection of CFL/Tube light..

Supply and installation of KV 3.5 CORE LT cable 630 sqm. armoured with termination kit complete in all respects as per approved NIT....

(i) Providing and Installation of Horizontal split casing pumps with squirrel cage induction electric motor including testing commissioning etc. complete in all respect. ii) 390 lps with 30 M Head (260 BHP)

Providing and Installation of Horizontal split casing pumps with squirrel cage induction electric motor including testing commissioning etc. complete in all respect. ii) 260 lps with 30 M Head (175 BHP) or 130 lps with 55 M Head (175 BHP) as per site condition...........

Porv. and fixing of chequered plates 6 mm thick complete including cutting and welding etc..........

DNIT FOR CONSTRUCTION OF 4 NO RANNEY WELLS, LAYING OF RISING MAIN, CONSTRUCTION OF MBS AT VILLAGE CHANDHAT and JANACHOLI FOR AUGMENTATION IN WATER SUPPLY IN PALWAL and NUH ` Construction of MBS Janacholi, Pump House and UGT at Kondal MBS ,laying, jointing and commissioning 800mm i/d DI Pipe line from MBS Chandhut to MBS Janacholi and all other works contingent thereto`Operation and maintenance during defect liability period after 3 month trial run period (operation only)

1st year Operation and maintenance after defect liability period

2nd year Operation and maintenance

3rd year Operation and maintenance

4th year Operation and maintenance

5th year Operation and maintenance