Irrigation And Water Resources Department Tender

RAW WATER PUMP: SITC of Raw Water Horizontal Split Casing Type pumping sets minimum four (4) star rating duties coupled to AC squirrel cage indication type motor with 1440 RPM 3 Phase 50 Hz and accessories as described in schedule no II complete in all respect with priming arrangement with complete base farme as per approved DNIT. Motor pumping set for Raw water having head as per the indicated requirements of discharge in LPM and power capacity in BHP as per IS marked :- 2600 LPM 60 Mtr. Head 60 BHP

Supply , Installation, Testing and Commissioning of factory made 11 KV, 630 A, 20kA / 3 sec, Outdoor Extensible type IP54 for panel and IP67 for main circuits Ring main unit (RMU) IEC 62271-200 in suitable RCC foundation with 2 no. Load break switch and 1 no. VCB / SF6 circuit breaker with over load, Earth fault, short circuit relay, copper bus bar, bus support and insulation material epoxy resin, ring core protection and metering CT, Auxiliary relay for WTI, OTI ,Bucholz alarm and trip along with annunciator panel, master trip relay, mechanical ON / OFF / Earth indication, Voltage presence indicator, Shunt trip coil, 24 V DC power pack, Digital multi-function meter, with Bus PT panel with 3 Nos single phase voltage transformers of the ratio 11kV/v3 / 110 V/v3, 25 VA, Class 1.0 with HT fuses in the primary and MCB on the secondary side, Voltmeter with selector switch, R Y B phase indication, Anti reflex operating handle, right angle boots etc. OEM Must have BIS certificate and and shall have submit NABL / CPRI / ERDA lab type test reports before execution as required complete in all respect. All as per pre-approved by Engineer in charge. For additional technical parameters of products/ work, refer Annexure `A` attached with this BSR .

`NS Item -Panel Board - Supply, erection, testing and commissioning of floor mounted electrical LT Panel board, fabricated from 14 SWG CRCA sheet duly stouten with suitable angle iron framework and completely powder coated of suitable size having following items for Horizontal split casing pump set of suitable for 1 Nos. pumping set 2600 LPM with 60 Mtr. Head Horizontal split casing pump set and required accessories: - ` Cost of material as per market rates MCCB as incomer 100 Amp. 1 Nos. Contactor MNX 55 2 Nos. Contactor MNX 45 1 Nos. Over load relay 90-150 Amp. 1 Nos. Push Button red plus green 1 Set Indicator on Red 1 Set Indicator Trip Yellow 1 Set Control MCB SP 6 Amp 1 Nos. S/D timer 1 Nos. Ampere meter digital with 1 No. CT 1 Nos. Single phase preventer 1 Nos. Capacitor 20 KVAR 1 Nos. `Fabrication with Alu. Bus bar power and control wiring with copper wire, labour and margin Panel size 800 L x 2250 H x 600 D (mm)` 1 Job (Note: - All accessories should be design load of motor).