Haryana Urban Development Authority Tender

[23.22.5.1]MCCB ,DISTRIBUTION BOARDS, MCB`s, RCCB`s, CHANGE OVER etc. 5.1. Supply and erection of miniature circuit Breaker 240/415 V in the existing distribution board including making necessary connections:- 6 amp. to 32 amp Single Pole

[23.24.3.5]MS STAND, BUS BAR CHAMBER AND PANELS 3.5. Supply and erection of metal clad bus bar chamber made from 1.6 mm thick M.S. sheet and fixing with rag bolts on wall or on existing pedestal/angle iron frame including bonding, detachable top and bottom including painting and necessary connection etc. (Aluminium bars). 200 amp 4 bars of 55 cm each (cross section 38 mm x 6 mm) chamber over all size 60 cm x 45 cm x 18cm

[23.27.3]Supply and erection of Godrej Almirah typeM.S. pedestal made of 50 mm x 50 mm x 6 mm angle iron frame with 3.00 mm thick M.S. sheet covering including shutters with suitable hinges and locking arrangement with Godrej type handle including round bars . The top covering should have downward overhang of 75 mm on all sides of pedestal , having two sets of water proof ventilation holes of suitable size on the sides , at top and bottom , each set containing four Nos. holes to discharge the heat produced by the current . The shutters fixed with rubber gasket of superior quality and of suitable size to make it water proof . The pedestal duly painted both inside and outside with two coats of approved paint and primary coat and its legs are embeded upto the entire depth in 1:2:4 cement concrete block , projected 75 mm all around the pedestal and and 200 mm above the ground level including the cost of all labour and material required to complete the job in all respect upto the entire satisfaction of the Engineer-in-charge of the work:- 3. M.S. pedestal of size 750 mm wide , 1200 mm high ,300 mm deep and bottom totally open , duly embeded in cement concrete block of size 900 mm x 450 mm x 200 mm above ground level , having a base of size 1050 mm x 600 mm x 250 mm below ground level . 0 0

[24.1.1]EARTHING AND LIGHTENING ARRESTOR 1. Earthing with GL earth pipe 4.5 m long and 40 mm dia with masonry enclosures on the top etc. (but without charcoal or coke and salt) as required.

[24.1.2]EARTHING AND LIGHTENING ARRESTOR 2. Extra for using salt and char coal/coke for pipe earth electrode as required.

[24.1.8]EARTHING AND LIGHTENING ARRESTOR 8. Providing and fixing 25 mm x 3mm G.I. strip on surface or in recess for connections etc. as required with all labour and material.

[24.2.8.5]LT CABLE 8.5. Supply and erection of aluminium lugs heavy duty including crimping etc. up to the entire satisfaction of the Engineer-in-charge of the work. 25 sqmm

[24.2.8.7]LT CABLE 8.7. Supply and erection of aluminium lugs heavy duty including crimping etc. up to the entire satisfaction of the Engineer-in-charge of the work. 50 sqmm

[24.4.8.7]STREET LIGHT 8.7. Supply and erection of Hot Dip Galvanized octagonal pole of 3mm thickness, with base plate including cost of nut and bolts , earthing studs, Integral Cable termination arrangement 5 mm thick Bakelite base plate on suitable welded MS/GI bracket 32 A four way connector 2 no 10 A SP MCB , end cover and all accessories as supplied by the manufacture including Providing RCC foundation of M25 grade (1 Cement:1 Stone aggregate: 2 Coarse sand) i/c excavation, steel reinforcement (Fe 500) @80 kg/cum of concrete contents, concrete cover 50mm, anchor bolts etc. over a bed of PCC 1:5:10 of required dimensions for octagonal poles of various heights as per following specifications complete in all respects and as per directions of Engineer-in-charge 9 Metre Long pole with top dia 100 mm and bottom 200 mm with base plate of size 350 x 350 x 20 mm.

[24.5.2.3]MISCELLANEOUS ITEMS 2.3. S/E mark double walled corrugated (DWC) HDPE, pipe 10 Kg/Cm2 ,laid 0.75 Metre below ground level including digging and refilling of earth including cost of suitable size socket/coupler for HDPE pipe including the cost of labour and material required to complete the job in all respect up to the entire satisfaction of Engineer in charge of the work. DWC/HDPE pipe 63/50 mm outer dia/inner dia

Supply and erection of PCC pole as per IS: 1678-1960 specifications, 9 Mtr. long 105mm x 115mm at top and 105mm x 315mm at bottom with working load of 200 Kg. buried 1.80m in ground or as per UHBVNL specification.

Supply and erection of stay set for LT/HT Line complete in all respect with G.I. stay wire( rope of 7 wires of 8 SWG G.I. Wire), egg/Disc insulator , G.I. rod of 20mm dia 8’ long threaded up-to 250mm long with nut (weight 6.224 kg) with cross plate of 460mm of angle 65x65x6 mm(weight 5.33 kg), elbow (weight 2.24 kg ) complete with clamps , nuts and bolts complete in all respect up-to the entire satisfaction to Engineer-in-Charge of the work. LT Stay

Supply and erection of L.T. Aerial bunched cable of size 120 Sqmm, 4 core plus 95 Sqmm including making of necessary connection of make Polycab, Havell’s Grandlay, complete in all respect up to the entire satisfaction of Engineer-in-charge

Only Labour charges for ON/OFF operation of street light points of all type of LED lights, Removal of Fault of Circuits. Dismantlement and re-erection of LED fitting from S/L poles for replacement or repairing of LED lights under defect liability period. 2nd Year maintenance

Only Labour charges for ON/OFF operation of street light points of all type of LED lights, Removal of Fault of Circuits. Dismantlement and re-erection of LED fitting from S/L poles for replacement or repairing of LED lights under defect liability period. 3rd Year maintenance

Supply and erection of Prodigy type in-built L.T. C.T. meter of (40- 200 amps), 3-phase 415 Volts rating suitable for 3-phase, 4-wire system of make Secure, Genus or other make approved by the UHBVNL. The meter is to be fixed in M.S Sheet cubical meter box on existing PCC Pole. This includes all petty material i.e. M-Seal, Nut–Bolts, thimbles etc. Meter will be got tested from the UHBVNL lab by the contractor after depositing the meter testing fee by him and it will be refunded on production of receipt received from UHBVNL.

S/E of 200 Watt LED Flood light luminari of with multiple LED with highly efficient high power LED light with lens, pressure die cast aluminum housing, reflector and enclosed with toughened glass, IP-66 level as per specification attached. (With 3 years free replacement warranty at site including labour charges free of cost). (Make:- Philips /Bajaj/LT/Panasonic/Anchor)

Supply, erection, testing and commissioning of ELEX-TWS-2EXT / Amson’s/LandT make Automatic electric timer to switch ON/OFF the street light automatically. It should have adjustable lux level switch, with extensible mountable sensor. It shall change ON/OFF timing automatically as per lux level of the Sun at sun-rising and sun setting, throughout the year. Shall have two Nos. LandT make, 3 pole power contactor model MNX-70 to control 70 amp per phase with 220 Volt coils. It shall have auto/manual switch for repair of street light during day time. The whole unit components to be assembled on Bakelite sheet with 16 amp capacity MCB to save the time switch. The erection of the complete unit in the existing pedestal with complete wiring upto the entire satisfaction of the Engineer-in-charge. ON/OFF Timer

Supply and erection of Suspension clamp Dead end clamps and eye belts for sagging of 11KV XLPE Aerial Bunched cable suitable for 50sqmm x 3 core to 240 sqmm x 3 Nos complete in al respect upto the entire satisfaction of Engineer-in-charge of the work Suspension clamp 50sqmm to 240 sqmm

Supply and erection of Suspension clamp Dead end clamps and eye belts for sagging of 11KV XLPE Aerial Bunched cable suitable for 50sqmm x 3 core to 240 sqmm x 3 Nos complete in al respect upto the entire satisfaction of Engineer-in-charge of the work Eye bolt 50sqmm to 240sqmm

Supply and erection of round type hot dip galvanized bracket of 0.75 mtr radios made out of 50 mm dia G.I. Pipe and canopy of size 0.6 mtr long made out of 125 mm dia G.I. Pipe complete with all labour , nut and bolts and all other petty items on existing octagonal / M.S. Pole complete in all respect up to entire satisfaction of the Engineer-in-Charge of the work. ( EXCUDING GST)

Supply and erection of PVC insulated and sheathed twin core flat or three core round cables 1100 volts each core having single solid aluminium conductor service cables as per IS: 694, of complete in all respect up to entire satisfaction of the Engineer-in-Charge of the work. (Excluding GST). 2.5 Sqmm x 3-core Make- Havall's/Polycab/Grandlay

Supply and erection of 63 Amps connection plate for incoming and outgoing cable in existing Panel/High Mast/Octagonal Pole etc. to be fitted with connector fixed on Bakelite sheet complete with nut and bolts.

S/E of 300 Watt LED Flood light luminaries with multiple LED with highly efficient high power LED light with lens, pressure die cast aluminum housing, reflector and enclosed with toughened glass, IP-66 level having more than 120 Lumens/watt complete in all respect, as per specification attached. (With 3 years free replacement warranty at site including labour charges free of cost). (Make:- Philips /Bajaj/LT/Panasonic/Anchor)

Credit of M.S. Scrap of old M.S. items such as damaged street panel, old dismantled M.S. angle/channel/flat, old steel tubular poles including dismantlement charges including TandP charges etc. (without GST)

Credit of old (8-10 years) 150w / 250w sodium light fittings including dismantlement charges for dismantlement from existing STP/Octagonal pole etc.. (Without GST)

Credit of old (8-10 years) HPSV 2x250W flood light fittings including dismantlement from existing Pole/High Mast complete. (Without GST)

Supply and erection of Single arm over-hang galvanized iron bracket having 125 mm top dia B-class canopy 0.60m long and each arm of length 2000 mm, made out of 50mm dia B-class G.I. pipe including 150 mm long nipple for LED Fitting if required making an angle of 15° with horizontal plane including all labour and material complete in all respect upto the entire satisfaction of Engineer-in-Charge. ( Excluding G.S.T. )

Supply and erection of PVC insulated and sheathed underground cable, loose in existing pipe or trenches 1100 volts core having solid aluminium conductor wires confirming to IS: 694:2010, including making necessary connections complete in all respect up to entire satisfaction of the Engineer-in-Charge of the work. Cable Size: 16 Sqmm x 4-core (Armd.). Make: Grandlay/Polycab/Havell`s. (Without GST)

Supply and erection of 120 watt LED Street light luminaire with multiple highly efficient and high power LED light with individual lens, pressure die cast aluminum housing with heat sink and aluminum extrusion, with secondary optics and enclosed with toughened glass, IP-66 level, having 120 lumens/watt, with 3 years defect liability period (on site replacement) free of cost, complete in all respect up to the entire satisfaction of Engineer-in-charge of the work. Make:- Philips/Bajaj//LT/Panasonic/ Anchor - (Rate without GST)

Supply and erection of 120 watt LED Flood Light luminaire with multiple highly efficient and high power LED light with individual lens, pressure die cast aluminum housing with heat sink and aluminum extrusion, with secondary optics and enclosed with toughened glass, IP-66 level, having 120 lumens/watt, with 3 years defect liability period (on site replacement) free of cost, complete in all respect up to the entire satisfaction of Engineer-in-charge of the work. Make:- Philips/Bajaj//LT/Panasonic/ Anchor - (Rate without GST)

Supply and erection of FR, PVC insulated and sheathed underground cable, loose in existing pipe or trenches 1100 volts core having solid aluminium conductor wires confirming to IS: 694:2010, including making necessary connections complete in all respect up to entire satisfaction of the Engineer-in-Charge of the work. Cable Size: 50 Sqmm x 4-core (Armd.). Make: Grandlay/Polycab/Havell`s. (Without GST)