Haryana Urban Development Authority Tender

23.22.1.3 Supply and Erection of Modular case circuit breacker single pole/4 pole on existing wall/pedestal/Panel including bounding to earth and making necessary connections required to complete the job in all respect up to the entire satisfaction of the Engineer-In-Charge of the work. Triple pole MCCB 16 to 100 amp. 25 KA

23.22.5.1 Supply and erection of miniature circit breaker 240/415 V in the existing distribution board including making necessary connectiosn. 6 amp. to 32 amp. single pole

23.27.1 Supply and erection of Godrej Almirah type M.S. pedestal made of 50 mm x 50 mm x 6 mm angle iron frame with 3.00 mm thick M.S. sheet covering including shutters with suitable hinges and looking arrangement with Godrej type handle including round bars. The top covering should have downward overhang of 75 mm on all sides of pedestal, having two sets of water proof ventilation holes of suitable size on the sides, at top and bottom, each set containing four Nos. holes to discharge the heat produced by the current. The shutters fixed with rubber gasket of superior quality and of suitable size to make it water proof. The pedestal duly painted both inside and outside with two coats of approved paint and primary coat and its legs are embedded upto the entire depth in 1:2:4 cement concrete block, projected 75 mm all around the pedestal and 200 mm above the ground level including the cost of all labour and material required to complete the job in all respect upto the entire satisfaction of the Engineer-in-Charge of the work. M.S. pedestal of size 600 mm wide, 750 mm high, 300 mm deep and bottom totally open, duly embedded in 1:2:4 cement concrete block of size 750 mm x 450 mm x 200 mm above ground level, having a base of size 900 mm x 600 mm x 250 mm below ground level.

Job Work Supply and erection, testing and commissioning of ELEX-TWS-2EXT/Amson’s make Automatic Electric Timer to switch ON/OFF the street light/ road light automatically. It should have lux level adjustable switch, with extensible mountable sensor. It will change ON/OFF timing automatically as per lux level of season throughout the year as purchase in the timing of sun-rising and sun setting suitable for street/road light. It will have three Nos. L&T make, 3 pole power contactor model MNX-25 to control 25 amp. Per phase with 220 volt coils. It will have auto/manual switching mode for repair of street light during day time and the whole unit fixed on Bakelite sheet to assemble the components etc. the erection of the complete unit in the existing pedestal with complete wiring upto the satisfaction of the Engineer-in-Charge (Excluding GST).