Haryana Urban Development Authority Tender

[23.22.5.1]MCCB ,DISTRIBUTION BOARDS, MCB`s, RCCB`s, CHANGE OVER etc. 5.1. Supply and erection of miniature circuit Breaker 240/415 V in the existing distribution board including making necessary connections:- 6 amp. to 32 amp Single Pole

[23.27.2]Supply and erection of Godrej Almirah typeM.S. pedestal made of 50 mm x 50 mm x 6 mm angle iron frame with 3.00 mm thick M.S. sheet covering including shutters with suitable hinges and locking arrangement with Godrej type handle including round bars . The top covering should have downward overhang of 75 mm on all sides of pedestal , having two sets of water proof ventilation holes of suitable size on the sides , at top and bottom , each set containing four Nos. holes to discharge the heat produced by the current . The shutters fixed with rubber gasket of superior quality and of suitable size to make it water proof . The pedestal duly painted both inside and outside with two coats of approved paint and primary coat and its legs are embeded upto the entire depth in 1:2:4 cement concrete block , projected 75 mm all around the pedestal and and 200 mm above the ground level including the cost of all labour and material required to complete the job in all respect upto the entire satisfaction of the Engineer-in-charge of the work:- 2. M.S. pedestal of size 750 mm wide , 900 mm high , 300 mm deep and bottom totally open , duly embeded in cement concrete block of size 900 mm x 450 mm x 200 mm above ground level , having a base of size 1050 mm x 600 mm x 250 mm below ground level.

[24.2.8.3]LT CABLE 8.3. Supply and erection of aluminium lugs heavy duty including crimping etc. up to the entire satisfaction of the Engineer-in-charge of the work. 10 sqmm

[24.2.8.5]LT CABLE 8.5. Supply and erection of aluminium lugs heavy duty including crimping etc. up to the entire satisfaction of the Engineer-in-charge of the work. 25 sqmm

[24.5.2.2]MISCELLANEOUS ITEMS 2.2. S/E mark double walled corrugated (DWC) HDPE, pipe 10 Kg/Cm2 ,laid 0.75 Metre below ground level including digging and refilling of earth including cost of suitable size socket/coupler for HDPE pipe including the cost of labour and material required to complete the job in all respect up to the entire satisfaction of Engineer in charge of the work. DWC/HDPE pipe 50/40 mm outer dia/ inner dia

[24.5.2.3]MISCELLANEOUS ITEMS 2.3. S/E mark double walled corrugated (DWC) HDPE, pipe 10 Kg/Cm2 ,laid 0.75 Metre below ground level including digging and refilling of earth including cost of suitable size socket/coupler for HDPE pipe including the cost of labour and material required to complete the job in all respect up to the entire satisfaction of Engineer in charge of the work. DWC/HDPE pipe 63/50 mm outer dia/inner dia

[4.12.1]Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead up to 50 m and lift up to 1.5 m, as directed by Engineer-in-charge. 1. All kinds of soil

[6.1.2]Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work below plinth level and up to Floor IV level: 2. 1:2:4 (1 cement : 2 coarse sand (zone-III) : 4 graded stone aggregate 20 mm nominal size)

[6.16]Reinforced cement concrete work in beams, suspended floors, roofs having slope up to 15° landings, balconies, shelves, chajjas, lintels, bands, plain window sills, staircases and spiral stair cases above plinth level up to floor four level, excluding the cost of centering, shuttering, finishing and reinforcement with 1:1.5:3 (1 cement : 1.5 coarse sand(zone-III) : 3 graded stone aggregate 20 mm nominal size).

[6.33.6]Steel reinforcement for R.C.C. work, where not included in the complete rate of RCC, including straightening, cutting, bending, placing in position, binding, wastage, overlaps, welded joints, spacer bars, chairs, stays, hangers and annealed steel wire etc. complete in all respect below plinth level 6. Thermo-Mechanically Treated bars of grade Fe-500D or more.

[6.9.1]Providing and laying damp-proof course with cement concrete 1:1.5:3 (1 cement : 1.5 coarse sand (zone-III): 3 graded stone aggregate 20mm nominal size) 1. 50 mm thick

[7.20.1]Brick work with common burnt clay modular bricks of class designation 10.5 in foundation and plinth in: 1. Cement mortar 1:4 (1 cement : 4 coarse sand)

Supply and Erection of decorative pole 4M height Linear pole with 114mm withthickness 3mm dia 76mm with PU paint. Base plate having 200x 200mm with anchor bolt with having door above 500mm from base with 4 way connector and 16amp mcb standard wire. Make-Kesslec

Supply, Installation, Testing and Commissioning of decorative post top LED light having width 570 and height 606mm Lumantix -P 50W NW 110lm/W With IP 66 CRI 70 led life cycle 50000 burning hour IK 07 fixture made of with casted aluminium canopy is corrosion resistant diffusser is made of PMMA total no of led in fixture 16NOS complete in all respect upto the entire satisfaction of engineer incharge of the work Make-Kesslec

Supply and erection of pole foundation of size (0.45 X 0.45 X 1)Mtr. with reniforcement 12Nos. 12mm TMT bars and 6 rings of 8mm TMT bars and all other works including binding/wastage complete in all respect upto the entire satsisfaction of Engineer in charge of the work.

Supply and erection LT Cables of various size armored cable with all necessary connection complete in all respect upto entire satisfaction of Engineer-In charge. Make-HAVELLS/KEI /Polycab/Grandly. 10 sqmm x 4 Core (A)

Supply and erection LT Cables of various size armored cable with all necessary connection complete in all respect upto entire satisfaction of Engineer-In charge. Make-HAVELLS/KEI /Polycab/Grandly. 25 sqmm x 4 Core (A)

Supply and erection of 15W high-efficiency circular horn loudspeaker, High-efficiency driver, Water and dust protected to IP 65, Max. Power: 22.5W, Power tapping: 15 / 7.5 / 3.75 W, SPL at 15 W (1kHz,1m): 115 dB, Frequency response: 500Hz-5kHz, Rated impedence: 1667 ?, Opening angle at 1kHz/4kHz(-6dB): 130° H x 50° V, IP 65 rating Horn Speakers for Outdoor. Make-BOSCH, Model-LBC3470/00

Supply, Installation, Testing and Commissioning of 480 W power amplifier, Temperature controlled forced front to back ventilation, Directly stackable, Mains, battery back-up and pilot tone supervision, Dual inputs with priority switching, loop-through facility, Multiple outputs-70V/100V and 8/4 ohm, 24VDC power supply, Overheat protection, Frequency response: 60Hz-18kHz, Distortion ( 1 %, S/N ratio ) 65 dB, Sensitivity: 1V, 3-pin XLR connector. Make-BOSCH, Model-LBD1938/00

Supply, Installation, Testing and Commissioning of Digital Signal processor with 12 mic/line analog inputs with 12 AEC, 8 analog outputs, USB audio for integrating with PC soft VC, 64x64 channel Dante conenctivity, Rj-11 for telephone system, sampling rate: 48KHz or better, processor : 32-bit floating point, Digital Dante network audio, Frequency Response 20 Hz to 20kHz, THD plus N: 0.002, Channel Separation (Crosstalk) ( -105 dB, Dynamic Range ) 110 dB, Safety: UL60065, CE, FCC compliance and for third Party integration complete with standard accessories as required. Make-Bose 1280C

Supply and erection of 2 core 2.5 Mic Cable comlpete in all respect upto entire satisfaction of Engineer-In-Charge.

Supply and installation of Equipment Rack for housing all rack mountable equipments with internal wiring, front glass door: heat dessipation fans: movement wheels, power distribution units etc. Make-Custom

Supply, Installation, Testing and Commissioning Digital Headwon wired Microphone with 3/4` back electret condenser, Polar Patterns Super cardioid, Audio frequency bandwidth 20 -  20000 Hz Equivalent noise level 21 dB-A Sensitivity 4 mV/Pa Voltage 48 V plus /- 4 V Current 3 mA with Balanced XLR 3 Pin pattern. Make- AKG C7/ Harman.

Supply, Installation, Testing and Commissioning of 320 mm wide, this DVD player is the perfect addition to your Home Theatre setup. With multi -format support—including DVD, CD -R/RW and MP3—and the option to connect and play content via USB. Make-Sony Playback 

Supply and installation of Stainless steel enclosure for cover on existing pole the horn loudspeaker with all required accessories and painted etc. Make-Custom

Operation of music system complete in all respect with labour and material (2 plus 2 hours morning/evening operation of music) i.e Amplifier, Booster, Speakers, Audio Spliter, DVD player and cable etc complete in all respect for 48 months.

Dismantlement and re-erection of 4 mtr. long GI pole with bracket and LED street light fitting complete in all respect upto the entire satisfaction of Engineer-in charge.

Providing and fixing of chemical earthing with 3 mtr. long 75 mm dia G.I pipe complete in all respect upto entire satisfaction of Engineer-in-charsge of the work.

Supply and erection of 2 core 1 .5 Sqmm Armoured Speaker cable Make-Krystal with necessary connections and lugs comlpete in all respect.