Directorate Of Urban Local Bodies Tender

Supply & Erection of shackle insulator along with nut & bot as per site requirement.

Supply & Erection of GI bracket pipe made of in 1.5 inch Dia pipe 2’ x 1’ welded at 135 degree as per required design and drawing.

Supply & Erection of MS clumps made of 40mm x6mm flat as per drawing including welding making holes along with nut &bolt of required &length.

Miniature Circuit Breaker and isolator S/E of miniature circuit breaker/isolator 240/415 V in the existing distribution board including making necessary connection. Miniature circuit breakers of 9KA breaking capacity SP MCB of 9 KA breaking capacity 6 amp. to 32 amp PWD Approved

Supply and erection of moulded case circuit breakers on wall or on existing pedestal including bonding to earth and necessary connections. 100 amp.to 200 amp. 415 V ,10 KA 3-phase. PWD Approved

Earthing of poles complete as per HSR 31.22 (I &II)

Sheet steel enclosures S/E of double door sheet steel enclosures distributes boards suitable for MCBs and ELCBs etc. recessed in wall including bonding to earth with all labor and material required to complete the job n all respect up to entire satisfaction of Engineer-in-charge of work SPN distribution board 8-way.

Pedestal. supply & Erection of Godrej Almirah type M.S. Pedestal made of 50 mmX50mmX6mm angle iron frame with 3.00 mm thick M.S. sheet covering including shutters with suitable hinges and locking arrangement with Godrej type handle including round bars. The top covering should have downward overhang of 75mmon all sides of pedestal having tow sets of water proof ventilation holes of suitable size on the sides, at top and bottom each set containing four nos. holes to discharge the heat produced by the current fixed with rubber gasket of superior quality and of suitable size to make it water proof the pedestal duly painted both inside and outside with two coats of approved paint and primary 75mm all around the pedestal and 200 mm above the ground level including the cost of all labor and material required to complete the job in all respect up to the entire satisfaction of the engineer in charge of the work. M.S. pedestal of size 750mm wide 1200 mm high 300 mm deep and bottom totally. Open dully embedded in cement concert block of size900mmX450mmX200mm ground level duly plastered with 12 mm thick 1:4 cement plaster having a base of size 1050mmX600mmX250mm below ground level. S/E of PVC unsheathed copper conductor cable single core 1100 volts grade in pipe of suitable size excluding cost and erection of pipe size 2.50 sq. mm (3/1.05mm) Sheet steel enclosures S/E of double door sheet steel enclosures distributes boards suitable for MCBs and ELCBs etc. recessed in wall including bonding to earth with all labor and material required to complete the job n all respect up to entire satisfaction of Engineer-in-charge of work TPN distribution board 4-way. N.S. ITEMS S/E of LED flood light luminaries of Crompton make pressure dia case housing with IP-65 protection, efficient high out put emitter LED LSFO-120 CDL, BARFEG 120 W LED Bajaj make and equivalent model of philips including the cost of all accessories and necessary connection of the same up to the entire satisfaction of Engineer in charge of the work. S/E testing and commissioning of Crompton greaves/Phillips/Bajaj Make motorized high Mast 12 mtr. Height on suitable RCC foundation with mobile lantern carriage and essential accessories including gear box and component suitable up to 9 luminaries wit its control panel for raising and lowering of lantern carriage system associated with sheathed traveled cable with 3 wires rope system with three sections without circumferential weld in mast section. The mast shall be fabricated from special steel plates conforming to BSEN10025 to BSEN10025 FE 510C all holding bolt should be hot dip galvanized to BS 729. The dimensions of top section base dimension door opening and base be as per the standard size/ design of manufacturing company. The mast should be suitable to with stand minimum wind pressure at the wind speed for 180km/Hr. the raising and lowering mechanism for the lantern carriage shall incorporate with winch double drum type head frame stainless steel wire internal electrical cable on no. aviation obstruction light on o. lighting arrester including reversible induction motor power tools/integralCrompton Greaves/Bajaj/Phillips brand with provision of operation of lowering/ raising of lantern carriage of make the above system functional. The induction motor should 3 phase kirloskar or equilent ISI make 415 V 50 he having B class insulation with weather resistant IP 55 protection and other required controlling device to operate motor with all accessories including cost of suitable foundation for mast as per soil bearing capacity at site. The mast should be complete in all respect including the cost of all labor and material required to complete the job in all respect upto the entire satisfaction of Engineer-in-charge of work complete high mast will be as per ISI standard. M.S.pedestal of size 750 mm wide , 1200 mm high ,300 mm deep and bottom totally open , duly embeded in cement concrete block of size 900 mm x 450 mm x 200 mm above ground level duly plastered with 12 mm thick 1:4 cement plaster , having a base of size 1050 mm x 600 mm x 250 mm below ground level .

Supply & Erection of LED street light 72 watt as per policy framed by DULB on dated 15-02-2017. The LED make and model will be decide by the CMC.

S/E & Commissioning of Timelite-32A 3 pol3/230 V-Astronomical, INDOASIAN make time switch or AMSON’s make automatic timer ON/Off the street light on different fixed timing main tenable on street light, in pedestal/pillar/wall wiring connection on/off three contractor 25 amp. rectifier system, switching system backlight connector 30 amp. auto/manual system fiber sheet and plastic component wiring and component fittings testing and commissioning at site complete in all respect include the job with all material.

Supply & Erection of PVC 3 core AI wire 2.5mm completed with making necessary connections with main street light line of PWD approved make.

For arranging Electric Connection from UHBVN including all charges Single Phase

Add Contingency