Faridabad Smart City Limited Tender

`Design, Supply, Erection, Testing and Commissioning of 11 KV, 3 phase, 50 cycles, 6 Way, Non-extensible (1 incoming, 5 outgoing) outdoor type totally enclosed metal clad SF 6 insulated Vacuum circuit breaker switch-gear having Rating of 630A, 21KA for 3 sec, SF 6 insulated, Motorized, Outdoor, type tested in line with latest IEC62271-200 standards. The RMU shall be suitable for operations at a height up to 1000 meters above sea level and at 40 degree ambient temperature without any derating. The switch-gear and bus-bar shall all be contained in a stainless steel enclosure filled with SF 6 at 0.3 bar (300 hPa) relative pressure. The RMU tank shall provide full insulation, making the switch-gear insensitive to the environment with degrees of protection of IP67 . The switch-gear operating mechanism shall have an IP3X protection. Accidental over-pressure due to an internal arc is limited by the opening of the safety valve, at the bottom of the metal enclosure, away from the operator. An operator situated in front, lateral (A-FLR 21kA – 1 sec, downwards exhaust, for tank as well as cable compartment) of the RMU switchboard during an internal fault will not be exposed to the effects of arcing. Internal Arc Type Test Report for IAC AFLR 21 kA for 1 sec for both tank and cable box. Plug in type of extensibility must be provided and coupling bus-bar should not be exposed to air to avoid oxidation of bus-bars. Extension of cubicle should only require 450mm to handle and the gap between the coupled RMUs must be within 10mm. All operations shall be from front of the RMU, including access to cable bushings. Cable bushings along the sides or the rear of the RMU are not acceptable. The connected devices shall be as specified. Manufacturers shall ensure to use same make Vacuum Interrupters and Vacuum Circuit breakers 6 Way (1 incoming , 5 out going ) outdoor type totally enclosed metal clad SF 6 insulated Vacuum circuit breaker have following standard electrical and mechanical datas Vacuum circuit breaker module with vacuum circuit breaker, three position isolator/earthing switch, bus-bars, interlocking, earth-bar and stored spring energy mechanism. Vacuum circuit breaker 11kV, 630A, 21kA for 3-sec 1 Microprocessor base Numerical type self powered relays with O/C and E/F protection – CSPR V5 relay. 1 Set of 3 Ring Core Protection CTs 2.5VA Class 5P10 - Ratio as per load requirement at site. 1 Cable bushings 400 series bolted 1 Capacitive voltage indication fixed type VPIS 9-15 kV Air insulated cable module 11kV, 630A, 21kA for 3-sec Manual operating handle Air Insulated Metering panel shall includes: i) Potential transformer - 11 kV/rt3/110V/rt3/110/rt3, Cl. 0.5, 50VA, 3P, 50VA ii) Battery - 12V DC, 12AH - 2 Nos., Battery Charger - 24V, 10A - 4k protection - 1 No. iii) Trivector Meter - 5 No.

`Supply, installation, testing and commissioning of outdoor type 2000 KVA Compact Package Substation, “Non walk in type” fabricated by GI Steel shall house having modular construction of Galvanized Sheet Steel. The Enclosure shall have IP54 degree of protection for HT and LT switch-gear compartment and IP 23 degree of protection for Transformer compartment. CSS shall be tested for IAC AB for 20kA for 1 sec. The enclosure exterior shall be painted with powder / polyurethane paint. Enclosure should have slant roof suitable to avoid water. Each compartment will be provided with the door and pad locking arrangement. The Compartment illumination lamp with door operated switch shall be provided for each compartment,including PCC foundation at the height of 3 m as recommended by manufacturer have following equipment : (a) HT Switch gear (Type : LK plus M): 01 Nos. 11KV,630 amps, 20 KA, SF 6 Gas Insulated Non -extensible type swithgear type LK plus M consisting of 1 Nos fixed motorized vacuum circuit breaker with microprocessor based and one number Air insulated Metering module, Inter connection between HT switch-gear and transformer shall be used 1C x 3x 95 sqmm aluminum unarmored XLPE cable. 1 No - V : Vacuum circuit breaker 12kV, 630A, 21kA 1 No - Stored energy mech for manual operation. 1 No - Bushings for connection of external Bus-bar 1 No - Bus-bar cover for module right side for M-module 1 No - Self powered Microprocessor based over current and earth fault protection relay with RS - 485 port , 3 set - - Ring core Dual mode CTs Consisting of 100-50/ 1-1 A, 2.5 VA, 1 for metering and 5P10 for protection 1 No - Multi-function meter 1 No Cable bushings 400 series bolted, Arc proof cable cover complete including interlocking 1 No Capacitive voltage indication fixed type VPIS 9-15 kV,1 No - Breaker on (Red) / Off (Green) / Trip (Amber) indication RMU shall be tested for IAC AFLR for tank as well as cable compartment for 1 sec. (b) Metering M is an air insulated metering module. 01 No - M : Air insulated metering module 12 kV, 630A, 21 kA 03 Nos - Bushings for connection of external bus-bar 01 No - 3 voltage transformers 11KV / v3 / 110 / v3, 50 VA, class 1.0 with HV fuse on primary side and MCB on secondary side.01 No - Digital Voltmeter.01 No - Bus-bar cover 01 No - Space beater with thermostat.01 No - Illumination lamp.01 No - R Y B Phase Indication. (c ) 2000 KVA Transformer: 200 KVA, 11/33KV, AN, Oil Type Transformer hermetically sealed confirming to IS:1180 (Part-1) 2014 with corrugated fins with corrugated off circuit tap links of rating plus 5 to - 5% @2.5 %.by means of hand operated off load tap changing gear 2000 kVA capacity transformer copper wound step down outdoor type 11000/433 Volt(at no load) double wound oil immersed naturally cooled with external cooling tubes directly welded to tank core type delta connected on primary side (HV) and star connected on secondary side(LV) in accordance with vector symbol Dyn-II with neutral brought on secondary side (LV side) and having tapping at plus /- 5% on HV side, the maximum temperature rise should not exceed 45 degree centigrade in oil and 55 degree centigrade in HV/LV winding when measured by resistance method after continuous full load run in ambient temp of 40 degree centigrade and the transformer shall be losses as per 1180 Level-2.

Supply and Laying, jointing testing and connecting XLPE insulated, screened, PVC bedded, galvanized steel strip or wire armored, electric power cable (heavy duty) with multi-stranded aluminum conductors, 11 KV grade, of size 3 core, 300 sqmm IS 7098 marked, suitable for HT 11 KV (E) system, laid in trenches/ducts/ encased in GI pipe / fixed to pole, including jointing and testing complete all as specified and directed. Makes:- National, Havells, KEI, Polycab or any other DHBVN approved make.

`Providing and laying HDPE pipe 160 mm dia PE-63 PN-4 (For laying cables as mentioned at serial no 1and2) and bring the site in its original position, upto the entire satisfaction of engineer-in-charge. Make:- Flexi-flow, Flow-well, finolex, Duraline or any other DHBVN approved make.`

Material and labour for Cable jointing kit for 11 kV Earthed grade cable for Indoor termination heat shrink type joint complete with jointing material and accessories suitable for XLPE armoured aluminum conductor cable of size 300 sqmm, complete all as specified and directed.

Supply and Erection of GI Strip 25x6 mm, 9 mtr long for earthing

Supply and Erection of 1000 kVA, 3 phase, 11kV/433-250V oil immerse, naturally cooled copper wound outdoor type distribution transformer as per latest Nigam technical specification with amendment relevant ISS with latest amendments.

Supply , Installation , Testing and Commissioning of 125kVA/100KW 3 phase Mahindra CPCB II compliant Gas Genset, Prime Rated, radiator cooled, powered by Mahindra 7.2 L mPower engine coupled with125KVA Leroy-Somer /CG OR Equivalent electric alternator, microprocessor-based Controller, Silencer, Anti-Vibration mountings, exhaust flexible connector, Batteries with cables, Acoustic Enclosure. Note: Rcc foundation of DG sets ,Power cable,Control cable,Gas piping after gas meter,Earthing ,Cable terminations cost are inclusive with complete in all respect with all required accessories in our offer. Overall dimensions of Genset : LxWxH = 3750x1300x1700 mm

Lightening Arrestor Complete Set (9 KV, 5 KA)