Directorate Of Urban Local Bodies Tender

Supply and erection of Decorative Mini High Mast Fixture Brix 400 watt IP-65, Total height of the GI pole is 9 meter lower part of the pole is having 140 mm dia with 4.3 mm thickness height 3meter. Base plate having 400*400*20mm thick elliptical shape service window having loop in loop our 4way connector 40 amp suitable for 10Sqmm wire with 6amp single pole MCB, middle part of the pole having 114mm dia with 4mm thickness height 3 meter. top part of the pole having 90mm dia with 3.7mm thickness height 3 meter. At the bottom of pole there is a cast iron base having dia 260mm and height of base is 220mm. decorative cast iron/aluminum casting are used at the joint of pole. Pole & decorative casting parts are PU panted in three layers coating in which 1st layer with ETCH primer, 2nd layer with EPOXY primer and 3rd final layer with PU paint, light fixture is made of cast aluminum housing having width of 700mm and height of the fixture is 270mm. light fixture is suitable for 350w(As per drawing). LED is mounted on MCPCB with single piece lens on 12 led. T2 lens is used for wide distribution of light fixture is IP65. including Hydra, labour & material required to complete the job in all respect upto the entire satisfaction of Engineer - In - Charge of the work. Make- As per PWD B&R Approved.

Cost of RCC 1:1.5:3 for foundation of size 700x700x1500mm include base with suitable reinforcement 1200x1200x300 with with minimum 8 nos. 12 mm dia longitudinal MS reinforcement rods with rings of 4nos 8 mm dia manufacturing from special steel along with nuts, washers, anchor plate & template all labour & material required to complete the job in all respect upto the entire satisfaction of Engineer - In - Charge of the work.

Providing trench less cuttting by Hydraulic Drilling Device boring/ Manual OR through some suitable alternate method with insertion of HDPE Pipe including supply, Delivery of HDPE pipe at work site and laying of 50mm internal diameter HDPE pipe inside road for road corssing of cable by Hydraulic Drilling Device without opening of the road top surface, laid at a depth of at least 900mm below the road surface from the feeding point to the feeder pillar box in median (OR) from feeder pillar to respective street light pole including cost of all accessories for road crossing for laying of cables.