Bhagat Phool Singh Mahila Vishwavidyalaya Tender

Dismantling old plaster or skirting raking out joints and cleaning the surface for plaster including disposal of rubbish to the dumping ground within 50 metres lead.HSR:-5.45 + 15 mm cement plaster on the rough side of single or half brick wall of mix : 1 :4 (1 cement: 4 fine sand). HSR:- 11.6.1 .

Providing and applying two coats white cement based putty of approved brand and manufacturer, over plastered surface and grinding the surface smooth with sand paper to get en even and smooth finish including cost and carriage of all material , labour charges, scaffolding, sundries etc. complete. HSR:-11.58

Painting with synthetic enamel paint of approved brand and manufacture of required colour to give an even shade : HSR:-30.28.1 One or more coats on old work

Renewing glass panes and refixing existing wooden fillets: HSR:-30.56.2 Float glass panes of nominal thickness 5 mm (weight not less than 12.5kg/sqm)

Supply & fixing Windows frames (Chowkhats) including mullions consisting frame fabricated from sheet roll formed out of 1.2mm thick galvanized sheet as per IS:277 (Base steel as per IS 513) with zinc of 120 gm/sqm & Powder coated with pure Polyester powder up to 50 microns (as per approved colour), 3 Nos. 100mm butt - hinges 2mm thick, 6 Nos. 1.2mm thick CRCA electroplated stiffner, 6 Nos. M.S hold fast with split and tail welded to stiffner plate 200mm long, receiver for aldrop, weld less corner assembly with brackets & screws, M.S tie rod 50mm x 25mm to be fixed at bottom finished with powder coated total thickness of coating 0.6mm of approved shade, fixed in position including the cost of cement concrete for 1 :2:4 for fixing lugs complete in all respects as per drawing, design, specification & entire satisfaction of Engineer-in-charge. HSR:-13.21.1 Door Frame of size 80mm x 50mm with 37mm wide single rebate for 35 mm door shutter.

Providing and fixing glazed shutters for doors, windows and clerestory windows using 4 mm thick float glass panes, including ISi marked M.S. pressed butt hinges bright finished of required size with necessary screws.Kiln seasoned and chemically treated Hollock wood HSR:-12.10.2.1 35 mm thick

Providing and fixing wire gauge shutters using galvanized M.S. wire gauge of average width of aperture 1.4 mm in both directions with wire of dia 0.63 mm, for doors, windows and clerestory windows with hinges and necessary screws: 35 mm thick shutters HSR :-12.19.1.2.2 Kiln seasoned and chemically treated Hollock wood.

Providing and fixing ISi marked flush door shutters conforming to IS : 2202 (Part I) non-decorative type, core of block board construction with frame of 1st class hard wood and well matched commercial 3 ply veneering with vertical grains or cross bands and face veneers on both faces of shutters:HSR:-12.37.1 35 mm thick (for cupboard) including ISi marked nickel plated bright finished M.S. piano hinges with necessary screws.

Providing & fixing fly proof wire gauze to windows, clerestory windows & doors with M .S. Flat 15x3 mm and nuts & bolts complete. HSR:-13.9.2 Stainless steel (grade 304) wire gauze of 0.5 mm dia wire and 1.4 mm aperture on both sides

Providing and fixing 1st quality ceramic glazed wall tiles conforming to IS:15622 (thickness to be specified by the manufacturer), of approved make, inall colours, shades except burgundy, bottle green, black of any size as approved by Engineer-in-Charge, in skirting, risers of steps and dados, over 12 mm thick bed of cement mortar 1 :3 (1 cement : 3 coarse sand) and jointing with grey cement slurry@ 3.3kg per sqm, including pointing in white cement mixed with pigment of matching shade complete. HSR:-10.62

Providing and laying Baroda Green marble stone 17mm and above thick in risers of step, skirting , dado, pillars and wall lining included matching the grains of marble slab in any pattern as specified laid over 12mm thick cement sand mortar 1 :3 and jointed with white cement slurry mixed with pigment to match the shade of marble including rubbing and polishing. The rates are for all heights / storey. The sample shall be got approved from Engineer In Charge. HSR:-10.47

Providing and fixing of Kota stone slab flooring over 20 mm (average) thick base laid over and jointed with grey cement slurry mixed with pigment to match the shade of the slab, including rubbing and polishing complete with base of cement mortar 1 : 4 ( 1 cement : 4 coarse sand) HSR:-10.37.3 25 mm thick

Providing and fixing water closet squatting pan (Indian type W.C. pan ) with 100 mm sand cast Iron P or S trap, 10 litre low level white P.V.C. flushing cistern, including flush pipe, with manually controlled device (handle lever) conforming to IS : 7231, with all fittings and fixtures complete, including cutting and making good the walls and floors wherever required. HSR:- 22.22.1 White vitreous chinaware Orissa pattern W.C. pan of size 580x440 mm with integral type foot rests

Providing and fixing C.P. brass long nose bib cock of approved quality conforming to IS standards and weighing not less than 810 gms. HSR:-22.105.1 15 mm nominal bore

Providing and fixing C.P. brass stop cock (concealed) of standard design and of approved make conforming to IS:8931. HSR:-22.107. 1 15 mm nominal bore

Half brick masonry with common burnt clay non-modular bricks of class designation 7 .5 in superstructure above plinth level up to floor IV level. HSR:-7.28.1 Cement mortar 1:3 (1 cement :3 coarse sand)

Demolishing brick work manually/ by mechanical means including stacking of serviceable material and disposal of unserviceable material within 50 metres lead as per direction of Engineer-in-charge. HSR:-5.7.4 In cement mortar

Providing and fixing P.V.C. waste pipe for sink or wash basin including P.V.C. waste fittings complete.Flexible pipe HSR:-22.14.2.2 40 mm dia

Supply and erection of double door sheet steel enclosure distribution board suitable for MCBS and ELCBS etc. recessed in wall including bonding to earth with all labour and material required to complete the job in all respect up to to the entire satisfaction of the Engineer-in-Charge of the work. TPN DB Horizontal type Double Door 4 way ( 8 incoming and 3phase*4 outgoing) HSR - 23.22.4.5

Supply and erection of miniature circuit Breaker/isolator 240/415 V in the existing distribution board including making necessary connections:- 6 amp. to 32 amp Single Pole (HSR-23.22.5.1)

40 amp to 63 amp. MCB's FOUR POLE (HSR-23.22.5.8)

Providing and fixing Piano type accessories of approved make in existing box and Bakelite sheet including fixing and making necessary connections, complete in all respect. Switch 5 amp. on existing sheet. HSR-23.8.1.1

Wall socket 5 amp on existing sheet. HSR-23.8.1.2

15 amp. switch on existing sheet. HSR-23.8.1.3

6 pin 15 multi socket on existing sheet HSR-23.8.1.4

Ceiling rose flush/surface type HSR-23.8.1.5

Socket size rotary step type Electronic regulator for A.C. ceiling fan HSR-23.8.1.13

Wiring main and sub mains in two single core for phase and neutral wire and one single core for earth wire PVC insulated Copper conductor cable 1100 Volts grade in existing MS/PVC Conduit etc as required. 1 run of Size 1.50 Sqmm(1/1.40mm) (HSR-23.5.6.1)

1 run of Size 4 Sqmm(1/2.24mm) HSR-23.5.6.1

Supply, erection, testing of Ceiling fans IS marked (as per IS code 374) with suitable GI pipe complete in all respects complete as per directions ofEngineer-in-charge 48" (1200mm) HSR - 20.71.2

Supply and erection of Bakelite sheet 10x5 with cutting complete in all respects complete in all respect up to the entire satisfaction of Engineer-in charges of the work NS

Supply and erection of PVC batten 1'' with double lock ISI make AKG, Polypack & Diplast in all respect up to the entire satisfaction of Engineer-in charges of the work NS

Supply and erection of heavy duty exhaust fan 12'' with double ball barring make Crompton, havells, Orient with (Warranty 2 year) in all respect up to the entire satisfaction of Engineer-in charges of the work. NS

Supply and erection of heavy duty exhaust fan 18'' with double ball barring make Crompton, havells, Orient with (Warranty 2 year) in all respect up to the entire satisfaction of Engineer-in charges of the work. NS

Supply and erection of LED Batten tube light fitting 20watt. Make Havells, Model no. LUMILINEBS20WLED865PCWH / Philips Model no. BN021CLED225PSUCWGR & Wipro model no. GARNET20WLEDD532065 with warranty 2 year complete in all respect up to the entire satisfaction of Engineer-in charges of the work. (NS)