Metropolitan Naga Water District Tender

Description Item No. Description Quantity Unit I. Pump & Electro-mechanical Equipment Estimated Qty. = 1.00 Lot A. Materials • Submersible Deep Well Pump Rated To Deliver 8 Lps @ 352.63 Ft. (107.5 M) Design Tdh. 4" Ø Riser Pipe Connection. Made Of Heavy-duty Stainless Steel; Corrosion Resistant; Complete With Cable Guard And Built-in Jam-free Check Valve, 1 Unit • Submersible Motor 15hp, 460v, 3-phase, 60hz. Stainless Steel; Double Flanged Nema Mounting Design; Stainless Splined Shaft; External Sand Slinger On Shaft; Copper Bar Rotor; Complete With Motor Lead Wire, 1 Unit • 4" Ø X 3m Upvc Column Pipe, Heavy Type, Square Thread With Rubber Seals, 32 Pcs • 4" Ø Top And Bottom Adaptor (male End Connection), Stainless, 1 Set • 4" Ø Upvc Column Pipe Coupler, 33 Pcs • Pump Guard With Connector, 1 Pc • Well Seal 14" X 14" X 1" With 100mm Ø Bore With Flange And Elbow (long Radius), 1 Pc • Submersible Cable, 3c-8.0mm², 150 Meters • Tw Wire #14 Stranded, 2 Boxes • Splicing Kit 82-a3, 1 Lot • Splicing Tapes (rubber Tapes, Electrical Tapes), 1 Lot • Pull Box, Electrically Insulated, Size: 12", 1 Unit • Variable Frequency Drive (vfd) Suited For 15hp, 460v, 3-phase, 60hz With Graphical Display Includes Supply And Delivery. The Whole Panel Is Assembled In Nema 12 Enclosure Complete With Mcb/mccb Rated Depending On Motor Size, By-pass Contactor, Thermal Overload Relay, Lightning Arrester, Liquid Level (well) Control Relay, Start/stop Push Button, Pilot Lights, Ammeter And Voltmeter Transfer Switches And Hoa Selector Switch, 1 Assembly • Pressure Transmitter 0 - 10 Bars, 4 - 20ma, With Shielded Wire, 1 Unit • Soft Starter Suitable For 15hp, 460v, 3-phase, 60hz. Complete With Mcb/mccb Rated Depending On Motor Size, Magnetic Contactor With Start/stop Push Buttons, Pilot Lights, Liquid Level Control Relay With Electrodes, Overload Relay, Under/over Voltage Relay, Lightning Arrester, With Phase Failure And Phase Imbalance Relay, Ammeter, Voltmeter, Ats, Vts And Hoa Selector Switch Mounted In Nema 12 Enclosure, 1 Assembly B. Installation, Testing, And Commissioning, 1 Lot Ii. Discharge Line Estimated Qty. = 1.00 Lot A. Materials • Discharge Pipe, Bi, 4" Ø X 20 Ft., Sch. 40, Seamless, 2 Pcs • Dynamic/ Combination Air Valve 1", 2 Pcs • Discharge Elbow 4" Ø X 90°, Flange-type (long Radius), 1 Pc • Sleeve-type Coupling With Harness 4" Ø (adapted To Bi Pipe), 2 Pcs • Pressure Switch, 1 Pc • Pressure Transmitter/switch/gauge Fitting Assembly, 1 Pc • Bi Tee, 4" Ø, Flange-type, Weldable, 1 Pc • Manometer Assembly, 1 Unit • Orifice Plate 75mm Ø X 180mm Ø,1 Pc • Hose Bib Assembly, 1 Unit • Fabricated B.i. Elbow, 4" Ø X 45°, Flange-type, Weldable, 2 Pcs • Flexible Conduit, Ltc, 2" Ø, 1 Length • Straight Connector, 2" Ø, 1 Set • Pvc Pipe With Coupling, 2" Ø, 1 Length • Pvc Pipe With Coupling, 3/4" Ø, 1 Length • Pvc Elbow, 2" Ø X 90°, 1 Lot • Pvc Elbow, 3/4" Ø X 90°, 1 Lot • Slip-on Flange 4" Ø With Gasket, 1 Lot • Bolt And Nuts, 1 Lot • Chlorinator, 10 Gpd @ 100 Psi, 1 Unit • 4"ø D.i Gate Valve, F/f, 1 Pc • 4"ø D.i Adaptor, F/m, 1 Pc • 12mm Reinforcement Steel Bar, 7 Pcs • 10mm Reinforcement Steel Bar, 9 Pcs • Cement 40 Kgs/bag, 10 Bags • 1/2" X 8" Anchor Bolt With Nut And Washer, 16 Pcs • 4-10"x10"x1/2" Base Plate, 1 Lot • 4" Ø Pipe Clamp With Bolt And Nut, 8 Pcs • Sand, 1 M3 • Gravel, 1.5 M3 B. Installation, Testing, And Commissioning, 1 Lot Iii. Electrical Equipment Estimated Qty. = 1.00 Lot, A. Materials, • 3 Phase, 60a, 460 Vac Molded Case Circuit Breaker, Panel Mounted, 1 Unit • Manual Transfer Switch With Two Mechanical Interlocked Circuit Breaker (60 At, 3ø, 460 V) With Two Pilot Lamps Indicator For Normal Cooperative Power And Emergency Generator Set Power, 1 Unit • Dry Type Transformer, Rated 5 Kva, 460 Vac Primary, 230 Vac Secondary, Single Phase, 60 Hz 2 - 2 1/2% Above And Below Normal Tappings, Class H Insulation, Pad Mounted And In Nema 1 Enclosure. The Unit Shall Be Provided With 50at/50af Circuit Breaker Protection At Primary Side, 1 Unit • 8mm² Thhn Cu. Wire Including The Wire To Be Used In The Interconnection Of The 3-10kva Transformer, 1 Lot B. Installation, Energization, Testing, And Commissioning, 1 Lot Iv. Generator Set Estimated Qty. = 1.00 Unit, A. Specification Prime Rating Power, Heavy Duty Generator, Diesel Engine Rated At 25 Kva, 480 Volts, 3 Phase 60hz, 1800 Rpm. Automatic Transfer Switch (ats) Compatible, Sound Proof And Water Protected Canopy, Trailer Mounted With Two Wheels With Towing Bar, 1 Unit Technical Data: Prp Continuous Power: 25 Kva / 20 Kw Power Factor: 0.8 Pf Voltage (vac): 460 V Frequency: 60 Hz Speed: 1800 Rpm Governor Type: Mechanical Battery: 12 V Combustion System: Direct Injection Fuel: Diesel No. Of Cylinder: 6 Induction System: Turbocharged, Air To Air Charge Cooled Cooling System: Water-cooled Insulation System: Class H Type Of Excitation: Shunt Type Of Regulation: Avr Voltage Regulation (steady): ± 5% B. Testing And Commissioning, 1 Lot V. Additional Requirements: A. Project Items And Technical Specifications Shall Comply In Accordance With All Annexes Of This Section Which Includes Annex “a”: Detailed Plans And Annex “b”: Operating Specifications And Other Requirements. B. Installation Works Shall Include The Provision Of All Necessary Equipment To Complete All Works. Note: 1. Fob Mnwd Naga City 2. Partial Delivery Shall Not Be Accepted 3. Delivery, Installation, Testing, And Commissioning Completion: Ninety (90) Calendar Days 4. Warranty: A. One (1) Year Against Structural Defects/failures B. Three (3) Years Against Factory Defects For Pump And Motor