Public Works Department Tender

Wiring for circuit/ submain wiring alongwith earth wire with the following sizes of FRLS PVC insulated copper conductor, single core cable in surface/ recessed medium class steel conduit as required a) 2 X 1.5 sq. mm + 1 X 1.5 sq. mm earth wire

b) 2 X4 sq. mm + 1 X 4 sq. mm earth wire

c) 2 X 6 sq. mm + 1 X 6 sq. mm earth wire

Supplying and fixing 20 A, 240 V, SPN Industrial type socket outlet, with 2 pole and earth, metal enclosed plug top alongwith 20 A, “C” curve, SP, MCB, in sheet steel enclosure, on surface or in recess, with chained metal cover for the socket out let and complete with connections, testing and commissioning etc. as required.

Supplying and fixing of following ways surface/ recess mounting, vertical type, 415 V, TPN MCB distribution board of sheet steel, dust protected, duly powder painted, inclusive of 200 A, tinned copper bus bar, common neutral link, earth bar, din bar for mounting MCBs (but without MCBs and incomer) as required. (Note : Vertical type MCB TPDB is normally used where 3 phase outlets are required.) a) 8 way (4 + 24), Double door

b)12 way (4 + 36), Double door

Supplying and fixing following rating, four pole, 415 V, isolator in the existing MCB DB complete with connections, testing and commissioning etc. as required. a)63 A

Supplying and fixing 5 A to 32 A rating, 240/415 V, 10 kA, “C” curve, miniature circuit breaker suitable for inductive load of following poles in the existing MCB DB complete with connections, testing and commissioning etc. as required. a)Single pole

Providing and fixing following rating and breaking capacity and pole MCCB with thermomagnetic release and terminal spreaders in existing cubicle panel board including drilling holes in cubicle panel, making connections, etc. as required. a) 150 A, 16 kA,TPMCCB

Supply, Installation, Testing and Commissioning of 1200 mm sweep, BEE 5 star rated, ceiling fan with Brush Less Direct Current (BLDC) Motor, class of insulation: B, 3 nos. blades, 30 cm long down rod, 2 nos. canopies, shackle kit, safety rope, copper winding, Power Factor not less than 0.9, Service Value (CMM/W) minimum 6.85, Air delivery minimum 215 CMM, 350 RPM (tolerance as per IS : 374- 2019), THD less than 10%, remote or electronic regulator unit for speed control and all remaining accessories including safety pin, nut bolts, washers, temperature rise=75 degree C (max.), insulation resistance more than 2 mega ohm, suitable for 230 V, 50 Hz, single phase AC Supply, earthing etc. complete as required.

Supplying, installation, testing & commissioning of energy efficient surface mounted type 34W to 36W full window glare free opal diffuser LED panel luminaries of size 4 x 1 feet (nominal size) including connections with 3 x 1.5 sq.mm FRLS PVC insulated copper conductor single core cable etc as required. The total system wattage not more than of 36W, LED lumen should be ≥ 3960 system efficacy of ≥ 110 lumen /watt colour temperature 4000K to 5700K, power factor0.95, CRI (Ra)80, THD 10%, with APFC driver having driver efficiency 85%, operating voltage 150-270 volts with minimum 2.5KV surge protection. The luminaries shall be submitted with LM-80 report with a life of 50000 Hours @ L-70 and LED photo biological safety report conforming to IEC 62471 & LED source manufacturer and LM-79 report from NABL accredited Lab. The LED chip should be of Cree, Nichia, Philips Lumiled, Osram, Edison.

Supplying, installation, testing & commissioning of energy efficient recessed mounted type 34W to 36W full window glare free opal diffuser LED panel luminaries of size 595mm x 595mm (nominal size) suitable for both Armstrong/POP/Gypsum Board or grid false ceiling fabricated with MS powder coated white CRCA housing including mounting with the help of chain/other suitable method, hanging from the ceiling including connections with 3 x 1.5 sq.mm FRLS PVC insulated copper conductor single core cable etc as required. The total system wattage not more than of 34W to 36W, LED lumen should be ≥ 3600 system efficacy of ≥ 130 lumen /watt color temperature 5500K to 6500K, power factor0.95, CRI (Ra)80, THD 10%, with APFC driver having driver efficiency 85%, operating voltage 150-270 volts with minimum 2.5KV surge protection. The luminaries shall be submitted with LM-80 report with a life of 50000 Hours @ L-70 and LED photo biological safety report conforming to IEC 62471 & LED source manufacturer and LM-79 report from NABL accredited Lab. The LED chip should be of Cree, Nichia, Philips Lumiled, Osram, Edison.

Supplying & replacement of 300 mm sweep 900 RPM heavy duty exhaust fan 230 Volt 1-ph 50 Hz in the existing hole i/c repairing the damage as same i/c connections with 1.5 sq. mm FRLS PVC insulated, copper conductor, single core cable etc. as reqd.

Supplying & replacement of 400 mm sweep size 230 Volts, single phase, 50 Hz wall fan with suitable mounting arrangement including connection with 1.5 sq. mm FRLS PVC insulated, copper conductor, single core cable etc. as required.

Supplying and drawing of UTP 4 Pair Cat -6 LAN cable in the existing surface/recessed steel/PVC conduit as required a)3.5x50 sq mm

Supplying and drawing of UTP 4 Pair Cat -6 LAN cable in the existing surface/recessed steel/PVC conduit as required a)1 run of cable

Supplying, installation, testing & commissioning of 9U amplifier rack duly chemical treated anticorrosive painted and aluminum front panel to accommodate the following equipment with louvers for ventilation complete with all mounting arrangement including connection etc as required as per site

Supplying, installation, testing & commissioning of Patch Panel Cat 6 UTP Keystone Type-24 Port-Fully Loaded complete etc as requird.

Supplying, installation, testing & commissioning of Patch cord of 3 meters length including connecting with one side existing computer & one side with gang box etc. as required.

Supplying, installation, testing & commissioning of Patch cord 1 meter length including connecting with one side existing computer & one side with gang box etc. as required.

Supplying & Fixing of RJ-45 modular type computer sockets outlets alongwith modular plate in recessed/surface steel conduit etc as required.

Supply installation testing & commissioning of wall mounting box speaker with minimum 5" type speaker component, max pwer: 9watt, rated power: 6watt, Transformer power : 6W-3W-1.5WSPL at 1Watt(at 1Khz, 1m): 91dB, Impedance: 1667/3333/6666 ohm, Frequency range(-10db) 150Hz~11KHz, Material: ABS, color: White etc complete etc as required.

Supply installation testing & commissioning of 240watt Mixing amplifier with frequencey Resoibse+0.1dB from 20Hz to 20kHz at 1 watt, THD 0.05%, Single-to-Noise Ration80 dB, intermodulation Distoration 0.35% (60Hz and 7kHz at 4:1, from full rated output to -30dB), CMRR(20Hz to 1kHz)55dB, typically 70dB, Crosstalk80dB(below rated power, 20Hz to 1kHz), slew rate 80v/usec, damping factor800 fram 10Hz to 400Hz etc complete as required.

Supply, Laying & Fixing of speaker 2 core, 1.5sq mm high definition speaker cable, PVC insulated in PVC jacket laid in existing conduits as required

Supplying and fixing of following sizes of medium class PVC conduit alongwithaceessories in surface/recess including alongwithaccesssories in surface/recess including cutting the wall and making good the same in case of recessed conduit as required

SITC of portable type , heavy duty MS powdered coated painted body LED TV Stand suitable for professional interactive panels for the size upto 55 to 86 inches size with provision of Video conferencing having 4 nos of high quality wheel complete etc as required.

Supplying, Installation, Testing & Commissioning of 75” Ultra HD Interactive Digital Board having 3840 x 2160 (UHD) native resolution, Built-in Speaker 20 Watts (2 X 10 watts) ,Input:- HDMI (3), DP, DVI-D, RGB, Audio in, USB 3.0, USB 2.0, OPS USB 2.0, output:- Touch USB 2.0 (2), External Control RS232C in/out, RJ45 , emperature Sensor, ISM method, DPM Select, Brightness Control, PM Mode, Wake on LAN, Energy Saving, File Play with USB, 2 PIP/PBP, Builtin Wi-Fi (802.11n Combo), USB Cloning, Failover, No Signal Image, Multi touch point Max. 40 Points, Touch Type P-Cap(Ag Metal Mesh), complete with all accessories etc as required.

Add @31.27% on DSR-2016 (E) Items (i.e. on Rs.1299259/-)

Less @ 9.50% on DSR-2016 (E) Items (i.e. on Rs.1299259/-)