Irrigation And Flood Control Department Tender

Demolishing cement concrete manually/ by mechanical means including disposal of material within 50 metres lead as per direction of Engineer - in - charge. Nominal concrete 1:3:6 or richer mix (i/c equivalent design mix)

Earth work in excavation by mechanical means (Hydraulic excavator) / manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, lift upto 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m. All kinds of soil.

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level :1:4:8 (1 cement : 4 fine sand : 8 graded stone aggregate 40 mm nominal size).

Centering and shuttering including strutting, propping etc. and removal of form work for : Foundations, footings, bases for columns

Providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement - All work up to plinth level : (1 cement : 1.5 coarse sand (zone-III): 3 graded stone aggregate 20 mm nominal size).

Steel reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding all complete upto plinth level. Thermo-Mechanically Treated bars

Excavating trenches of required width for pipes, cables, etc including excavation for sockets, and dressing of sides, ramming of bottoms, depth upto 1.5 m, including getting out the excavated soil, and then returning the soil as required, in layers not exceeding 20 cm in depth, including consolidating each deposited layer by ramming, watering, etc. and disposing of surplus excavated soil as directed, within a lead of 50 m : All kinds of soil Pipes, cables etc, not exceeding 80 mm dia

Laying one number PVC sheated / XLPE power cable of 1.1 KV grade of following size in the existing RCC/HUME/Metal pipe as required upto 35 Sq. MM.

Supplying and laying double walled corrugated (DWC) High Density Poly ethylene (HDPE) pipe of 125/105 size having corrugation on the outer wall and plain surface on inner wall confirming to IS 14930 (Part I & II) below the ground level excluding excavation refilling the trench etc. as per specification etc. as required

Supplying installation testing and commissioning of 90-92W (System Wattage) LED street light Luminaries with in high pressure die cast LM6 Aliminium/ extruded Aluminium housing, minimum 6900 Lumen output, CCT 5700 K, for effective thermal managament, sturdiness and better aesthetics. Luminaries should be 140-270 Volt, surge protection 5KV (additional SPD 5 KV inside Housing ), Driver efficiency should be 85%THD 10% Driving current of LED 700 mA, phase to phase protection 415 Volt AC, individual lense for each LED for Better Uniformity. UV stablized polycarbonate / glass cover high ingress protection of IP 66 for complete luminaries. sutaible for side entry with GI (B Class ) bracket of 40-60 mm dia Pipe etc. complete as reqired (make Bajaj/Havells/Halonix/Phillips)

Supplying & testing of PVC insulated armored and PVC Sheathed (genral pupose ) multi core cable with standard aluminium conductor suitable for working voltage upto and including 1100 volts confirming to IS1554/pt/88 with amendment NO. as required 4x 16 Sqmm (finolex havells polycab)

Supplying & drawing following sizes of FRLS PVC insulated copper conductor, single core cable in the existing surface/recessed steel / PVC conduit as required 2 x 2.5 Sqmm

Supplying & fixing 5 amps to 32 amps rating, 240/415 volts 'C' curve miniture circuit breaker suitable for inductive load of following poles in the existing MCB DB complete with connectionm testing and commossioning etc. as required A) Single Pole.

Earthing with G.I earth pipe 4.5 mtr. Long, 40 mm dia accessories and providing masonry enclosure with cover plate having locking arrangement and watering pipe etc. with charcoal/coke and salt as required.

Providing and laying 6 SWG G.I. wire on surface or in recess for loop earthing along with existing surface/recessed/conduit/sub main

Fabrication supplying and installation of outdoor type cubical feeder pillar of suitable size not less than 30 cm and upto 45 cm deep made out of M.S. Sheet 2mm thick (14SWG) duly compartmentalized having 4 strip busbar of 200 amp capacity double door with locking arrangements for protection from rain dust duly fixed on M.S. angle iron frame work of size 50 mm x 50 mm x 6 mm (NS) 110 cm long legs out of which 50cm duly grouted in cement concrete 1:2:4 (1 cement :2 coarse sand : 4 graded stone agreegate 20mm) having following accessories mounded inside the cubical panel including connection inter connection/soild with aluminum timbles earthing with two nos. earth studs duly painted with one coat of red oxide and two coats of superior quality enamel paint completed etc. as required having also compartment for energy meter. Supplying and fixing of following accesssories in the existing cubical panel board/feeder pillar including connection testing etc. as required having also compartment for energy meter Supplying and fixiing of folowing accessories in the existing cubical pnal board/feeder pillar including connection testing etc. as required incomer 25 Amp .35KA MCCB with thermal release 1 No. Outgoing A) 63Amp - DPMCB - 6 Nos. B) 63Amp - ELCB - 1 Nos. C) C.T. Opetrating . D) Tongal Switch E) Voltmeter 0-5000 volts 96 Sqm flush type with selector switch F) Ampere 0-100/5 sqmm Flush type with selector Switch & 100/5 Amp ratio cts G) Indication Lamp (ryb) with control 3 pole (ML-6) 95 Amp H) Power contactor 3pole (ML-6) 95 AMP I) Auto timer Rex modular D41 model MDS make J) Danger notice plate.

Providing and laying in position ready mixed plain cement concrete, with cement content as per approved design mix and manufactured in fully automatic batching plant and transported to site of work in transit mixer for all leads, having continuous agitated mixer, manufactured as per mix design of specified grade for plain cement concrete work, including pumping of R.M.C. from transit mixer to site of laying and curing, excluding the cost of centering, shuttering and finishing, including cost of curing, admixtures in recommended proportions as per IS : 9103 to accelerate/ retard setting of concrete, improve workability without impairing strength and durability as per direction of the Engineer-in-charge.” Note : Excess/less cement used than specified in this item is payable/ recoverable separately. All works upto plinth level M-10 grade plain cement concrete (cement content considered @ 220 kg/cum)

Providing and laying RMC of M-30 grade By using minimum 400kg of cement(43 grade, OPC) per cum of concrete in roads / streets manufactured in automatic RMC plant using coarse sand and graded stone aggregate of 20mm nominal size in appropriate proportion as per approved design criteria including transportation to site in transit mixer, including cost of admixture in recommended proportion as per IS9103 to accelerate/ retard setting of concrete to improve workability with out impairing strength and durability as per specification including spreading and compacting mechanically by using needle and surface vibratos, leveling to required slope & camber, finishing by floating & brooming with wire brushes etc. and curing including making provision for contraction / expansion, construction of cross / longitudinal joints of size 10mm wide 50mm deep by groove cutting machine, providing and filling joints with approved joint filler and sealants, etc. complete, as per direction of Engineer in-charge. (Cost of joint filler & sealants shall be paid for separately under relevant items). Note:- Cement content considered in M-30 is @ 400 kg/cum. Excess/less cement used as per design mix is payable/ recoverable separately M-30 RMC by using minimum cement @400 kg/cum. Cement concrete manufactured in automatic batching plant (RMC plant) including transportation to site in transit mixer.

Total amount