Delhi University Tender

Applying priming coat: With ready mixed pink or Grey primer of approved brand and manufacture on wood work (hard and soft wood)

Painting with synthetic enamel paint of approved brand and manufacture to give an even shade : Two or more coats on new work

Renewing glass panes, with putty and nails wherever necessary including racking out the old putty: Float glass panes of nominal thickness 4 mm (weight not less than 10kg/sqm)

P/F 19 mm thick pressed ply ( Duro / Centuary make) of approved quality in book rack/ kitchen shelf / almirah etc i/c cost of fevicol, nails, nut bolts of required size wooden beading etc

P/F 4 mm thick veneer / teak ply with necessary screws,nails, adhesive etc complete

P/F commercial ply 6 mm thick of approved make

Polishing in high gloss/matt finish melamine clear polish on wood work in required color/wooden shade texture with following process in the sequence as detailed below: 1. The surface to be polished is rubbed with sand paper 80/ 120 no. and then with sand paper of 160/180 nos. 2. Applying two coats of sealer with spray gun and allowing sufficient drying time for 1st coat and 2nd coat is allowed to dry for 8 to 12 hrs. 3. On drying of sealer coat, wet rubbing with emery cloth of finer grading with ample water to remove excess sealer layer and make the surface further smooth after this wet rubbing, then surface is applied with special grade melamine fillers to fill all the small and big holes/grooves etc. Filler coat to be allowed to dry for 4 to 6 hrs on which again a light wet rubbing is done this surface is further allowed to dry for 12 hrs. 4. On this, 1st coat of melamine polish is applied with spray gun using melamine clear polish and melamine thinner in required proportion. This 1st coat is allowed to dry for 24 hrs then this dry surface is again fine wet rubbed smooth, which is further allowed to dry for 12 hrs. The final melamine polish is applied with compressor pressure spray gun using melamine clear polish and melamine thinner mixed in required proportion complete as per direction of Engineer-in-Charge. (Final coat to be done in 1 or 2 layers without gap of time.)

Providing and fixing stainless aluminium tower bolt with approved qualtiy: 150x10 mm

Providing and fixing stainelss steel piano hinges of apprved quality as per direction of Engineer-in-charge

Providing and fixing Multipurpose lock (Godrej make) for cupboards etc complete

Providing and fixing commercial cupboard of depth upto 450 mm with shelves, sides, top bootom & shutter with 19 mm thick teak board (Duro/ Centuay make) and cover with 1 mm thick sunmica (Mareno or equivalent) i/c 6 mm thick teak ply teak wood beading, multipurpose lock (Godrej make) fittings painting & polishing etc all complete as per direction of Engineer-in-charge. (Measurement will be made of front portion)

Repairing, replacing the old wooden table including necessary fittings etc complete as per direction

Fixing the photo and Art Gallery frame in wall etc complete as per direction of the Engineer-in-charge

Providing and fixing 150 mm bright finished floor brass door stopper with rubber cushion, necessary brass screws etc. to suit shutter thickness complete