Delhi State Health Mission Tender

S/o. Sub. P/Set for deep bore wells (high head) of 7.5 HP with dynamically balanced motor, vibration free total enclosed motor fitted squirrel cage induction motor, water lubricated thrust bearing, fitted with S.S. impeller mounted on stainless steel shaft of following parameters having 2900 RPM, suitable to operate on 3 Phase 415 Volt 50 Hz, A.C. supply. Head in meters app. – 144-82, Discharge in LPM – 95-170. Method of starting – Star Delta Delivery Size – 50 mm Make DJB Approved.

Hut type electrical feeder pillar/metal board of welded construction of size 1370mm x 760mm x 460mm fabricated with 16 SWG M.S. sheet with horizontal and vertical intermediate chamber of suitable size on suitable size insulating board to make the Panel Robust, having double door with 14 SWG S.S hinges along with double locking arrangement with arrangement for mounting of switch gear and electrical energy meter i/c powder coating painting, Vermin proof having following items.MCCB 63 Amp, 4 Pole, Breaking capacity at 415 V: 35 kA, adjustable thermal setting (70- 100%) and fixed magnetic settings. Confirms to IEC: 60947-II/IS: 13947-II, RCCB 63 Amp, 4 Pole with earth fault indicator and positive contact indication protecting a circuit automatically in the event of earth leakage, Sensitivity: 300 mA, Confirms to IEC: 61008-I/IS: 12640-I, Fully automatic star delta starter upto 10HP, 3Phase oil immersed type, Ampere meter 96mmx96mm square shape of 0-30 Amp range, Voltmeter of 96mm x 96 mm square shape of 0-500 volt range with selector switch, LED Indicating lamps with fitting (a set of 3 lamps), Shunt capacitor of 5 KVAR MPP type with three phase isolator ,Panel Should have Motor Protection Assembly having Earth Leakage protection, Phase sequence corrector, Single phasing protection, Over load protection, High voltage-low voltage protection. Time delay power on Programmable time switch (i.e. RYB Phase & facility to change over from automatic to manual & vice versa) up to 10 H.P., Complete wiring of panel board & installation of electrical accessories in the panel with required copper conductor wire & thimbling etc as required. The panel board shall be mounted on the base frame of 2 feet height made of 50x50x6mm angle iron frame. Make:-The entire insert used in Panel must be of DJB approved makes wherever applicable.

Supply CI D/F non return valve of size 50mm dia.,as per IS 5312(part 1&2)PN 1.0 CI Body, Door/Bronze to Rubber rings/SS410 Hinge Pin Construction Make: IVC/Kirloskar