Delhi Development Authority Tender

Supplying, erection and commissioning of HOT Dip galvanized octagonal steel pole of 10 mtr height i/c dismantling of existing LED fitting and old /rusted pole made out of 3 mm thick sheet having bottom 210 mm A/F & top 90 mm A/F with built in connector control box with flush cover on height of 1000 mm from the bottom of pole, MS base plate of size 300 mm x 300 mm x 16 mm thick, the pole is to be fixed on existing RCC foundation with bolt and nuts making connection, interconnection with 2 nos. 3X 2.5 sq mm size of copper wire with thimble/ lugs in the connector box, earthing, making/ numbering of pole etc as required with following accessories with mounted in built in control box. a) 6 mm thick laminated sheet along with 2 nos. 6 Amp, 10KA, SPMCB, 'C' charcteristic on the din channel, 2 no. 63 Amp terminal block suitable for 16 sq.mm Aluminum condr. cable and din channel for MCB's. b) Earth stud weld at suitable height i/c washer, spring washers and nuts. c) Cable support clamps suitable for 2 nos. of 2x 16 sqmm Cable. d) 1000 mm long double over hang 75X40 mm C-channel fixed on suitable size pole cap of suitable height (as per manufacturer's design) i/c drilling holes of suitable size with suitable clamp for fixing of LED fitting etc. as required. e) Drawing of pole shall be approved from the engineer incharge as per manufacturer before use at site. (rebate for old dismantled pole is inclusive in the rate and dismantled pole shall be the property of the agency and agency should quote the rates accordingly i/c rebate but excluding LED fittings )

Providing and laying in position M 20 (1:2:4) reinforced cement concrete foundation of size 500 mm long x 500 mm wide and 1500 mm deep i/c excavation of earth, providing cutting, bending and placing in position reinforcement of cold twisted bar of 12 mm dia 1650mm long (approx.) -8 Nos. and reinforcement ring of cold twisted bar of 8 mm dia 1800 mm long (approx.)-10 Nos. (with 150 mm spacing) i/c supplying of 4 Nos. M-24 x 750 mm long (150 mm top threaded portion) GI foundation bolt (EN- 8 grade) with 3 Nos. nuts and 2 Nos. washer, bolt along with 2 Nos. templates/ Anchor plate of size 320 mm x 320 mm x 4 mm thick having 4 Nos. 26 mm dia holes to match with PCD of poles base plate with positioning of foundation bolts and providing 120 mm (OD) 2 Nos DWC pipe for cable entry and exit as required. (Drawing to be approved by Engineer in charge.)

Supplying and drawing following sizes of PVC insulated PVCsheathed/ XLPE copper conductor multicore cable in the existing poles and bracket from cable termination connector to the fitting i/c providing suitable copper lugs connections etc. as reqd.