Tourism Department Tender

Filling in plinth with sand under floors including watering ramming, consolidating and dressing complete.

Providing and laying cement concrete 1:2:4 (1-Cement : 2- Coarse sand : 4-graded stone aggregates 20 mm nominal size) and curing complete excluding cost of formwork in (A) Foundation and Plinth.

Providing and laying controlled cement concrete M.250 and curing complete including the cost of formwork and reinforcement for reinforced concrete work in (A) Foundations, footings, Base of column sand Mass concrete.

Providing and laying controlled cement concrete M.250 and curing complete including the cost of formwork and excluding reinforcement for reinforced concrete work in (C) Beam, Col. Footing upto plinth

Providing and laying controlled cement concrete M.250 and curing complete including the cost of formwork and reinforcement for reinforced concrete work in (D) Columns, Pillars posts and struts, upto floor two level.

Providing and laying controlled cement concrete M.250 and curing complete including the cost of form work and excluding reinforcement for reinforced concrete work in © Slabs, landing, shelves, Balconies, Lintels, Beams, Girders and Cantilever upto floor two level.

Providing and laying cement concrete work 1:2:4 (1- Cement: 2- Coarse sand: 4- graded stone aggregates 20 mm nominal size) and curing complete excluding cost of formwork and reinforcement for reinforced concrete work in (B) Slabs, landing, shelves, Balconis, Lintels, Beams, Girders and Cantilever upto floor two level. wall caps/coping.

Providing TMT Bar FE 500D reinforcement for R.C.C. work including bending, binding & placing in position complete upto floor two level.

White Stone Bela masonry block in course in superstructure with stone of approved quality in Cement Mortor 1:6 (1-Cement: 6-course sand) including packing the joints etc. complete.

20mm thick sand faced cement plaster on walls uptoheight 10metres above ground level consisting of 12mm thick backing coat of C.M. 1:3 (1-cement : 3-sand) and 8mm thick finishing coat of C.M. 1:1 (1-cement : 1-sand) etc. complete.

Finishing wall with weather proof exterior emulsion paint on wall surface (two coats) to give an required shape even shade after thoroughly brushing the surface to remove all dirt, and remains of loose powdered materials.etc complete

Prov. and laying Tremix design mix cement concrete M-400 in roads / drive ways using  coarse sand and graded stone aggregates 20 to 25 mm nominal size in appropriate quantity as per specification, mechanically vibrated using and surface screed vibrators, vaccume pump power floater, power trovel, concrete floor cutter etc. Including approved quality floor hardener @ 2 kg/smt on top surface incl. steel form work with  200 mm M.S. channel sections incl. proper curing and providing and filling construction joint and dummy joints  with "shalitax" primer silflex sheet not less than 20 mm th. incl. rounding the edges and cutting the groove by using concrete cutter  inzigzac pattern  upto 1/3 depth of the RCC thicknes and not less than 10 mm in width and filling the grooved by dummy joints with bitumen sealing compound of grade-A Including making all necessary arrangments for expansion joints at every 15 mtr's square or as per site situation with filling bitumen etc. complete.  Note :- This item will be excluded of reinforcement but Including centering, shuttering, MS form work, necessary tools & plants and all required materials etc. comp. as directed by Engg. In charge.

providing and fixing precast concrete curb stone(Rubber Dye or machine mold) of grey cement based concrete block 30cm length , 30 cm height and 15 cm thick of M250 grade concrete as per approved design and including excavation for fixing in proper lined and level filleing the joint with C:M- 1:3 (1-cement , 3- fine sand) etc. complete

Providing and fixing pre-cast Rubber Dye inter locking concrete block 60mm thick with grade of concrete M250 pnumatic compressed by mechanically pressed and as per approved design including 75mm Sand layer for levelling and filling the joint with sand in proper line and level etc. complete

Filling in plinth with sand under floors in cluding water in gramming ,consolidating and dressing complete

Double Swing

F.R.P. Slide

See-Saw

Per Equipment Erection Total Item

providing and laying 200 mm thk rubble soling

providing and fixing ms gate 6.0 mt x 1.8 mt (double leaf) using ms. Angles, tees & flats etc.

Providing and laying cement concrete 1:4:8 (1- Cement : 4- Coarse sand : 8- Graded Brick bats aggregate 40mm normal size) and curing complete excluding cost of formwork in (A) Foundation and Plinth

Half brick masonry in common brunt clay building bricks having crushing strength not less than 35 Kg/Sq.Cm. in Cement mortar 1:4 (1- Cement : 4 -coarse sand ) in foundation and plinth (B) Conventional

precast R.C.C greting 450mm x 75mm thick for collection of rain water trench

PERCOLATION WELL-Furaat Horizontal Filtration Module (HFM-2350) ofdiameter 1500mm and 2350mm height. In a typical Horizontal Filtration Module (HFM-2350) each vertical precast slab has eight inlets of 60 mm diameter each. Top module is above ground level with an option of keeping height 300 /400/ 610 mm above ground level. Top module accommodates filter media in the form of layers of gravel supported on a pair of an open able perforated pre cast slab ( 1075mm x 550mmx 40mm thick),. Bottom module is for sedimentation. The inlet and outlet of the system is 160mm diameter UPVC pipes. The entire system contains approximately 0.08 cubic meter gravels of 40 mm size. All precast concrete slabs are of M-25 grade. Filtration capacity & testing up to 30m3 per hour from modular systems only.This module is used for Roof/Surface water and the filtered water to get into is finally connected with the Sand Filtration Module.wih excavation, filling etccomplate as per drawings/Architect/EIC.

Providing, laying and jointing in true line and level 160 diametre U.P.V.C (Type B) conforming to IS 13592-1992 with one end plain and other end socketed with rubber ring, & fittings conforming to ISI 14735-1999 of approved make for drainage system pipe line, pipe shall be jointed with each other with rubber lubricant, pipe shall be fixed on wall using of PVC clamp of the size 160 mm diametre x 210 mm length x 196 mm heigh at every 2000 mm center to center or shall be concealed in walls as directed including necessary fittings such as bends, shoes etc. including testing of pipes and joints and jointed with adhesive solvent cement including cost of all materials.