Punjab Engineering College Tender

Providing and fixing of seasoned teak wood battens/ Phatties on the student seating class room benches including finshing complete in all respect with all necessary wood steel screw with MS angle iron

Providing and applying white cement based putty of average thickness 1 mm, of approved brand and manufacturer, over the plastered wall surface to prepare the surface even and smooth complete.

Wall painting with acrylic emulsion paint of approved brand and manufacture to give an even shade :

Two or more coats on new work

Removing dry or oil bound distemper, water proofing cement paint and the like by scrapping, sand papering and preparing the surface smooth including necessary repairs to scratches etc. complete.

Polishing in high gloss/matt finish melamine clear polish on wood work in required color/wooden shade texture with following process in the sequence as detailed below: 1. The surface to be polished is rubbed with sand paper 80/ 120 no. and then with sand paper of 160/180 nos. 2. Applying two coats of sealer with spray gun and allowing sufficient drying time for 1st coat and 2nd coat is allowed to dry for 8 to 12 hrs. 3. On drying of sealer coat, wet rubbing with emery cloth of finer grading with ample water to remove excess sealer layer and make the surface further smooth after this wet rubbing, then surface is applied with special grade melamine fillers to fill all the small and big holes/grooves etc. Filler coat to be allowed to dry for 4 to 6 hrs on which again a light wet rubbing is done this surface is further allowed to dry for 12 hrs. 4. On this, 1st coat of melamine polish is applied with spray gun using melamine clear polish and melamine thinner in required proportion. This 1st coat is allowed to dry for 24 hrs then this dry surface is again fine wet rubbed smooth, which is further allowed to dry for 12 hrs. The final melamine polish is applied with compressor pressure spray gun using melamine clear polish and melamine thinner mixed in required proportion complete as per direction of Engineer-in-Charge. (Final coat to be done in 1 or 2 layers without gap of time.)

Providing and fixing of zebra rollor blind including fixing on wall complete in all respect.

Applying one coat of Water thinnable cement primer

Printing with synthatic ennamal

a) one coat

Electrical Work (B)

Providing and Fixing of PVC Rigid drain Pipe surface/recess in wall / floor with necessary repair to the original condition, complete in all respects from indoor unit to Disposal Points as directed by the E.I.C. Size ¾” including specials- Make- Diplast or Equalivent.

Providing and Fixing of 22 gauge soft copper piping of size 3/8” & 5/8” or as per original manufacturer of A/C size, for Liquid & Suction sides, between indoor & outdoor units with 6 mm thick nitrile rubber insulation & protective covering for exposed weather including cost of chasing brick wall/RCC wall & repairing to original condition.Make Rajco., Mandev, Totaline.

Providing & fixing of 4 core 2.5 sqmm flexible coppe wire ISI Marked complete. Makes Havell/Polycab as per site.

Supply, installation, testing and commissioning of Inverter Split AC 2TR capacity, 3 star rating with Refrigerant R-410/R-32 Gas with with ISEER in range 3.80 to 4.39 , Cooling Capacitty = 6200 Watt . AC shall be suitable for 230 Volts+- 10% Volt ,50 Hz, Single phase , other standard manufactures Specification including installaltion charges complete in all respect upto the entire satisfaction of Engineer-in Charge. Make :- Daikin/Carrier/Hitachi/ Voltas

Providing & Fixing of Powder coated ready made heavy duty out door stand for Split out door as per site requirement to the entire satisfaction of Engineer- in Charge.

Making Hole in ceiling RCC slab for fixing of AC on Terrace complete job including necessary Rapairs complete in all respect