Municipal Corporation Tender

Providing and fixing fencing of G.I. chain link fabric with MS frame having GI wire of dia. 4 mm, having mesh size 50mm x 50 mm in required colour and shade embeded in MS Angle 45x45x5mm frame (size 6' x 6') duly embedded in Cement Concrete 1:2:4 block of 1’-6” x1’-6” x 1’-6” with 3’ part of MS angle column of frame extended to frame with anchorage 2' of same MS angle size embedded in concrete base and 6’-0” clear above the ground level and 6'-0" wide. All the edges and middle cross both sides i.e Vertical & Horizontal of shape (+) duly flash welded to the M.S angle and chain link fabric by M.S flat of size 25x5mm. The adjacent frames to be connected with nut & bolt arrangement and welded are required. The cost also includes two coat of special quality paint over one coat primer complete in all respect and to the entire satisfaction of the Engineer-In-Charge. Welding should be done all along the length of the flat of different points to make it sturdy and avoid vandalism)

Providing and fixing M.S gate with 2 nos operable shutter of size 50x50x6mm M.S angle frame 5'-6" long x 6'-0" high (both sides, vertical and Horizontal) with M.S flat 40x6mm at distance 4" centre to centre vertical and two Nos horizontal Jointed with M.S. Channel (double box) of size 100x50mm on both sides having height 6'-0" above ground level and 2'-6" below ground level (6" spacing by providing in between bottom frame to ground level) including anchorage piece 2 Nos each shutter 1'-6" long of size 50x50x6mm M.S angle embedded in cement concrete 1:2:4 block of size 2'-0''x 2'-0''x 2'-6". The rates also includes the cost of 6 nos moveable/operable hinges (3 Nos each side) & Two Nos sliding bolt for locking arrangements and gate shall be painted with two coats of approved quality enamel paint over one coat of primer complete in all respect to the entire satisfaction of Engineer- in-Charge..

Providing and fixing M.S Angle 50x50x6 mm frame notice board of height 9 feet and width 4 feet. The CRC sheet 16 gauge of size 4'-0" long and 3'-0" high is to be welded on top of the frame with MS angle 50x50x6 mm at top and bottom of sheet. The frame is to be fixed on ground with 6'' long anchorage in cement concrete 1:2:4 block size 1'x1'x2' (Depth) with 2'-0'' part of frame embeded inside and 7'-0'' above. The rates also inclused one coat of steel primer with two coat of special quality enamel paint of approved shade and further writing the approved write-up on both sides of the board as per the direction of EIC, complete in all respects as per drawing & job to the entire satisfication of Engineer- in-Charge.