Municipal Corporation Tender

Brick work with F.P.S. bricks of class designation 75 in foundation and plinth in: Cement mortar 1:4 (1 cement : 4 coarse sand) (DSR 6.1.1)

Steel work welded in built up sections/ framed work including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. In gratings, frames, guard bar, ladder, railings, brackets, gates and similar works. as required. (DSR 10.25.2)

Providing and fixing M.S flat gate having flat size 50 x12 mm having 5'-0" long and 2'3" high of each openable shutter welded with 2 no's M.S flat 40 x10mm including 25X10mm horizontal below top flat horizontally at 6'' upper and 6'' from bottom and 9 no's M.S square bars of 45 degree angle at 6'' center to center including 2 no's M.S. Channel 75x40mm in posts having 2no's channel welded to form post of size 75x80mm & 5'-0" long(3'-0" above ground level and 2'-0" below ground level) with lugs 1'-3" long 2 no's M.S. Flat 40x10mm at bottom under each post to be provided on both sides of shutter with 2 no's hinges for openable arrangements with sliding bolt for locking arrangements and gate shall be properly embedded in cement concrete 1:2:4 (1'-6"x1'6"x2'-0") be painted with two coats of approved quality paint over one coat of primer complete in all respect to the entire satisfaction of Engineer- in-Charge.

Providing and fixing M.S. flat railing having flat size 50x12mm,(2"x1/2") 4'-0" high(3' high above ground level) welded with 2no's M.S. flat 38x10mm horizontally at distancwe 9.5" upper and 9.5” from bottom and 1no's M.S. flat 25x10mm on the lower side of top M.S. flat including 8mm M.S. square bars of 45 degree angle at 6" center to center bsetween the 2no's horizontally M.S. flat iron. The rates also includes the cost of 2 No. 12mm dia nut and bolts with 2no's M.S. pipe of 19mm dia and 3" long imbedded in ceme sleeve piece embedded in cement concrete 1:2:4 block of size 1'-0"x0'-9"x1'-0" and painted with three coats of approved quality paint over one coat of primer complete in all respect to the entire satisfaction of Engineer-in-Charge.

15mm cement plaster of mix: 1:4 (1 cement: 4 coarse sand) to the entire satisfaction of Engineer-in-Charge. (DSR 13.5.1)

Pointing on brick work or brick flooring with cement mortar 1:3 (1 cement : 3 fine sand) (Flush/ Ruled/ Stuck or weathered pointing to the entire satisfaction of Engineer-in-Charge (DSR 13.31.1)

Raking out joints in lime or cement mortar and preparing the surface for re-pointing or replastering, including disposal of rubbish to the dumping ground, all complete as per direction of Engineer-in-Charge. (DSR 14.17)

Providing and applying JK putty of 2mm thickness over plastered surface to prepare the surface even and smooth complete (DSR 13.26)

Finishing walls with acrylic Smooth exterior paint of required shade:- New work (Two or more coat applied @ 1.67 ltr/10 sqm) over and including priming coat of exterior primer applied @ 2.20 kg/10 sqm (DSR 13.46.1)

Painting with synthetic enamel paint of approved brand and manufacture of required colour to give an even shade : One or more coats on old work. (DSR 14.54.1)

Ramdon rubble masonry with hard stone n superstructure above plinth level and upto floor five level. Including leveling up with cement concrete 1:6:12 (1 cement : 6 coarse sand : 12 graded stone aggregate 20mm nominal size) at window sills, ceiling level and like: cement mortar 1:6 )1 cement : 6 (1 cement : 6 coarse sand) (DSR 7.2.1)

Providing and Laying position cement concrete of specified grade excluding the cost of centring and shuttering . All work plinth level :- 1:2:4 (1 cement : 2 coarse sand : 4 graded stone agg 12.5 mm nominal size complete in all respect to the entire satisfaction of Engineer-in-Charge.(DSR 4.1.3(

Credit of bricks bats/brick tiles bats/brick tiles complete in all respect and to the entire satisfaction of the Engineer-in-Charge.