Chandigarh Administration Tender

Construction of 200mm thick compacted Wet Mix Macadam to confirming to clause 406 of MORT&H specification (5th edition) having as laid, density of 2.2gm/c.c by providing laying, spreading and compacting clean, crushed aggregate and granular material (taking 3.30 cum material for 10 sqm area) conforming to Table 400-12 (Physical characteristics) and Table 400-13 (grading) of MORT&H specifications (5th edition). The material shall be premixed with water at OMC in Mixing Plant/Pan type mixer/Pug Mill and mixed material carried to site by tippers and spread uniformly and evenly on the prepared sub base/base by paver finisher of adequate capacity and all high and low spots remedied by removing or adding aggregate, as required and rolled with 8-10 tones roller to achieved/desired density. It shall included the cost of tools and plants, carriage of material from stacks, templates, barriers, safety temporary warning lamps at night, chowkidar, maintenance of diversion etc. Complete in all respects as per MORT&H specification, drawings and the instruction of Engineer in charge. (NS)

Providing and fixing 80 mm thick ISI approved high density rubber moulded precast cement concrete paver blocks grey / coloured designer, polished, manufactured by vibro hydraulic pressure process having wearing layer of 6mm to 8mm thick with Cement and fine aggregate mix ratio 3:1 (three cement and one fine aggregate) and under layer consisting of design mix of cement, sand and fine aggregate having designation M-35 including best quality of colour and hardening agent. The pavers should be complied with tensile strength and breaking load as per BIS 6717-1993 and shall be tested against resistance to wear as per IS:1237-1980. The paver should be laid over a layer of 25 mm thick screened coarse sand to the required slope and filling the joints with fine sand etc. complete in all respect and to the entire satisfaction of Engineer-in-charge. (NS)

Dismantling of existing Kerb including stacking the same within a lead of 1000 mtr complete in all respect and to the entire satisfaction of the Engineer in charge. (NS)

Dismantling of existing Channel including stacking the same within a lead of 1000 mtr complete in all respect and to the entire satisfaction of the Engineer in charge. (NS)

providing and fixing of factory manufactured precast concrete kerb of size 300mm x 300mm having 100mm thickness at bottom & 75mm at top duly vibrated mechanically and compacted made of P.C.C 1:2:4 duly cured and finished. The rate further include filling of joints between kerbs / channels with cement mortar 1:2 complete in all respect and to the entire satisfaction of Engineer-in-charge.(NS)

providing and fixing factory manufactured precast concrete channels of size 300 x 300mm having 75mm thickness duly vibrated, mechanically and compacted made of P.C.C 1:2:4 duly cured and finished. The rate further include filling of joints between kerb with cement mortar 1:2 complete in all respects and to the entire satisfaction of the Engineer-in-Charge. (N.S.)