Public Works Roads Department Tender

Construction of subgrade and earthen shoulders with approved material obtained from borrow pits with all lifts & leads, transporting to site, spreading, grading to required slope and compacted to meet requirement of table (300-2) with lead upto 1000m as per Technical Specification Clause 303.1. (i) From private land

Construction of granular sub-base by providing well graded Material, spreading in uniform layers with motor grader on prepared surface, mix in place method with rotavator at OMC, and compacting with smooth wheel roller to achieve the desired density, complete as per Technical Specification Clause 401. (ii) For Grading II Material

Providing, Laying, Spreading and compacting stone aggrigates of specific size to water bound macadam specification including spreading in uniform thickness, hand packing, rolling with smooth wheeled roller 80-100 kN in stages to proper grade and camber, applying and brooming, stone screening to fill-up the interstices of coarses aggregate, watering and compacting to the required density grading 3 as per Technical Specification Clause 405. (A) By Manual Means.

Providing and laying interlocking concrete block pavement (M40) having thickness 80mm as per technical specification clause 1504 including carriage. a) Including Edge block/ Edge restraints

Providing and fixing of retro-refectorised cautionary, mandatory and informatory signas per IRC:67 made of encapsulated lens type reflective sheeting vide Clause 1701.2.3 fixed over aluminium sheeting , 1.5mm thick supported on a mild steel angle iron post 75mm x 75mm x 6mm firmly fixed to the fround by means of properly designed foundation with M15 grade cement concrete 450mm x 450mm x 600mm, 600mm below ground level as per drawing and technical Specification Clause 801 600mm equilaterial tringle

600mm circular

Providing and erecting of tripical PMGSY informatory sigh with Logo MORD Specifications and drawing. Three MS places of 1.6mm thick, top and middle plate duly welded with MS flat Iron 25mm x 5 m sixe on back on edge. The lower place will be welded with MS angle iron frame of 25mm x 25mm x5mm. The angle iron frame of the lower most plate and flat iron frame of middle plate will be welded to 2 nos. 75mm x 75mm of 12 SWG sheet tubes posts duly embedded in cement concrete M-15 grade block of 450mm x 450mm x 600mm below ground level. The top most diamond plate will be welded to middle plate by 47mm x 47mm of 12 SWG steel plate tube. All M.S. will be stove enameled on both sides. Lettering and printing arrows, border etc. will be painted with ready mixed synthetic enamel paint of superior quality in required shade and colour. All sections of framed posts and steel tube will be painted with primer and two coats of epoxy paint as per drawing clause 1701 and Annexure 1700.1