Public Works Roads Department Tender

Granular Sub-Base with Well Graded Material ( Table:- 400- 1) (Construction of granular sub-base by providing well graded material, spreading in uniform layers with motor grader on prepared surface, mixing by mix in place method with rotavator at OMC,and compacting with smooth wheel roller to achieve the desired density,complete as per Technical Specification clause 401. For Grading II Material

Providing, laying, spreading and compacting stone aggregates of specific sizes to water bound macadam specification including spreading in uniform thickness, hand packing, rolling with smooth wheel roller 80-100 kN in stages to proper grade and camber, applying and brooming, stone screening/binding materials to fill-up the interstices of coarse aggregate, watering and compacting to the required density grading 2 as per Technical Specification Clause 405. (A) By manual means

Inter locking concrete Block pavement (a)Providing and laying interlocking concrete block pavement (M40) having thickness 80mm as per technical specification clause 1504 complete including carriage.(a) Including cost of Edge restraints wall

Retro reflectorised Traffic sign: Providing and erecting of Retro-Reflectrorised cautionary, mandatory & informatory sign as per IRC: 67 made of high intensity encapsulated lens type reflective sheeting vide clause 801.3, fixed over aluminium sheeting, 2 mm thick fixed on an angle iron of 25x25x4mm supported on a mild steel angle iron post 75mm x 75mm x 6mm firmly fixed to the ground by means of properly design foundation with M-15 grade Cement concrete 45cm x 45cm x 60cm, 60cm below ground level as per approved drawing and sign. ( All the Steel work must be Tata/Sail/or any other approved brand) (ii) 60cm equilateral traingle

(iii) 60cm Circular

(iv)80cm x 60cm rectangular

Direction and place identification sign upto 0.9sqm size board. Providing and erecting direction and place identification retro-Reflectrorised sign as per IRC:67 made of encapsulated lens type reflective sheeting vide clause 801.3 fixed over aluminium sheeting, 2mm thick with area not exceeding 0.9sqm fixed on an angle iron of 25x25x4mm supported on a mild steel angle iron post 75mm x 75mm x 6mm firmly fixed to the ground by means of properly design foundation with M-15 grade Cement concrete 45cm x 45cm x 60cm, 60cm below ground level as per approved drawing and sign. ( All the Steel work must be Tata/Sail/or any other approved brand)

Earth work in excavation for structures as per drawing and Technical specification clause 305.1 including setting out ……………… with excavated material 1. Ordinary soil (i) upto 3m depth

Laying bedding on well compacted sand as per clause 1105 (ii)sand

Providing concrete for plain/reinforced concrete in open foundations complete as per drawings and technical specifications Clause 802, 803, 1202 & 1203 B)With natural Gravel (I)PCC M10 (1:3:6 nominal mix)

Providing concrete for plain/reinforced concrete in open foundations complete as per drawings and technical specifications Clause 802, 803, 1202 & 1203 B)With natural Gravel (I)PCC M15 (Nominal mix (1:2.5:5))

Brick masonry work in cement mortar in foundation of head walls complete excluding pointing and plastering as per drawing and technical specification clause 1109 (in prop.1:4)

Providing and laying reinforced cement concrete in superstructure as per drawing and technical specifications Clauses 800, 1205.4 and 1205.5 (II) RCC M25

Providing and laying cement concrete wearing course M 30 grade including reinforcement complete as per drawing and technical specifications Clauses 800 and 1206.3

Providing weepholes in brick masonry/stone masonry, plain/reinforced concrete abutment, wing wall, return wall with 100 mm dia AC pipe extending through the full width of the structures with slope of 1(V):20(H) towards drawing face complete as per drawing and technical specification Clauses 614, 709, 1204.3.7

Supplying, fitting and placing TMT (Fe-500 D) reinforcement bar . (From Primary Producer: TATA/SAIL/Esser Steel/ Jindal steel/Shyam steel/RINL) in superstructure complete as per drawing and technical specifications Clauses 1002, 1010 and 1202

Providing and laying interlocking concrete block pavement (M40) having thickness 60mm as per technical specification clause 1504 complete including carriage.

Granular Sub-Base with Well Graded Material ( Table:- 400- 1) (Construction of granular sub-base by providing well graded material, spreading in uniform layers with motor grader on prepared surface, mixing by mix in place method with rotavator at OMC,and

Plastering with cement mortar (1:4), 15 mm thick on brickwork in substructure as per technical specification Clauses 613.4 & 1204

Construction of Foundation Stone with Brick masonary work in cement morter in foundation including plastering with cement mortar (1:4), 15 mm thick on brick work and painting with 2 coats of water based cement paint, and fixing black colour granite plate of size 1067 mm X 762 mm (3'6'' X 2'6'') with necessary letter writing (golden coloured) in groves on granite plate,boundary and logo of required size and numbers as desired by the department and as per drawing and directed by the department including providing with pandel of size 60'X40' with dias, arrangement of table & VIP chair 10 (Ten) nos. and plastic chairs 200 (Two hundred) nos. electric generator,temporary arrangement of fan and lighting, sound system etc. as desired by the department required for Foundation Stone Laying Ceremoney for public meeting to be addressed by VIPs with supply of package drinking water and refreshment.