Indo Tibetan Border Police Tender

Providing and installation of structural prefabricated toilet and bathroom - the structure size should be 1220mmX915mm and height 2025 mm (except foundation structure ) With following specification complete:- I) Structure wall panels- (i) Each wall consists of 4 sandwich panels (Inc of top louver panel in each side.) Sandwich panel size 650mm* 995mm (ii) All 4 top wall to have to single skin Louvre panels (150 mm)of 0.6 mm Galvanized plain powder coated sheet .(iii) Each wall panel is to be 40 mm thick Sandwich panels made of 0.6 mm thick, Min 240 MPa yield strength (YS), Min 340 Ultimate Tensile strength (UTS) zero spangled skin passed Tension leveled, Restriction of Hazardous substance EPS (Expanded polystyrene ) of density 16 kg/m3) inside it (iv) The bottom most panel on 3 side on sides in each compartment to have SS 304 in the interiors up to 125 mm form floor that is to be riveted over powder coated galvanized plain sheet. II) Structure Roofing - Flat roof of 40 mm thick Sandwich panels made of 0.6 mm thick , 272 MPa Strength zero spangled skin passed 120 GSM galvanized plain powder coated cold rolled sheet with insulation ( 38mm EPS) (Expanded polystyrene) of density 16kg/m3 ) inside it. The protrusion is to be 50 mm III) Structure corner pillars – 40 mm thick sandwich panels made of 0.6 mm thick, 275 MPa Strength zero spangled skin passed 120 GSM galvanized plain powder coated cold rolled sheet to be used for structure corner pillars. IV) Doors- 1790 mm *649mm* 40mm thickness, (made of 0.6 mm Galvanized plain powder coated steel inclusive of standard accessories i.e 2 Nos of Allu handle (6”) L drop with plastic brush, 1 No of Allu Tower bolt (6 inch) and SS Hinges and screws. V) Ventilation – Powder coated steel ventilation above door (built in single panel) made of 0.6 mm thick , 275 MPa Strength zero spangled Galvanized plain sheet VI) External/ internal finish – pure polyester glossy Powder Coating VII) Water tank & Tank frame – 200 Liters on each Cabin with required plumbing fitments along with tank frame VIII) Plumbing – All internal piping with CPVC pipe of nominal dia 20 mm with necessary unions for maintenance purpose & stop cocks. PTMT SYMET of similar: One bib cock tap in each compartment. One stop cock each for controlling water flow (i) Water source to tank (ii) Tank to Washing Tap . Stainless steel SS wash basin with one bib cock & water supply connection. All other necessary pipes fittings like P trap, vent pipes etc. IX) Electrical Fittings – 1 CFL & 1 Modular switch in each compartment and required internal wiring. 6 Nos Toilet and 6 Nos Bathroom block with 3000 Ltr Bio Digester tank at BOP Bishing which is 12 kms on foot (one side) in hilly terrain from last road head Gelling, Arunachal Pradesh.