Roads And Buildings Department Tender

Urgent Repairs to the road from Km 31/3 to 32/7 Rayalapuram Bridge to APCARL Circle of Muddanur Pu;Supplying of hot applied thermoplatsic road marking compound, 2.5mm thick including reflectorising glass beads @ 250 gms with Reflectorising glass beads on Bituminous surface at 250 gms per sqm area thickness of 2.5mm is exclusive of surface applied glass bead as per IRC 35 the materials should be of BERGER Company/BERGER Equivalent and must comply with the following: (A) White index for the product should be in the range of 60-70 when measured against standard refernce. The applied panel 7/8 number must be submitted for checking up the white index in the department lab. In Case the department approves the white index of any vendor, the department engineer may carryout random checking of the applied products at site against the approved panel. In case of any major deviation, beyond acceptance limit, department reserve the rigid to cancel or reject the total supplied consignment of the said material as per approved panel at his own cost and additional demurrages may be claimed due to loss of man days (as per the rules of the department). (B) Luminance factor of the material should be in the range of 80 - 85% at 45 degree centigrade as per ASSTHOM 4249. (C) Crack resistance: The applied panel cured for 7 days under ambient condition and then should be tested as per BS3262, Part-1, 1989 and should pass at the range of '0' degree centigrade to '-10' degree centigrade (D) Adhesion: Strong (E) Softoning point: 102 degree centigrade (F) Dired film finish:Smooth and uniform (G) Night vision: High as directed by the Engineer - In - Charge and conforming to IS:164-1961(1st revision reaffirmed in 1986) and clause conforming to IRC 35-1997.

Urgent Repairs to the road from Km 31/3 to 32/7 Rayalapuram Bridge to APCARL Circle of Muddanur Pu;Supply & fixing of molded shanks Raised pavement markers made of polycarbonate and ABS moulded body and reflective panels with micro prismatic lens capable of providing total internal reflection of the light entering the lens face and shall support a load of 16000 k tested in accordance to ASTM D 4280 type H and complying to specification of category A of MORTH circular no RW/NH/33023/10-97 ? DO III dt 11.06.1997. the light width and length shall not exceed 50 mm. 100 mm and 100 mm and with minimum reflective area of 13 Sqm on each side and the slope to the base shall be 35+/- degree. The strength of detachment of the integrated cylindrical shanks.(of diameter not less than 19+/- 2 mm and height not less than 30 +/- 2mm) from the body is to be minimum value of 700 Kgs. Fixing will be by drilling holes on the road for the twin shanks to go inside without nails and using epoxy resin based adhesive as per manufacturers recommendation and complete as directed by the engineer.