Panchayat Raj Engineering Department Tender

Rewinding of 10HP/Three phase Submersible Pumpset including all necessary material and of the same characteristics as original with required size of super enameled wire 'E' class insulation material and testing etc.complete for finished item of work.

Re-errection charges of 10HP/Three phase Submersible Pumpset with all accessories in to the existing source including testing and conducting trail run and all labour charges etc.complete for finished item of work.

Manufacture, Supply & Delivery of 110mm dia 4Kg/cm2 UPVC Pipes of ISI Make for Potable water supplies confirming to IS 4985/2000 (3rd Rev) as per specifications inclusive of transportations and excluding all taxes

Manufacture, Supply & Delivery of 160mm dia 4Kg/cm2 UPVC Pipes of ISI Make for Potable water supplies confirming to IS 4985/2000 (3rd Rev) as per specifications inclusive of transportations and excluding all taxes

Manufacture, Supply & Delivery of 200mm dia 4Kg/cm2 UPVC Pipes of ISI Make for Potable water supplies confirming to IS 4985/2000 (3rd Rev) as per specifications inclusive of transportations and excluding all taxes

Labour charges for Leakage in the existing 110mm dia 4Kg/cm2 PVC Pipe lines of different places including necessary trench excavation by manual in all soils, dewatering, removing of mud, cleaning of pipe and leakage portion, cutting the pipe line & removing piece of pipe from trench with inclusive of mechanical deviced JCB, Hydralic Crane if necessary & labours required with providing material such Turened CID joints with Nut bolt, Ribber rings, lowering, laying and jointuing of pipeline to allgnment and gradient, refilling trench with excavated earth as per specification, watering and tampering and removing surpules earth from site of work, filling of water in the pipe line as per specification etc.complete. The rates are incluslve of cost & conveyence of all materiels and all labour charges etc.complete (excluding cost of Pipe) for finished item of work.

Labour charges for Leakage in the existing 160mm dia 4Kg/cm2 PVC Pipe lines of different places including necessary trench excavation by manual in all soils, dewatering, removing of mud, cleaning of pipe and leakage portion, cutting the pipe line & removing piece of pipe from trench with inclusive of mechanical deviced JCB, Hydralic Crane if necessary & labours required with providing material such Turened CID joints with Nut bolt, Ribber rings, lowering, laying and jointuing of pipeline to allgnment and gradient, refilling trench with excavated earth as per specification, watering and tampering and removing surpules earth from site of work, filling of water in the pipe line as per specification etc.complete. The rates are incluslve of cost & conveyence of all materiels and all labour charges etc.complete (excluding cost of Pipe) for finished item of work.

Labour charges for Leakage in the existing 200mm dia 4Kg/cm2 PVC Pipe lines of different places including necessary trench excavation by manual in all soils, dewatering, removing of mud, cleaning of pipe and leakage portion, cutting the pipe line & removing piece of pipe from trench with inclusive of mechanical deviced JCB, Hydralic Crane if necessary & labours required with providing material such Turened CID joints with Nut bolt, Ribber rings, lowering, laying and jointuing of pipeline to allgnment and gradient, refilling trench with excavated earth as per specification, watering and tampering and removing surpules earth from site of work, filling of water in the pipe line as per specification etc.complete. The rates are incluslve of cost & conveyence of all materiels and all labour charges etc.complete (excluding cost of Pipe) for finished item of work.

Supply & Delivery of 100mm dia Electormagnetic Flow meter (Bulk Flow meter), manufacturer should have ISO 9001:2008 certification and flow meter testing confirming to ISO 17025, Flow meter Tube - SS304, Flanges - Carbon Steel as per DIN PN 10 or higher rating as per requirement, Liner - Hard Rubber or PTFE suitable for Drinking water application, Grounding - Grounding Rings SS 304/Grounding Electrodes of material SS 316, Coil Housing and Junction Box - SS 304/Die cast Aluminum/Carbon Steel with anticorrosive epoxy coating of minimum thickness 150 microns/equivalent as per EN ISO-12944 standard (as per the site condition), Ingress Protection - IP 68 for sensor and IP 67 for transmitter, Flow Trasmitter Accuracy - +/- 0.5% of the measured value of velocities 0.5 m/sec and above, Display - Digital LCD/LED (blacklit LCD/LED) Diplay, Instantaneous flow, Bi-Directional flow and Totalized Flow, Cable between Flow Head and Transmitter - Miximum 25 meters including PVC conduit, Surge Arrester - To be provided, Power Supply & Output - 230V AC or 24V DC as applicable to site condition & 4-20 mA HART, Compatible to SCADA/WEB Based Data acquisition System, Flow meter test lab certificatin should be provided from NABL appproved lab/FCRI, Excluding all taxes with 5 years warranty (Makes - M/s Krohne Marshall/Endress+Hauser/Yokogawa/Siemens/Emerson/ABB/ or equiavalent make)

Operation and Maintenance of CPWS Scheme to CPWS Scheme to Gottiprolu and other habitations in Chittamur Mandal of SPSR Nellore District for the Year - 2024-25 for Supply of potable (chlorinated) drinking water at the specified quantity as per drinking water quality standards to all the habitations mentioned in the schedule through the existing network system comprising of infrastructure viz. RSF, OHBR, Service Reservoirs i.e. OHSRs, GLSRs etc., including all operating expenses like wages to the system staff and other amenities applicable as per the labour act, Mobility/transportation facilities etc., for the designated qualified Pump operators, Electricians, Fitters, Helpers, Watchmen etc. for carrying out of all operations involved in drawing of raw water from source, treatment and supply of drinking water as per the guidelines of CPHEEO manual/Department at the rate of 40LPCD with relevant IS specifications wherever applicable and with highest quality standards. The scope of work also includes routine, periodic, breakdown and preventive maintenance, staffing and engaging manpower under Operation & Maintenance. The turbidity of supplied water shall be maintained below 1 NTU and should not exceed 5NTU by mixing alum in raw water duly arriving the Alum dosage by jar test. Disinfection with Bleaching Powder/Liquid Chlorine/Gas Chlorination shall be taken up to maintain Residual Chlorine not less than 0.2ppm in pipe lines at last FHTC in the tail end habitations. The scope of work includes taking up of all other incidental activities pertaining to the Operation and Maintenance of CPWS Scheme and to follow all standard procedures by the agency as directed by the Employer/Engineer of the department. The Rate per KL is applicable to supply potable (chlorinated) drinking water by engaging system staff for Operation & Maintenance of said CPWS Scheme (The rate is excluding cost of consumables, power consumption charges, Repairs and Renewals and GST) for the Period from 01.12.2024 to 31.03.2025 (121 Days - 192.72KL per day). (Annexure is enclosed for the System staff & Habitations list)

Supply, delivery and staking of Bleaching Powder as per I.S 1065-1989, Table - 1, Grade - I, including cost and conveyance of material, stacking at the location specified by the Department and all taxes, duties and levies etc.complete. (Available Chlorine percent by mass 34%)

Manufacture, Supply & Delivery of 110mm dia 4Kg/cm2 UPVC Pipes of ISI Make for Potable water supplies confirming to IS 4985/2000 (3rd Rev) as per specifications inclusive of transportations and excluding all taxes

Manufacture, Supply & Delivery of 160mm dia 4Kg/cm2 UPVC Pipes of ISI Make for Potable water supplies confirming to IS 4985/2000 (3rd Rev) as per specifications inclusive of transportations and excluding all taxes

Labour charges for Leakage in the existing 110mm dia 4Kg/cm2 PVC Pipe lines of different places including necessary trench excavation by manual in all soils, dewatering, removing of mud, cleaning of pipe and leakage portion, cutting the pipe line & removing piece of pipe from trench with inclusive of mechanical deviced JCB, Hydralic Crane if necessary & labours required with providing material such Turened CID joints with Nut bolt, Ribber rings, lowering, laying and jointuing of pipeline to allgnment and gradient, refilling trench with excavated earth as per specification, watering and tampering and removing surpules earth from site of work, filling of water in the pipe line as per specification etc.complete. The rates are incluslve of cost & conveyence of all materiels and all labour charges etc.complete (excluding cost of Pipe) for finished item of work.

Labour charges for Leakage in the existing 160mm dia 4Kg/cm2 PVC Pipe lines of different places including necessary trench excavation by manual in all soils, dewatering, removing of mud, cleaning of pipe and leakage portion, cutting the pipe line & removing piece of pipe from trench with inclusive of mechanical deviced JCB, Hydralic Crane if necessary & labours required with providing material such Turened CID joints with Nut bolt, Ribber rings, lowering, laying and jointuing of pipeline to allgnment and gradient, refilling trench with excavated earth as per specification, watering and tampering and removing surpules earth from site of work, filling of water in the pipe line as per specification etc.complete. The rates are incluslve of cost & conveyence of all materiels and all labour charges etc.complete (excluding cost of Pipe) for finished item of work.

Supply & Delivery of 100mm dia Electormagnetic Flow meter (Bulk Flow meter), manufacturer should have ISO 9001:2008 certification and flow meter testing confirming to ISO 17025, Flow meter Tube - SS304, Flanges - Carbon Steel as per DIN PN 10 or higher rating as per requirement, Liner - Hard Rubber or PTFE suitable for Drinking water application, Grounding - Grounding Rings SS 304/Grounding Electrodes of material SS 316, Coil Housing and Junction Box - SS 304/Die cast Aluminum/Carbon Steel with anticorrosive epoxy coating of minimum thickness 150 microns/equivalent as per EN ISO-12944 standard (as per the site condition), Ingress Protection - IP 68 for sensor and IP 67 for transmitter, Flow Trasmitter Accuracy - +/- 0.5% of the measured value of velocities 0.5 m/sec and above, Display - Digital LCD/LED (blacklit LCD/LED) Diplay, Instantaneous flow, Bi-Directional flow and Totalized Flow, Cable between Flow Head and Transmitter - Miximum 25 meters including PVC conduit, Surge Arrester - To be provided, Power Supply & Output - 230V AC or 24V DC as applicable to site condition & 4-20 mA HART, Compatible to SCADA/WEB Based Data acquisition System, Flow meter test lab certificatin should be provided from NABL appproved lab/FCRI, Excluding all taxes with 5 years warranty (Makes - M/s Krohne Marshall/Endress+Hauser/Yokogawa/Siemens/Emerson/ABB/ or equiavalent make)