Municipality Tender

Manufacture, Supply, & Delivery of HDPE Pipes are conforming to IS 14333 -2000 for using underground drainage and sewerage systems including transportation to anywhere in A.P, excluding all taxes (Supply up to 90 mm drain coil & above 90 mm dia. straight length) (SOR 2019-2020)(6.00 Kg/Sqcm)(110mm dia)

Laying and jointing of HDPE pipes by butt fusion welding as per IS:7634 – part - II/1975 as amended from time to time to the alignment and gradient and testing the pipeline to required pressure - 1 Rmt ( Public Health Items,P.4)

Construction of un-reinforced, plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M30 (Grade), coarse and fine aggregates conforming to IS : 383, maximum in a concrete mixer of not less than 0.2 cum capacity and appropeiate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 mictron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with sholvels, rakes, compacted using needle, scareed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints, applying debonding strips, primer, sealant, dowel bars, near approaches to bridge / culvert and construction joints, admixtures as approved, curing of concrete slabs for 14- days, curing compound (where specified) and water finishing to lines and grade as per drawing and Technical Specification Clause 1501 MORD. item RBR-CCPV-5 of standard data

Manufacture, Supply, & Delivery of HDPE (PE –100 Grade) fittings conforming to IS 4984 - 1995 including transportation to anywhere in A.P. Excluding all taxes,Complete (HDPE pipe ends long neck 110mm)

Tees 110mm

Reducers OD 110 mm x 125 mm

MS Flanges 110mm

Supply and delivery of "Resilient Seated Soft Sealing" Gate Valves (Sluice Valves) with Body and Bonnet of Ductile Iron GGG-40/SG-400/15 or GGG-50/SG-500/7 or Equivalent as per IS1865, IS:3896-2 and Wedge fully Rubber Lined with food grade quality grade W270 grade EPDM, Replaceable Spindle Nut without gland packing with 3-O ring protection system on the Shaft and Seals of NBR. The Valves should be Vacuum tight and 100% leak proof with face to face dimensions as BS:5163 Type A/IS:14846. All the valves should be with fusion bonded Electrostatic Powder coating both inside and outside (Min 250 Microns)- RAL 5005 with Pocket Less Straight through body Passage conforming to Design standards of DIN-3202F4/BS:5163 Type A Flange drilling as per IS - 1538 excluding all taxes, duties and including transportation. PN1.6 (SOR 2019-2020)

Supply and Delivery of the folwing sizes of Bolts and Nuts with double washers including taxes and conveyance etc.,complete (SOR 2019-2020) M-130).

Carting away the surplus excavated earth from the work site with a lead of 1.00 Km beyond initial lead including loading, unloading and conveyance but exclding stacking charges etc., complete.