Municipal Corporation Tender

Supplying of hot applied thermoplastic road marking compound, 2.5mm thick includig reflectorsing glass beads @ 250gms with reflectorising glass beads on bituminous surface at 250 gms per sqm area, thickness of 2.5mm is exclusive of surface applies glass bead as per IRC:35, the material should be of BERGER company BERGER equivalent / Equivalent brand and must comply with the following: a) white index for the product should be in the range of 60-70 when measured against standard reference. The applied panel 7/8 number must be submitted for checking up the white index in the department lab. In case the department approves the white index of any vendor, the department engineer may carryout random checking of the applied products at site against the approved panel. In case of any major deviation, beyond acceptance limit, department reserve the right to cancel or reject the total supplied consingment of the said material and will compell the vendor has to repalce the full consignment by the desired material as per approved panel at his own cost and additional demurrages may be claimed due to loss of man days (as per the rules of the department) b) Luminanace factor of the material should be in the range of 80-85% at 45degree centigrade as per AASTHOM 249. c)Crack resistance: The applied danel cured for 7 days under amblent condition and then should be tested as per BS3262, part-1 1989 and should pass at the range of '0' degree centigrade to '-10' degree centigrade D) Adhesion: Strong E) Softening point:102 degree centrigrade F) Dried film finish: Smooth and uniform G) Night vision: High as directed by the Eingieer-in-Charge and confirming to IS"164-1961 (1st revision reaffirmed in 1986) and clause conforming to IRC 35-1997 Taking out put 640 Sq.m

Supplying and fixing of molded raised pavement markers made of plastic body moulded from HIPS (HI-impact polysterene) or ABS or ASA (Acrylic strene Acrylonitrite) and reflective panels with micro prismatic lens capable of providing total internal refiction of the light entering the lens faceand shall support a load of 16000 kg tested in accordance to ASTM D4280 type H and complying to specifications of category A of MORTH circular no RW/NH/33023/10-97 - Do III Dt.11.06.1997. The height, width and length shall not exceed 50mm, 100mm and 100mm and with minimum reflective area of 13 Sqcm on each side and the slope to the base shall be 35+/- 5 degree. Fixing using epoxy resin based adhesive as per manufactur's recommendation and complete as directed by the Engineer-in-Charge.