Electricity Department Tender

“Repairing work of departmental vehicle Ashok Leyland bearing Regn.no. AN F 4580 Rangat Site Office

I. Driver’s cabin repair works: Removal of complete driver’s cabin from the chassis frame then plating, welding and denting work to be done to the entire driver’s cabin wherever required. After completion of plating welding & denting the body is to be mounted on the chassis using Teflon felt/body mounting rubber bushes and proper fastenings to prevent abnormal vibrations. II. Rear luggage carrier body: Plating, denting and welding work to be done to the entire driver’s cabin wherever required. III. Painting: Complete painting of Vehicle after thorough cleaning with sand paper, grease, soapy water. Metal waste, oil primer, putty to be applied on the dent surface. The surface should be polished accordingly in required shape. After drying, the surface to be quoted with PS grey and painted with two coats of standard acrylic enamel automobile paint. Under chassis painting to be done with standard quality of paint.(maintaining existing color scheme). IV. Upholstery works: i.Complete upholstery work to be done with replacement of existing seat covers, door pads and ceiling cover with new superior quality rexine cloth cover.(quality sample of rexine cloth should be verified from the Executive Engineer (Rural) before stitching the seat covers). ii. Existing drivers seat assy. To be replaced with new one. V. Mechanical and Electrical repair works: i.Requires replacement of both RHS & LHS front spring leaf sets with all shackles brackets, mounting bolts etc. ii. Both front and rear existing break drums and brake shoe innings to be replaced with new one. iii.Existing dual brake valve assy. To be replaced with new one. iv.All steering worn out linkages, bail joints to be replaced with new one. v.All 06 Nos. existing tyres with tubes & flaps to be replaced with new one. vi.Defective centre bearing assy., and U.J cross bearings on propeller shaft to be replaced with new one. vii.Gear box to be overhauled by replacing the damaged parts with new one. viii.Complete re-wiring to be done by replacing the existing wiring harness with new one. (Maintaining existing grade of wiring). Replacement of existing headlight assy., tail light assy., front blinker light assy., electric horn, combination switch, wiper blades, cabin light etc. with new one.