Directorate Of Shipping Services Tender

Plating Painting and Associated Works

Hull Plating:- Cropping and renewal of steel plates at various places of Ship’s underwater hull, ship side (above waterline and below main deck), tanks, confined tanks, double bottom tanks, engine room, steering compartment, enclosed places, pump rooms, ship’s keel, skeges, nose, rudder and A-bracket, curvature, and rudder trunk including proper cleaning of worksite, renewal of shell frames (transverse and longitudinal), brackets, foundation, bulk heads, girders etc. as required on-board DSS vessels manufacturing/fabrication and fitment of item like foundation, frames, brackets, girders, coamings etc from MS Plate/Angle etc. will be calculated as steel renewal at the same rate. NOTE: “While carrying out plate renewal works it shall be insured that alignment is not disturbed/altered it shall be the responsibility of the contractor to rectify the defects free of cost”. Note:The inner surface of the renewed and welded steel plates supplied by the department for renewal has to be coated with 02 coats of Primer Paint of Make: Jotun/AkzoNoble/Sigma. This will form part of scope of worl and shall be undertaken by the firm with supply of paints and Labour Charges at the quoted price. MS plates, angles, flats etc., shall be supplied by the department.

Deck plating:- Cropping and renewal of steel plates at various places of Ship’s decks and superstructure including degutting and re-gutting of paneling, removal and re-fitment of exiting glass wool, plywood, sunmica, wooden frames, electrical fittings, cables etc. if found reusable. The work includes cleaning of work site, renewal of stiffeners, flat plate bracket, shell frames/bottom floor, foundation deck beams/girders, bulk heads, deck fittings, eye plates, cleats, coaming, stanchion, stanchion shoes etc. coming on the way of plate renewal will be part of plates renewal manufacturing/fabrication & fitment of item like foundation, bollards, towing post, frames, brackets, girders, coamings, cleats, manhole cover, hatches, guard rails, piping works, ventilation flaps, air vent, system pipe lines etc. from MS Plate/Angle G.I or MS Pipe etc. will be calculate as steel renewal at the same rate. Note: The inner surface of the renewed and welded steel plates supplied by the department for renewal has to be coated with 02 coats of primer paint of Make: Jotun/ Akzonoble/Sigma. This will form part of scope of work and shall be undertaken by the firm with supply of paints and labour charges at the quoted price. MS plates, angles, flats etc., shall be supplied by the department.