Public Works Department Tender

Brick soling with picked jhama bricks including preparation of bed as necessary with brick joints properly filled in and packed with powdered earth and including necessary (d) Soling or dry pavement with one brick-on-edge laid in herring bone pattern over a layer of bricks flat (thickness 125 mm plus 75 mm)

Plain / Reinforced Cement Concrete in Open foundation with or without reinforcements, in any part of foundation of bridges / culverts with graded stone chips of appropriate nominal sizes, including screening and cleaning of coarse aggregates, fine aggregate (sand) conforming to proper grading zone, both of approved quality and cement, as necessary, cost of curing with water, including cost and carriage of all materials and including preparation of design mix, approval of the same by the Engineer-in-Charge, cost for quality control, sampling, testing etc. including cost of formwork but excluding reinforcement complete as per drawing and technical specifications. D) PCC Grade M30 I) Using concrete mixer

Supplying and laying in the specified pattern of Interlocking Concrete Block Pavement (ICBP) with concrete blocks (with concrete grade as specified as per table 1 of IS 15658:2006) Manufactured in still mould clamped to a vibrating table by hydraulic pressure (as per cl. No. 6.30 of IRC : SP: 63 (2018), from BIS licensee manufacture, with spacer nib (small protruding profiles on the vertical face of a paver block used as a devise for keeping minimum joint gape in between the paving blocks, as per CI. No. 3.26 of IS : 15658) and of specified size and shape with aspect ratio ( the ratio of length to thickness of a paver block , as per CI. No.3.3 of IS : 15658) as per table 2 of IS: 15658 with flexural strength /breaking load as per Annexure G of IS : 15658, on the prepared base course of specified CBR as per table 1 of IRC SP 63 (2018) or else as mentioned in design and drawing with a cushion of compacted bedding sand of 25- 35 mm thick (Grading of the grading sand as per clause 6.5.1 of IRC SP -63) and filling up the gaps in between paver blocks with joint filling sand (the grading of the joint filling sand will be as per clause 6.5.2 of IRC SP 63) and completing the edges with cut blocks as per CI. No. 8.7 of IRC SP -63(2018) with paper confinement of grading and joint filling sand. Compaction, leveling and filling up of the edge gap. 120mm thick Grey

Add GST @ 18% on Item Serial No.1 to 6

Add CESS @ 1% on Serial No. 1 to 7