Public Works Roads Department Tender

Supplying and laying in the specified pattern if interlocking concrete Block pavement (ICBP) with concrete blocks (with concrete grade as specified as per Tablel 1 of as IS 15658:2006) manufactured in steel mould clamed to a vibrating table by hydraulic pressure (as per cl. no. 6.30 of IRC:SP:63 (2018), from BIS licensee manufactured, with spacer nib (small protruding profiles on the vertical face of a paver block used as a device for keeping minimum joint gap in between the paving block as per cl. no. 3.3 of IS: 15658) and of specied size and shape with aspect ration(the ratio of length to thickness of a paver block, as per cl. no. 3.3 of IS:15658) as per Table 2 of IS:15658 with flexural strength/breaking load as per Annexure G of IS:15658, on the prepared base course of specified CBR as table 1 of IRC SP 63 (2018) or else as mentioned in design and drawing with a caushin of compacted bedding sand of 25-35 mm thick (grading of the bedding sand as per clause 6.5.1 of IRC SP-63) and filling up the gaps in between paver blocks with joint filling sand (the grading of the edge with cut blocks as per cl. no. 8.7 of IRC SP-63 (2018) with compaction, levelling and filling up of the edge gap. 100mm thick. Gray

Plain / Reinforced Cement Concrete in Open foundation with or without reinforcements, in any part of foundation of bridges / culverts with graded stone chips of appropriate nominal sizes, including screening and cleaning of coarse aggregates, fine aggregate (sand) conforming to proper grading zone, both of approved quality and cement, as necessary, cost of curing with water, including cost and carriage of all materials and including preparation of design mix, approval of the same by the Engineer-in-Charge, cost for quality control, sampling, testing etc. including cost of formwork but excluding reinforcement complete as per drawing and technical specifications. A PCC Grade M20

GST @ 18%(CGST 9% + SGST 9%) of above

Labour Welfare Cess@1%