Rural Engineering Department Tender

Construction of granular sub-base by providing well graded material, spreading in uniform layers with tractor mounted grader on prepared surface mixing by mix in place method with rotavator at OMC, and compacting with smooth wheel roller to achieve the desired density, complete as per Technical Specification Clause 401

Providing, laying, spreading and compacting stone aggregates of specific sizes 53mm to 22.4mm to water bound macadam specification including spreading in uniform thickness, hand packing, rolling with smooth wheel roller 80-100 KN in stages to proper grade and camber, applying and brooming, stone screening to fill-up the interstices of coarse aggregate, watering and compacting 7.50cm thickness to the required density Grading 3 as per Technical Specification Clause 405.(4.7.3) By Manual Means .

First class brick work in 1:4 cement and coarse sand above 2.25 F.M. mortar in foundation and plinth including supply of all materials,labour and t&p etc required for proper completion of the work. as per SI. N0. 305(B).

Construction of Un Reinforced ,dowel jointed at expansion and constuction joint only , Plain Cement Concrete pavement , thickness as per design , over a prepared sub base , with 43 grade cement or any other type as per Clause 1501.2.2 (M-30 Grade) , coarse and fine aggregrates conforming to IS :383 , maximum size of coarse aggregrate not to exceed 25mm,mixed in a concrete mixer not less than 0.20cum capacity and appropriate wieght batcher using approved mix design ,laid in approved fixed side form work (steel channel , laying and fixing of 125 micron thick polythene film , wedges, steel plates including levelling the form work as per drawing ), spreading the concrete with shovels, rakes , compacted using needle,screed and plate vibrators and finishing in continous operation joints, applying debonding stripes, primer ,sealant dowel bars near approaches to bridge/culvert and construction joints , admixtures as approved curing of concrete slabs for 14 days curing compound (where specified) and water finishing to lines and grade as per drawing and technical specification MORD 1501 (excluding supply polythene and making of contraction Joint ) as per rate sanctioned by S.E. R.E.D Azamgarh

Providing and Laying 125 micron thin polythene to act as separation layer

Making contraction / construction joint with filling bitumin 40% , asbestas 5% and coarse sand including all for proper completion of the work

12 mm thick plaster over brick work with cement mortar consisting of one part cement & four parts of fine sand of 1.25 F.M. including supply of all material,labour and T&P etc required for proper completion of the work as per SI NO 584

Mild Steel Work in R.C.C. Including cutting and bending S.I. 504

Providing and fixing 450 mm NP3 Hume Pipe for Cross Drainage