Public Works Department Tender

Construction of granular sub-base by providing close graded material, spreading in uniform layers with motor grader on prepared surface, mixing by mix in place method with front end loader at OMC, and compacting with vibratory roller to achieve the desired density, complete .As per Reference to MORT&H Specification 401 SN. 4.01 Rates are including all labour, material, T&P, taxes & labour cess but excluding GST

Supply and laying of 100 mm thick precast cement concrete I-.shape Interlocking paver blocks ISI marked confirming to IS: 15658-2006 with top layer of minimum 5mm thickness having plan dimension 200 x (160+120mm) of O.P. cement, Smoth high gloss finish skid resistant, manufactured from rubber moulds through vibro-compression mechanism. The Compressive strength of concerete paver block shall not be less than 50 MPa and weight 5.0 kg per including cost of material with a blanket layer of 4 cm. thick fine sand including labour, T & P etc.As SI No New Item No 15 Ch.20 Road Work. Rates are including all labour, material, T&P, taxes & labour cess but excluding GST

Providing, laying and spreading of Stablized graded stone aggregate (WMM) after mixing with water at OMC in mechanical mix plant carriage of mixed Material by tipper to site, laying with 4% OPC cement in unform single layer on sub-base /subgrade and compacting with the road roller to achieve the desire density..Rates are including all labour, material, T&P, taxes & labour cess but excluding GST

Construction of un-reinforced, dowel jointed at expansion and construction joint only, plain cement concrete pavement, thickness as per disign, over a prepared sub base with 43 grade cement or any other type as per Clause 1501.2.2 (1:1½:3) M-30 coarse and fine aggregates confirming to IS 383 maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less then 0.2 cum capacity and appropriate weight batcher using approved mix design, laid in approved fixed side form work (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels. rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints as per norms, applying debonding strips primer, sealant, dowel bars, near approaches to bridge/ culvert and construction, joints, admixtures as approved, curing of concrete slabs for 14-days, curing compound (Where specified) and water finishing to lines and grade as per drawing and Technical Specification Clause 1501 including Cost of Polythene Sheet and Dowel bar and also including complete shifting of matrials & Concrete etc.Rates are including all labour, material, T&P, taxes & labour cess but excluding GST

Construction of embankment/Patri with approved material obtained from borrow pits with all lifts (Distance 4 km) and all leads, transporting to site, spreading, grading to required slope and compacting to meet requirement of table 300-2. (Ref. to Mort&H Specification No.305) including cost of earth etc.Rates are including all labour, material, T&P, taxes & labour cess but excluding GST

Providing and applying tack coat with bitumen emulsion using emulsion pressure distributor at the rate of @ 0.25 kg per sqm on the prepared bituminous surface cleaned with mechanical broom.As per Reference to MORT&H Specification 503 SN.5.02 Rates are including all labour, material, T&P, taxes & labour cess but excluding GST

Providing and laying dense graded bituminous macadam with higher capacity batch type HMP using crushed aggregates of specified grading, premixed with bituminous binder VG-40 @ 4.5 per cent by weight of total mix and filler, transporting the hot mix to work site, laying with a hydrostatic paver finisher with sensor control to the required grade, level and alignment, rolling with smooth wheeled, vibratory and tandem rollers to achieve the desired compaction as per MoRTH specification complete in all respects.As per Reference to MORT&H Specification 505 SN. 5.4 Rates are including all labour, material, T&P, taxes & labour cess but excluding GST

Providing and applying tack coat with bitumen emulsion using emulsion pressure distributor at the rate of @ 0.20 kg per sqm on the prepared bituminous surface cleaned with mechanical broom.As per Reference to MORT&H Specification 503 SN.5.02 Rates are including all labour, material, T&P, taxes & labour cess but excluding GST

Providing and laying bituminous concrete with higher capacity batch type hot mix plant using crushed aggregates of specified grading, premixed with bituminous binder VG-40 @ 5.4 per cent of mix and filler, transporting the hot mix to work site, laying with a hydrostatic paver finisher with sensor control to the required grade, level and alignment, rolling with smooth wheeled, vibratory and tandem rollers to achieve the desired compaction as per MORTH specification complete in all respectsAs per Reference to MORT&H Specification 507 SN. 5.5 Rates are including all labour, material, T&P, taxes & labour cess but excluding GST

Cement Concrete with 2 cm gauge approved stone grit, coarse sand & cement in the proportion of 8:4:1 including supply of all materials, labour, Tools & plants etc. required for proper completion of the work all same as S.I item 281. Rates are including all labour, material, T&P, taxes & labour cess but excluding GST

R.C.C. Work with cement, approved coarse sand & 2 cm gauge approved stone grit in proportions of 1:2;4 in lintels of door & windows excluding supply of reinforcement and its bending, but including its fixing and binding the same with 24 B.W.G.G.I. binding wire and including necessary centering and shuttering etc. and supply of all materials, labour, Tools & plants etc. required for proper completion of the work including cost of binding wire. The rate excludes making of drip course which shall be paid extra. all same as S.O.R item 284 Rates are including all labour, material, T&P, taxes & labour cess but excluding GST

M.S (tor steel or plain ) in plain work such as RCC or R.B work i/c bending for proper shape and i/c supply of steel & its wastage,bends,hooks,and authorised overlapping shall be measured and i/c cost of binding wire as S.O.R item 504. Rates are including all labour, material, T&P, taxes & labour cess but excluding GST