Cane Development And Sugar Industry Tender

M-150 Brick Work in 1:3 Cement & C.Sand For Drain SI.No. 307

R.C.C. Work in 1:1.5:3 with cement C.Sand & 2 cm gauge S.Grit for Slab SI.No. 284 (a)

Mild Steel Plain Work such as R.C.C.Work DSR 5.22.6

P.C.C. in 1:2:4 with cement, C.sand & 2 cm. gauge S. grite (SI NO. 279a)

12 mm thick Plaster in 1:4 cement & Fine Sand (SI NO.284)

M.S.Work in heavy size such as trusses ,builtup gates,record racks,roof work,Gate etc.SI.No. 503 drain cover

Construction of un-reinforced, dowel jointed at expansion and construction joint only, plain cement concrete pavement, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M-30 (Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints, applying debonding strips, primer, sealant, dowel bars, near approaches to bridge/culvert and construction joints, admixtures as approved, curing of concrete slabs for 14-days,including cost of polythene sheet

B. Canteen Earth work in excavation in foundation (SI No251 a )

P.C.C. in 1:4:8 with cement f.sand and 4 cm gauge B/ballast SI No. 275

M-150 Brick Work in 1:6 Cement and F.Sand SI.No. 303

2.5 cm thick Damp Proof Course with cement concrete consisting of 1 part cement, 1½ parts approved coarse sand and 3 parts approved 10 mm. graded stone grit and including water proofing material as ordered by the Engineer incharge in the proportion as specified by the manufacturer as per (S.I.No. 361 )

M-150 Brick Work in 1:6 Cement & F.Sand For 9" Wall in S/S as per SI.No. 303+309+310

R.C.C. Work in 1:2:4 with cement C.Sand & 2 cm gauge S.Grit for liter beam as per SI.No. 285

R.C.C. Work in 1:1.5:3 with (M-20) cement C.Sand & 2 cmm gauge S.Grit as per SI.No. 284 a for slab

Mild Steel Plain Work such as R.C.C.Work as per SI.No. 504

12 mm thick Plaster in 1:4 cement and Fine Sand as per SI.No. 584

M.S. Work in heavy size such as door Trusses builup gate, Record Rack, gate etc. as per SI.No. 503

Supply and fixing 6 to 8 mm thick ivory or light shades vitrefied tiles 600x600 mm size in flooring and skirting with 1:3 approved cement and coarse sand morter finished with in its cement colour slurry, jointing and polished of approved quality complete, including supply of all materials, labour, tools and plants etc. required for proper completion of the work. as per direction of Engineer - inIcharae as per (S.I.No. 14.26/New Item-4)

Fixing of door & window & jall door, Window Chapter 10 524 new item

S/F of Rolling shutter of approved make made (SI NO. 520)

P/F of 27.50 cm.long wire spring grade - 2 (SI No. 521)

P/F of Ball Bearing for Rolling Shutter (SI No. 523)

P/F Top cover (SI No. 522)

Providing earthwork in embankment with carted earth up to 8 K.M. lead , laying in 15 cm thick compacted layers, breaking clods, dressing to required lines, curves , grade & section, watering and compaction to meet requirements. (SI No. 253a+261+231a)

Painting wood or MS work synthetic enamel paint with with one coat of priming and two coat of enamel paint approved paint (British antesol or equivalent) including supply of all materials, labour, Tools & plants etc. required for proper completion of the work. Paint to be used ISI Marked. For every coat after the first coat. (S.I.No. 15.04/644 +645)

Providing wall putty on New surface with approvel quality material of Berger/J.K./Birla or similar make 2 coats. (on exterior walls). S.I. No. 15.22/New item

Providing cement primer on old/ new surface

Finishing exterior wall with wather coat paint of approved make and quality on new work with two coat to give an even shade including supply of all materials, labour, Tools & plant etc. required for proper completion of the work. (S.I.No. 15.22/662 New Item)

Sanitary & Electric work