Public Works Department Tender

Seal Coat Providing and laying seal coat sealing the voids in a bituminious surface laid to the specified levels, grade and cross fall using Type A, or Type B or Type C or type D as per MoRD Techinical Specification Clause 510. A. By Manual Means Case IV Type D (Premix with fine sand). 1) Bitumen (60/70 Grade) VG-30

Flat Brick soling Providing and laying flat brick soling layer on prepared subgrade according to lines, grades and cross-section shown on the drawing, filling joints with Earth, free from clay with a Plasticity Index not exceeding 6, watering and rolling the same with three wheeled road roller 80-100 kN as per MoRD Technical Specification Clause 412.

Excavation for structures A.Without Dewatering Earthwork in excavation for structure as per drawing and MoRD technical specifications clause 305.1 including setting out , construction of shoring and bracing , removal of stumps and other deleterious materials and disposal upto a lead 50 m , dressing of sides and bottom and backfilling in trenches with excavated suitable materials. i) Ordinary soil upto 3 m depth

Filling in foundation trenches as per drawing and MoRD technical specification clause

Providing concrete for plain concrete (Using Jhamma brick aggregate) in open foundation complete including formwork as per drawing and MoRD technical specification clauses 802,803,900,1202 and 1203(including cemntering, shuttering, staging etc. but excluding reinforcement)

Plain/reinforced cement concrete in substructure complete including formwork as per drawings & MoRD technical specification Clauses 802, 804, 805, 806, 807, 900, 1202 & 1204. (including centering, shuttering, staging etc. but excluding reinforcement). R.C.C grade M-25.upto 5 m height

Supplying, fitting & placing TMT bar / cold twisted deformed steel bar reinforcement in sub structure complete as per drawings & MoRD technical specifications Clauses 1002 , 1005,1010 & 1202

80 mm thick factory made c.c. interlocking paver block of M-35 Grade Providing and laying factory made chamfered edge Cement Concrete paver blocks of required strength, thickness & size/ shape, made by table vibratory method to attain superior smooth finish using PU or equivalent moulds, laid in required grey colour& pattern over 50 mm thick compacted bed of sand, compactingand proper embedding/ laying of inter locking paver blocks intothe sand bedding layer through vibratory compaction by usingplate vibrator, filling the joints with fine sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand in footpath, parks, lawns, drive ways or light traffic parking etc. all complete as per specifications & approval/ direction of the Engineer -in-Charge: (a) 80 mm thick c.c. paver block of M-35 grade with approved colour, design and pattern.