Municipal Administration And Water Supply Department Tender

Supply, delivery, Erection and commissoning of 16mt GI octangle light pole with step arrangements for easy climbing/maintanance as per dimension-Top dia-70mm bottm dia 175mm, section-1 (section length-10000m) Thick 3mm Base plate 250mm x 250mm x 16mm with 4 nos of M24 dia bolt (4Nos) with safetylader PCD 250mm with suitable RCC works, with 32Amps 2 pole MCB with MCB DB Box and Door arrangement at the bottom of the pole and Round ring arm at the top of the pole suitable for fixing of flood light luminaries 8 nos of 150W LED flood luminaries complete set with cast aluminium housing and anodized reflector complete with IP65 protection glass with necessary wire connection complete set as standard specification. 1/20 CTS copper wiring from light pole to service box for power Automatic ON/OFF timer switch box with 24x7 hrs programmable digital timer clock, 40Amps 4 pole contractor with 220 volt coll, 64 Amps Miniature,circuit breaker,16 Amps neutral link fully wired with fibre glass wire 40 Amps double pole ISOLATOR Main switch, 63Amps fuse carrier, fully wired on a wooden board in a zinc coated box with lock and key arrangements and necessary clamps and anles with bolts and nuts etc., complete. 1x11 Nos (SOR-PWD 2022-23 New Item No.3 pgno.150)

Design and casting of suitable foundation with 1:2:4 mix RCC concrete with 30 cm projection above the ground level with 1 Metre width x 1 Metre Length and 2 Metre depth with necessary galvanized foundation bolts nuts and washers and dump plate enclosing the bolts for the High Mast considering the safe soil bearing capacity at site. and using with Ceramic tlles for the foundation including all charges

Feeder pillar box comprising 0.90 m x 0.45m x 1,20m floor AI frame with 63 A TPN main switch 1 no , 63 A fuse unit 3 nos. , 63 A power contactor with automatic timer arrangements and reversing starter for the 3 phase motor. High powered power tool complete with hand held control panel and motor with push button type remote control switch suitable for 3 phase 415 V 50 HZ for raising and lowering of the lantern carriage complete to operate all fittings mounted in the base to couple with winch.(MR)